소개
This manual provides essential information for the safe and effective operation, setup, and maintenance of your BlackZon Slyder ST Turbo 1/16 4WD Electric Stadium Truck. Please read this manual thoroughly before operating the vehicle to ensure proper function and to prevent damage or injury.

Figure 1: BlackZon Slyder ST Turbo 1/16 4WD 2S Monster Truck, top-side view, 보여 주다asing its green body and aggressive tires.
The BlackZon Slyder ST Turbo is a high-performance remote-controlled vehicle designed for off-road racing and bashing. Its durable polycarbonate body and four-wheel drive system are engineered to handle rough terrain. This 1/16th scale truck is compact and agile, featuring a powerful electric motor for quick acceleration and speed, complemented by an adjustable suspension system for a smooth ride over various obstacles.
안전 정보
- 차량은 항상 사람, 애완동물 및 장애물이 없는 탁 트인 공간에서 운행하십시오.
- Do not operate near public roads, water, or in crowded environments.
- 손, 머리카락, 헐렁한 옷 등을 움직이는 부품에 가까이 두지 마십시오.
- 배터리는 사용 전에 완전히 충전해야 하며, 사용하지 않을 때는 분리해 두십시오.
- 충전 중인 배터리를 절대로 방치하지 마십시오.
- Use only the provided charger and battery type.
- 14세 미만 사용자의 경우 성인의 감독을 받는 것이 좋습니다.
- 전자 장비 손상을 방지하기 위해 습기가 많은 환경에서의 작동을 피하십시오.
패키지 내용
상자에 포함된 것:
- BlackZon Slyder ST Turbo 1/16 4WD Electric Stadium Truck
- 2.4GHz 무선 송신기
- 2S 7.4V 1000mAh LiPo Battery with T-Plug connector
- USB 충전기
- Front LED Lights (requires installation)
- Wheelie Bar (requires installation)
작동에 필요한 구성품 (포함되지 않음):
- 송신기용 4 x AA 배터리
설정
1. 리튬 폴리머 배터리 충전
- Connect the 2S 7.4V 1000mAh LiPo battery to the included USB charger.
- USB 충전기를 호환되는 USB 전원(예: 컴퓨터 USB 포트, USB 벽면 어댑터)에 꽂으세요.
- Monitor the charging process. The indicator light on the charger will typically show red during charging and turn green when fully charged.
- Once fully charged, disconnect the battery from the charger. Never overcharge LiPo batteries.
2. 송신기 배터리 설치
- Open the battery compartment on the bottom of the 2.4GHz radio transmitter.
- AA 배터리 4개를 올바른 극성(+/-)에 맞춰 넣으세요.
- 배터리 칸을 단단히 닫으세요.
3. Installing Optional Accessories (LED Lights & Wheelie Bar)
The front LED lights and wheelie bar are included in the box and can be installed if desired. Refer to the diagrams in the separate assembly guide (if provided) for specific installation steps. Generally, the LED lights connect to a designated port on the ESC/receiver unit, and the wheelie bar attaches to the rear chassis.

그림 2: 밑면 view of the BlackZon Slyder ST Turbo chassis, revealing the motor, battery compartment, and suspension components.
작동 지침
1. 전원 켜기
- Ensure the vehicle's battery is securely connected and placed in its compartment.
- 먼저 송신기를 켜십시오. 전원 표시등이 켜져야 합니다.
- Next, turn on the power switch on the vehicle. The vehicle's electronics will initialize, and you may hear a series of beeps.
- If the vehicle and transmitter do not link automatically, refer to the binding procedure in the troubleshooting section or a separate binding guide.
2. 기본 제어
- 스로틀 트리거: Pull the trigger to accelerate forward. Push the trigger forward to brake, then push again for reverse.
- 스티어링 휠 : 핸들을 좌우로 돌려 차량을 조종하세요.
- Speed Limiter Dial: Located on the transmitter, this dial allows you to adjust the maximum speed of the vehicle. Turn clockwise for higher speed, counter-clockwise for lower speed. This is useful for beginners or when operating in smaller spaces.
- Steering D/R (Dual Rate): Adjusts the maximum steering angle. Useful for fine-tuning steering response.
3. 운전 요령
- Start with the speed limiter set to a lower setting until you are comfortable with the controls.
- 탁 트인 공간에서 핸들 조작과 가속 페달 조작 연습을 하세요.
- Avoid sudden, sharp turns at high speeds to prevent rollovers.
- Be mindful of battery life. When the vehicle starts to slow down significantly, it's time to recharge.
4. 전원 끄기
- Turn off the vehicle's power switch first.
- Then, turn off the transmitter.
- Disconnect the battery from the vehicle for storage.
유지
정기 점검:
- 각 실행 후: Inspect the vehicle for any loose screws, damaged parts, or debris. Clean off dirt and dust.
- 바퀴와 타이어: Check for wear, tears, or punctures. Ensure wheel nuts are tight.
- 보류: Verify that shocks are functioning smoothly and that suspension arms are not bent or broken.
- 구동계: Inspect the spur gear for damage and ensure it's free of debris. Check metal rear drive shafts for bends or wear.
- 전자제품: Ensure all wires are securely connected and free from damage. Keep electronics dry.
배터리 관리 :
- 리튬 폴리머 배터리는 직사광선과 극한 온도 변화를 피해 서늘하고 건조한 곳에 보관하십시오.
- Do not store fully charged or fully discharged LiPo batteries for extended periods. Charge them to a storage voltage (typically around 3.8V per cell) if storing for more than a few days.
- Never puncture or damage LiPo batteries. Dispose of damaged batteries safely according to local regulations.
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 차량이 송신기에 응답하지 않습니다. |
|
|
| Vehicle runs slowly or stops suddenly. |
|
|
| 조종이 불안정하거나 반응이 없습니다. |
|
|
명세서
- 규모: 1/16번째
- 운전하다: 4WD - Shaft Driven
- 모터: 3800KV 무브러시 모터
- ESC/수신기: 2-in-1 Brushless ESC/Receiver (2S LiPo Max Capable)
- 배터리: 2S 7.4V 1000mAh LiPo w/ T-Plug connector
- 라디오 시스템: 2.4GHz
- 보류: Independent Double Wishbone, Adjustable Coilover Shocks
- 차이점: 4-Gear (Front & Rear)
- 조종: Dual Point Bell Crank System with Built-in Servo Saver
- Chassis Features: Covered Spur Gear, Metal Rear Drive Shafts, Ball Bearings throughout
- 전자제품: Splashproof
- 길이: 270의 mm (10.62 인치)
- 너비: 215의 mm (8.4 인치)
- 키: 130의 mm (5.11 인치)
- 휠베이스: 175mm (XNUMXmm)
- 무게: 약 1파운드
보증 및 지원
BlackZon products are manufactured to high standards. For warranty information, technical support, or replacement parts, please contact BlackZon customer service through their official web해당 웹사이트 또는 판매점에서 구매하세요. 보증 청구를 위해 구매 증빙 자료를 보관하십시오.