1. 서론
This manual provides instructions for the setup, operation, and maintenance of your Allotech HOR 40 remote control. This portable transmitter features 4 channels (4 buttons) and is designed for ease of use and compact portability. It is compatible with various Hormann and Tubauto gate and garage door systems operating at 40.685 MHz.
The Allotech HOR 40 remote control is designed to be programmed in the same manner as the original transmitter, with a quick and straightforward process.
Image 1: Allotech HOR 40 Remote Control, front view, showing four grey buttons arranged in a cross pattern and a small LED indicator.
2. 안전 정보
- 리모컨을 어린이의 손이 닿지 않는 곳에 보관하세요.
- 기기를 극한의 온도, 직사광선 또는 습기에 노출시키지 마세요.
- Do not attempt to disassemble or repair the remote control yourself. Refer to qualified personnel.
- Ensure the gate or garage door area is clear before operating to prevent injury or damage.
- The programming process should ideally be performed by two people for safety and convenience, especially when dealing with the receiver unit.
3. 패키지 내용
The Allotech HOR 40 package includes:
- 1 x Allotech HOR 40 Remote Control
- 1 x 12V 배터리(사전 설치됨)
- 1 x 사용 설명서(이 문서)
4. 호환성
This remote control is compatible with Hormann and Tubauto automatic systems operating at a frequency of 40.685 MHz. It replaces the following handheld transmitters:
- Hormann HSE2
- Hormann HSM4
- Hormann HSM2
- Hormann HSE4
- Hormann HS2
- Hormann HS4
- Tubauto HS2
- Tubauto HS4
- Tubauto HSM2
- Tubauto HSM4
중요한: This remote is only compatible with Hormann systems using a 40.685 MHz frequency and grey buttons. It is NOT compatible with other frequencies or button colors (e.g., green, orange, yellow, blue, black).
Image 2: Compatibility chart showing the Allotech HOR 40 remote control alongside various Hormann remotes. It highlights compatibility with 40.685 MHz grey button remotes and explicitly shows non-compatible remotes with different frequencies and button colors (green, orange, yellow, blue, black).
5. 설정 및 프로그래밍
The Allotech HOR 40 remote control can be programmed in two ways: by copying from an existing Hormann remote or by programming directly to your radio receiver.
5.1. If you have an original Hormann remote
You can copy the code from your HORMANN remote control (grey button) to your new remote by following these steps:
- Step 1: Take your original remote.
First, press and hold a key on your original remote. Then hold your original HORMANN remote control and your new model remote control in your hand. Bring them together as shown in the diagram (Fig. A) below by placing them head to head.
- Step 2: Use your new remote.
On your new remote control, press a button and allow it to be pressed. The light on your new remote should flash slowly for four seconds, then faster. This indicates a successful programming operation. Finally, release the buttons on your remote controls, then test your remote.
메모: 리모컨의 각 키를 프로그래밍하려면 필요한 만큼 작업을 반복하세요.
5.2. If you want to program your remote with your receiver
- Step 1 & 2: Locate your radio receiver.
Press the push button on your receiver. The LED on your receiver should light up and flash slowly. Take your new remote control and press a key for more than 5 seconds. The LED light on your receiver should flash faster. Finally, release the button on your remote control. The light on your receiver should flash for a few more seconds then go out.
Image 3: Diagram (Fig. A) illustrating the head-to-head programming method for the Allotech HOR 40 remote control, showing two remote controls held together for code transfer.
6. 사용 설명서
Once programmed, operate your gate or garage door by pressing the corresponding button on the Allotech HOR 40 remote control. The remote has four buttons, allowing you to control up to four different functions or devices, depending on how it was programmed.
- Press a programmed button once to activate the associated function (e.g., open/close gate, open/close garage door).
- Ensure you are within the operating range (up to 10 meters) of the receiver for reliable operation.
- Observe the gate/door movement to ensure safe and proper operation.
Image 4: The Allotech HOR 40 remote control superimposed on a background of a house with a garage door, illustrating its intended use.
7. 유지관리
7.1. 청소
리모컨은 부드럽고 마른 천으로 닦으십시오. 연마성 세제나 용제를 사용하지 마십시오. 리모컨이 손상될 수 있습니다.asing.
7.2. 배터리 교체
The remote control uses a 12V battery. If the operating range decreases significantly or the LED indicator does not light up when a button is pressed, the battery may need replacement. To replace the battery:
- 리모컨을 조심스럽게 열어보세요asing.
- 오래된 12V 배터리를 제거하세요.
- 올바른 극성을 확인하여 새로운 12V 배터리를 삽입합니다.
- C를 닫으세요asing 안전하게.
오래된 배터리는 해당 지역 규정에 따라 폐기하세요.
8. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 원격 제어가 작동하지 않습니다. | 배터리가 부족하거나 소진되었습니다. | 12V 배터리를 교체하십시오. |
| 원격 제어가 작동하지 않습니다. | 올바르게 프로그래밍되지 않았습니다. | Repeat the programming steps (Section 5). Ensure correct frequency and compatibility. |
| 작동 범위가 감소했습니다. | Low battery. Interference. Obstructions. | Replace battery. Ensure clear line of sight to receiver. Check for sources of radio interference. |
| 리모컨의 LED 표시등이 켜지지 않습니다. | Dead battery. Faulty remote. | 배터리를 교체하십시오. 문제가 지속되면 고객 지원팀에 문의하십시오. |
9. 사양
| 상표 | 알로텍 |
| 모델명 | HOR 40 |
| 색상 | 회색 |
| 연결 기술 | 무선 주파수 (RF) |
| 빈도 | 40.685MHz |
| Number of Channels/Buttons | 4 |
| 호환 장치 | Hormann automatic systems (40.685 MHz, grey buttons) |
| 특징 | 가지고 다닐 수 있는 |
| 배터리 유형 | 1 x 12V 알카라인(포함) |
| 최대 범위 | 10 Meters (approx.) |
| 크기(대략) | 55mm(높이) x 44mm(폭) x 12mm(깊이) |
| 무게(대략) | 35g |
Image 5: Diagram showing the approximate dimensions of the Allotech HOR 40 remote control: 55 mm height, 44 mm width, and 12 mm depth.
10. 보증 정보
Warranty information is not explicitly provided in the product details. Please refer to your point of purchase or the manufacturer's official web보증 조건에 대한 자세한 내용은 해당 사이트를 참조하십시오.
적합성 선언: Allotech declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A declaration of conformity is available at the address www.allotelecommande.com.
11. 지원
For technical assistance or further inquiries, please contact your retailer or visit the manufacturer's web대지.
제조업체/유통업체:
알로텍
1 RUE DU GABIAN, LE THALES - BLOC B
(8EME ETAGE)
98000 모나코(MC)
Failure to follow these instructions excludes Allotech's liability and its warranty. Allotech cannot be held responsible for changes occurring after the publication of this notice.
