scentify V2 Lux Diffuser User Manual

scentify V2 Lux Diffuser

경고

제품을 사용하기 전에 모든 지침을 읽으세요.

(DANGER]

• Use in environments between -10°C and 50°C only. Operation outside this ange may damage the product and cause satety hazards. For use below 2000m altitude only
• Use only the specified rated voltage. Otherwise, safety risks may occur.
• 배터리 팩이나 기기를 불이나 과도한 온도에 노출시키지 마십시오.

[경고]

• Use only the recommended vaporizing medium. Other substances may produce toxic gases or pose a fire risk.
• Use only in conjunction with the supplied power supply device.
• Use only the safe ultra-low voltage specified by the appliance to prevent malfunction.
• If the supply cord is damaged, replace it with a special cord o ssemblv available trom the manutacturer or service agent on . Rechargeable batteries may only be replaced by qualified personne drv batteries excepted’ Do not tamper with original operating devices or functions.
• RED Article 10 (2)
• This product can be used across EU member states RED Article 10 (10)
• 본체와 제품 사이의 RF 거리는 20cm입니다.
• Frequency Range: 2402-2480M Hz
• Max.RF Output Power: -1.92 dBm

FCC 성명

이 장치는 FCC 규정의 15부를 준수합니다. 작동은 다음 두 가지 조건에 따릅니다.

1. 이 장치는 유해한 간섭을 일으키지 않으며,
2. 이 장치는 원치 않는 작동을 일으킬 수 있는 간섭을 포함하여 수신되는 모든 간섭을 수용해야 합니다.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference hv one or more of the followine measures*

• Reorientor는 수신 안테나를 재배치합니다.
• 장비와 수신기 사이의 거리를 넓힙니다.
• 수신기가 연결된 것과 다른 회로의 콘센트에 장비를 연결하세요.
• 도움이 필요하면 딜러나 숙련된 라디오/TV 기술자에게 문의하세요.

FCC 주의:

Any changes or modifications not expressly approved by th arty responsible for compliance could void the user’s authority to operate the equipment. This transmitter must not be co-located or operating in conjunction with any other antenna ortransmitter. Not applicable

RF 노출

이 장치는 통제되지 않은 환경에 대해 규정된 FCC 방사선 노출 제한을 준수합니다. 이 장비는 라디에이터와 사용자의 신체 사이에 최소 20cm의 거리를 두고 설치하고 작동해야 합니다.

ISED 성명

이 장치에는 혁신, 과학 및 경제 개발 캐나다의 면허 면제 RSS를 준수하는 면허 면제 송신기/수신기가 포함되어 있습니다. 작동은 다음 두 가지 조건에 따릅니다.

1. 이 장치는 간섭을 일으켜서는 안 됩니다.
2. 이 장치는 원하지 않는 장치 작동을 유발할 수 있는 간섭을 포함하여 모든 간섭을 수용해야 합니다. 디지털 장치는 Canadian CAN ICES – 3(B)/NMB – 3(B)를 준수합니다.

기술 사양

• Product Name Lux Diffuser V2
• Model Scentify Lux
• Diffuser V2
• Dimensions 10 × 8 × 4in
• Oil capacity 200ml
• 권tag전자 6.3W
• Power Consumption 100ml

중요한

Do not pour oil directly into the device Keep upright at all times Tilting may cause damage

시작하기

버튼 컨트롤

힘
3초간 길게 눌러 디퓨저를 켜거나 끕니다.

강도 조정

• Press+ to increase intensity.
• Press_ to decrease intensity

주변 조명
Short press the power button to cycle through light colors.

공장 초기화
Press and hold + and -buttons simultaneously to restore factory settings.

