AUTOONE JWA2 8000A Jump Box/Air Pump & JS02 6000A Jump Starter User Manual

1. 서론

This manual provides detailed instructions for the safe and effective operation of your AUTOONE JWA2 8000A Jump Box/Air Pump and JS02 6000A Jump Starter. This versatile device combines a powerful jump starter with an integrated air compressor, a portable power bank, and an LED flashlight, designed for automotive emergencies and outdoor use. Please read this manual thoroughly before use and retain it for future reference.

The AUTOONE JWA2/JS02 unit combines an 8000A jump starter and a 150PSI air compressor for comprehensive vehicle emergency support.

2. 안전 정보

Always observe the following safety precautions to prevent injury or damage to the device and property:

• 장치를 작동하기 전에 모든 지침을 읽으십시오.
• Wear eye protection and protective clothing when jump starting a vehicle.
• Do not short circuit the jump starter clamps.
• 기기를 어린이의 손이 닿지 않는 곳에 보관하세요.
• 장치를 비나 습기에 노출시키지 마십시오.
• Do not disassemble the device. Refer servicing to qualified personnel.
• 환기가 잘 되는 곳에서 장치를 사용하십시오.
• Ensure proper polarity when connecting to a vehicle battery: red clamp 양극(+), 검은색 clamp to negative (-) or chassis ground.
• Do not overinflate tires. Always check the recommended tire pressure for your vehicle.
• Allow the air compressor to cool down after extended use to prevent overheating.

3. 제품 오버view

The AUTOONE JWA2/JS02 is equipped with multiple features to assist in various situations:

• Robust Jump-Starting Power: Up to 8000A peak current (JWA2) or 6000A (JS02) for 12V vehicles with all gas and up to 12L diesel engines.
• Built-in Force Start Intelligence: 배터리 용량을 자동으로 감지합니다.tage and health, activating high-current output for weak or dead batteries.
• High-Performance Air Compressor: Inflates tires at 45 liters per minute, with a maximum pressure of 150PSI.
• 24000mAh 파워뱅크: Provides 18W MAX input/output for charging electronic devices.
• 600 루멘 LED 손전등: Features high-beam, strobe, and SOS modes for illumination and emergencies.
• HD LCD 디스플레이: Shows real-time pressure, battery level, and inflation modes.
• 종합 보호: Includes short-circuit, overcurrent, overvoltage, and IP67 dust/water resistance.

The integrated HD LCD display provides real-time information on battery level, tire pressure, and selected inflation modes.

4. 설정

4.1 초기 충전

Before first use, fully charge the device. Connect the provided charging cable to the device's input port and a suitable power adapter (wall charger not included). The LCD display will indicate charging status. A full charge typically takes approximately 2.5 hours with an 18W fast charger.

The 24000mAh large-capacity unit can be fast-charged via its input port. Ensure the device is fully charged before use.

5. 사용 설명서

5.1 차량 점프 스타트

1. Ensure the jump starter is sufficiently charged.
2. 연결하다 빨간색 clamp 차량의 양수(+) 배터리 터미널.
3. 연결하다 검은색 clamp 차량의 음수 (-) battery terminal or a solid metal part of the engine block (chassis ground).
4. The device's "Built-in Force Start Intelligence" will automatically detect the battery status and initiate the jump-starting process.
5. 차량을 시동하세요.
6. 차량이 시동되면 분리하십시오. 검은색 clamp 먼저 빨간색 clamp.
7. Remove the jump starter from the vehicle battery.

점프 스타터 클립을 올바르게 연결하십시오.amps to the vehicle battery terminals is crucial for safe operation. This unit supports 12V vehicles with all gas and up to 12L diesel engines.

5.2 공기 압축기 사용 방법

1. 공기 호스를 타이어 밸브 스템에 연결합니다.
2. 장치의 전원을 켭니다.
3. Use the control buttons to select the desired inflation mode (car, motorcycle, bicycle, ball) and set the target pressure (PSI, BAR, KPA, Kg/cm²).
4. Press the start button to begin inflation. The compressor will automatically stop when the target pressure is reached.
5. 공기 호스를 분리합니다.

The integrated air compressor can inflate a pickup truck tire from 30PSI to 36PSI in approximately 2.5 minutes.

A single full charge can inflate up to 25 sedan tires (245/75 R17), 18 SUV tires (275/65 R18), or 6 pickup truck tires (315/70 R17).

5.3 파워뱅크로 사용하기

1. Connect your electronic device to the USB output port(s) using a compatible charging cable.
2. 기기가 자동으로 충전을 시작합니다.

The unit features 18W MAX input and 18W MAX output, allowing it to charge various electronic devices.

5.4 LED 손전등 사용법

Press the flashlight button to cycle through the available modes: High-beam, Strobe, SOS, and Off. The 600 Lumen LED flashlight provides illumination for roadside emergencies and other low-light situations.

6. 유지관리

• 충전 중: Recharge the device every 3-6 months, even if not used, to maintain battery health and prolong its lifespan.
• 저장: Store the device in a cool, dry place, away from direct sunlight, high temperatures, and excessive moisture.
• 청소: 기기를 마른 부드러운 천으로 닦으십시오. 독한 화학 약품이나 연마성 세척제를 사용하지 마십시오.

7. 문제 해결

If you encounter issues with your AUTOONE jump starter, refer to the following common problems and solutions:

• 장치가 켜지지 않음: Check the battery level on the LCD display. Recharge the device if the battery is low.
• 차량 시동이 걸리지 않음:
  • 점프 스타터가 제대로 작동하는지 확인하세요.amps are correctly connected to the vehicle battery terminals (red to positive, black to negative/chassis ground).
  • 차량 배터리 단자가 깨끗하고 부식이 없는지 확인하십시오.
  • If the vehicle battery is severely discharged, allow the "Force Start" function to operate for a few moments before attempting to start the vehicle.
• 공기압축기가 작동하지 않습니다:
  • Check that the air hose is securely connected to the tire valve stem.
  • Ensure the target pressure is set correctly and is higher than the current tire pressure.
• 기기가 외부 장치를 충전하지 않습니다. Ensure the charging cables are properly connected to both the jump starter and the external device. Verify that the jump starter has sufficient charge.

8. 사양

9. 보증 및 지원

For warranty information or technical support, please contact AUTOONE customer service through the retailer where the product was purchased or visit the official AUTOONE website. Please have your model number (JWA2 or JS02) and purchase details available when contacting support.