1. 중요한 안전 정보
Please read this entire manual carefully before installing, operating, or servicing this gas heater. Failure to follow these instructions could result in fire, explosion, property damage, personal injury, or death.
- 통풍: Always ensure adequate ventilation when operating the heater. Do not use in unventilated areas.
- 연료: Use only butane or propane gas as specified. Ensure the gas cylinder is correctly connected and free from leaks.
- 놓기: Place the heater on a firm, level surface, away from flammable materials (curtains, furniture, paper, etc.). Maintain a safe distance from walls and other objects.
- 어린이와 애완동물: Keep children and pets away from the heater. Never leave the heater unattended when in operation.
- 움직이는: 히터가 작동 중이거나 아직 뜨거울 때는 이동시키지 마십시오.
- 수정 사항: Do not modify the heater in any way. Any unauthorized modifications will void the warranty and may create a safety hazard.
- 저장: Store gas cylinders in a well-ventilated area, away from heat sources and direct sunlight.
- 일산화탄소: 가스 히터는 일산화탄소를 발생시킵니다. 일산화탄소 중독을 예방하기 위해 적절한 환기를 확보하십시오. 일산화탄소 감지기 설치를 고려해 보십시오.
2. 제품 오버view
The Orbegozo HBF 120 is a portable gas heater designed for indoor use, providing efficient warmth with adjustable flame and thermostat settings. It operates on butane or propane gas and features a sleek white finish.
그림 2.1: 전면 view of the Orbegozo HBF 120 Gas Heater. This image shows the heater's white exterior and the flame effect window at the base, indicating its operational state.
그림 2.2: 측면 view of the Orbegozo HBF 120 Gas Heater. This image highlights the ventilation grilles on the side and a recessed handle on the top for portability.
3. 설정
- 짐 풀기: Carefully remove the heater from its packaging. Retain packaging for future storage or transport. Inspect the heater for any signs of damage. Do not use if damaged.
- 놓기: Position the heater on a stable, non-combustible, and level surface. Ensure there is at least 1 meter (3 feet) clearance from any combustible materials (furniture, curtains, walls, etc.) on all sides. Ensure adequate ventilation in the room.
- 가스 실린더 연결:
- 가스통 밸브가 닫혀 있는지 확인하세요.
- Connect the gas regulator to the gas cylinder valve according to the regulator's instructions.
- Connect the gas hose from the regulator to the heater's gas inlet. Ensure all connections are tight.
- 누출 테스트:
- 가스 실린더 밸브를 천천히 엽니다.
- Apply a soapy water solution to all gas connections. If bubbles appear, there is a leak. Close the gas valve immediately and tighten the connections. Repeat the test. If leaks persist, do not use the heater and contact qualified service personnel.
- Battery Installation (for ignition, if applicable): If your model requires batteries for the igniter, install 1 AA battery as indicated in the battery compartment.
4. 사용 설명서
- 히터 시작하기:
- 가스 실린더 밸브가 완전히 열려 있는지 확인하십시오.
- Turn the control knob to the desired heat setting (e.g., Low, Medium, High).
- Press and hold the control knob inward while simultaneously pressing the igniter button repeatedly until the pilot flame ignites.
- Continue to hold the control knob for 10-20 seconds after ignition to allow the thermocouple to heat up. Release the knob. The main burner should now ignite.
- If the burner does not ignite, repeat the process. If it fails after several attempts, refer to the Troubleshooting section.
- 열 조절: Rotate the control knob to select the desired heat output. The Orbegozo HBF 120 features adjustable flame and thermostat settings for optimal comfort.
- 히터 끄기:
- 조절 손잡이를 "OFF" 위치로 돌리십시오.
- 가스 실린더 밸브를 닫습니다.
- 히터를 옮기거나 보관하기 전에 완전히 식히십시오.
5. 유지관리
Regular maintenance ensures the safe and efficient operation of your heater.
- 청소:
- Ensure the heater is off and completely cool before cleaning.
- 부드러운 d로 외부 표면을 닦으십시오.amp 천. 연마성 세척제나 용매를 사용하지 마십시오.
- Keep the ventilation openings clear of dust and debris. Use a soft brush or vacuum cleaner to gently remove any blockages.
- 가스 호스 및 레귤레이터: Periodically inspect the gas hose and regulator for cracks, cuts, or damage. Replace them immediately if any damage is found. Check the expiration date on the gas hose and replace it as recommended by the manufacturer.
- 저장: When not in use for extended periods, disconnect the gas cylinder and store the heater in a dry, dust-free location.
6. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 히터가 점화되지 않습니다. | 가스 실린더가 비어 있거나 밸브가 닫혀 있습니다. 점화기가 스파크를 일으키지 않습니다. Thermocouple not heating sufficiently. | Check gas level and ensure valve is open. Check battery for igniter. Hold control knob longer after pilot ignition. |
| 불꽃이 약하거나 불규칙적입니다. | 가스압력이 낮습니다. 버너가 부분적으로 막혔습니다. | 가스통의 가스 잔량을 확인하십시오. Ensure gas hose is not kinked. Contact service for burner inspection. |
| 가스 냄새. | 가스 누출. 불완전 연소. | Immediately turn off heater and gas supply. Ventilate area. Perform leak test. If smell persists, evacuate and contact emergency services. |
| 히터가 예기치 않게 꺼집니다. | Oxygen Depletion Sensor (ODS) activated due to insufficient ventilation. Thermocouple issue. | Increase ventilation. Ensure no obstructions. If problem persists, contact service. |
For problems not listed here or if solutions do not resolve the issue, contact qualified service personnel or the manufacturer.
7. 사양
| 특징 | 세부 사항 |
|---|---|
| 상표 | 오르베고조 |
| 모델 번호 | HBF120 |
| 전력 출력 | 3800W (3.8kW) |
| 연료 유형 | Butane / Propane Gas |
| 색상 | 하얀색 |
| 재료 | 탄소강 |
| 치수(길이 x 너비 x 높이) | 40 x 30 x 50cm |
| 품목 무게 | 9 킬로그램 |
| 특별 기능 | Adjustable flame, Adjustable thermostat, Flame effect |
| 전원 | 가스 동력 |
| 설치 유형 | 독립형 |
| 배터리 요구 사항 | 1 AA (for ignition, if applicable) |
8. 보증 및 지원
Warranty information for the Orbegozo HBF 120 Gas Heater is typically provided with your purchase documentation. Please refer to the warranty card or contact your retailer for specific details regarding coverage and duration.
For technical support, spare parts, or service inquiries, please contact Orbegozo customer service or your authorized dealer. Contact details can usually be found on the manufacturer's official web사이트 또는 제품 포장에 포함되어 있습니다.