강도 수준

CONNECTING YOUR DIFFUSER – BLUETOOTH

1. Open the Scentify App
   • Tap Bluetooth Connection
   • See Connection Tips below if your diffuser does not appear
2. Select Your Diffuser
   • Choose your diffuser from the device list
3. 비밀번호를 입력하세요
   • Enter the default password: 8888 Tap Login
4. Change password (optional)
   • Tap the About tab
   • Tap Change Password
5. Edit Device Name (optional)
   • Tap the device name or label to edit it
   • 저장을 탭하세요연결 팁
     • 휴대전화에서 블루투스가 활성화되어 있는지 확인
     • Allow Bluetooth permissions when prompted
     • Stay close to the diffuser during setup
     • If permissions were denied, enable Bluetooth access in your phone settings
     • Make sure the diffuser is powered on before connecting
6. Change Light color
   • Tap the color icons to change the color of the diffuser logo light.
7. 밝기 조절
   • Tap Brightness to adjust the logo light brightness (Off, Low, or High).
8. 교정하다
   • When the bottle is empty, tap Calibrate to reset the oil level to 0% Refill the bottle with oil (up to 200ml)
   • The diffuser will automatically synchronize and track the remaining oil level based on the amount added
9. 켜기/끄기 버튼
   • Tap to turn the diffuser on or off
10. 일정을 선택하세요
    • Tap a schedule to edit settings
    • Tap + to add a new schedule Swipe left to delete a schedule
11. Set Operating Hours
    • Select the start and end time for your schedule
12. Select Repeat Days
    • Choose the days you want the diffuser to run
    • All days are selected by default
13. 강도 조정
    • Use – or+ to adjust intensity levels
14. Create Custom Intensity
    • Set custom spray and pause durations
15. 설정 저장
    • Tap Save to apply your schedule and settings

CONNECTING TO APP – WIFI

1. Open the Scentify App
   • Tap WiFi Connection
   • Make sure your phone is connected to a 2.4GHz WiFi network
2. Login or Create an Account
   • Login to your existing account Or create a new account
3. Add Your Diffuser
   • 기기 추가를 탭합니다.
   • Select your diffuser from the device list
   • 추가를 탭하세요
4. WiFi 네트워크 선택
   • Choose your WiFi network Enter your WiFi password
   • Make sure your phone is connected to the same network
   • NOTE: Only 2.4GHz WiFi networks are supported.
5. 완전한 설정
   • Wait while the app connects the diffuser to the cloud and initializes the device. Keep your smartphone and diffuser close to the router during setup. When setup is complete, enter a custom name for the diffuser if desired. Tap Confirm to finish.
6. 장치 설정 구성
   • Tap your diffuser to access Device Control For scheduling, intensity settings, calibration, and other app functions, see the Bluetooth Setup & App Settings page

연결 팁

• Make sure Bluetooth and WiFi are enabled on your phone
• Use a 2.4GHz WiFi network during setup
• Make sure your phone is connected to the same WiFi network you are connecting the diffuser to
• Allow Bluetooth and Location permissions when prompted
• Stay close to the diffuser during setup
• If permissions were denied, enable Bluetooth and Location access in your phone settings
• Make sure the diffuser is powered on before connecting

문제 해결

청소

1. Remove the oil bottle from the diffuser.
2. Empty any remaining fragrance oil from the bottle.
3. Fill the bottle with isopropyl alcohol (rubbing alcohol). For a deeper cleaning, warm water and white vinegar may also be used.
4. Remove the bottle and empty any remaining liquid
5. Run the diffuser at the highest intensity setting for approximately 15 minutes to flush the internal system.
6. Remove the bottle and empty any remaining cleaning solution.
7. Allow all parts to fully dry before refilling with fragrance oil.

유지 관리 및 보관

• Power off the diffuser when the bottle is empty.
• Remove the oil bottle before transporting or storing the diffuser.
• Store the diffuser upright in a cool, dry location at normal room temperature. Clean the diffuser periodically to maintain optimal performance.
• Inspect the bottle, tubing, and seals periodically for wear or damage.

RESET THE DIFFUSER

Press and hold the + and – buttons simultaneously for approximately 5 seconds to restore factory settings.

Need Additional Help? Contact support at info@scentify.com