1. 서론
This manual provides essential instructions for the safe and efficient operation, setup, and maintenance of your Sovelor MG330 Portable Propane Gas Forced Air Heater. Please read this manual thoroughly before operating the device and retain it for future reference. The Sovelor MG330 is designed to provide powerful, temporary heating for well-ventilated areas.
2. 안전 지침
Your safety and the safety of others are paramount. Always follow these basic safety precautions to reduce the risk of fire, electric shock, and personal injury.
- 통풍: Operate this heater only in well-ventilated areas. Ensure adequate fresh air supply to prevent oxygen depletion and carbon monoxide buildup.
- 연료: Use only propane gas. Ensure the propane tank is upright, stable, and located at a safe distance from the heater. Check all gas connections for leaks using a soapy water solution before each use.
- 전기 연결: Connect the heater to a properly grounded 230V electrical outlet. Do not use extension cords unless absolutely necessary, and if so, ensure they are rated for the heater's power requirements and are in good condition.
- 정리: Maintain a minimum clearance of 1 meter (3 feet) from combustible materials (e.g., paper, wood, fabric) on all sides of the heater.
- 감독: 히터가 작동하는 동안에는 절대로 자리를 비우지 마십시오.
- 어린이와 애완동물: 히터에서 어린이와 애완동물을 멀리하세요.
- 인화성 물질: 이 히터 주변에 휘발유 또는 기타 인화성 증기 및 액체를 보관하거나 사용하지 마십시오.
- 유지: Do not attempt to repair or modify the heater. Refer all servicing to qualified personnel.
3. 설정
Follow these steps to set up your Sovelor MG330 heater:
- 짐 풀기: Carefully remove the heater and all components from the packaging. Inspect for any shipping damage.
- 놓기: Position the heater on a stable, level, non-combustible surface in a well-ventilated area. Ensure adequate clearance from walls and combustible materials.
- 프로판 연결:
- Connect the regulator and hose assembly to the propane tank valve. Tighten securely.
- Connect the other end of the hose to the gas inlet on the heater.
- Open the propane tank valve slowly and check all gas connections for leaks using a soapy water solution. Bubbles indicate a leak. If a leak is detected, close the tank valve immediately and tighten connections or replace faulty parts.
- 전기 연결: Plug the heater's power cord into a grounded 230V, 50Hz electrical outlet.
4. 사용 설명서
To operate your Sovelor MG330 heater, follow these steps:
- 사전 작업 확인: Ensure all safety instructions and setup procedures have been followed. Verify that the propane tank has sufficient fuel and all connections are secure and leak-free.
- 전원 켜기: Turn the main power switch on the heater to the "ON" position. The fan should start operating.
- 가스 공급: Slowly open the valve on the propane tank completely.
- Ignition (Manual): Press and hold the gas valve button on the heater. While holding, press the igniter button repeatedly until the burner ignites. Continue to hold the gas valve button for approximately 10-15 seconds after ignition to allow the thermocouple to heat up and hold the flame.
- Flame Check: Visually confirm that the burner is lit and producing a stable flame.
- 열 출력 조절: If your model has a variable heat setting, adjust the control knob to the desired heat output (e.g., 18kW or 33kW for MG330).
종료 절차:
- Close the valve on the propane tank completely.
- Allow the heater to run until all residual gas in the hose is consumed and the flame extinguishes. This may take a few minutes.
- Turn the main power switch on the heater to the "OFF" position.
- 전기 콘센트에서 전원 코드를 뽑으세요.
5. 유지관리
정기적인 유지관리는 히터의 수명과 안전한 작동을 보장합니다.
- 청소: Keep the heater clean and free from dust and debris. Use a soft, dry cloth for cleaning. Do not use abrasive cleaners or solvents. Ensure the fan blades are clear of obstructions.
- 가스 호스 및 레귤레이터: Periodically inspect the gas hose and regulator for cracks, cuts, or damage. Replace immediately if any damage is found.
- 전기 코드 : 전원 코드에 손상이나 닳은 흔적이 있는지 확인하세요.
- 저장: When not in use, store the heater in a dry, clean place, away from direct sunlight and extreme temperatures. Disconnect the propane tank and store it separately according to local regulations.
- 연례 검사: It is recommended to have the heater inspected annually by a qualified service technician.
6. 문제 해결
If you encounter issues with your Sovelor MG330 heater, refer to the following common problems and solutions:
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 히터가 점화되지 않습니다. | No propane supply, faulty igniter, gas valve not held long enough, low gas pressure. | Check propane tank level and valve. Ensure igniter sparks. Hold gas valve button for 10-15 seconds after ignition. Check regulator. |
| Flame goes out after ignition. | Thermocouple not heated sufficiently, faulty thermocouple, low gas pressure. | Hold gas valve button longer. Ensure thermocouple is clean and positioned correctly. Check gas supply. |
| 팬이 작동하지 않습니다. | No electrical power, faulty motor, obstructed fan. | Check power cord and outlet. Ensure power switch is ON. Clear any obstructions from the fan. |
| 가스 냄새. | 가스 누출. | Immediately shut off propane supply. Ventilate area. Check all connections with soapy water. Do not operate until leak is resolved. |
이러한 해결 방법을 시도한 후에도 문제가 지속되면 자격을 갖춘 서비스 담당자에게 문의하세요.
7. 사양
The following table details the technical specifications for the Sovelor MG330 model:
| 특성 | 단위 | MG330 Value |
|---|---|---|
| 본체 소재 | - | 스테인리스 스틸(이녹스) |
| Heat Output (min / max) | kW | 18 / 33 |
| Heat Output (min / max) | Kcal/H | 15480 / 28380 |
| 공기 흐름 | M³ / H | 1000 |
| 전기 공급 | V/Hz | 230 V~1 50 |
| 전기 전력 | W | 60 |
| Gas Consumption (min / max) | Kg/H | 1.2 / 2.4 |
| 보호 지수 | - | IPX4 |
| 치수(길이 x 너비 x 높이) | mm | 552 x 220 x 342 |
| 무게 | Kg | 7.5 |
Additional specifications from product data:
- 제조업체: Sovelor
- 모델 참조: MG330
- 필요한 배터리: 아니요
- ASIN: B07Z41BL41
- Amazon.fr에서 최초 구매 가능: 9년 2021월 XNUMX일
8. 보증 및 지원
Specific warranty information for the Sovelor MG330 is not available in the provided product data. For warranty details, please refer to the documentation included with your purchase or contact the retailer or manufacturer directly.
For technical support or service inquiries, please contact Sovelor customer service or the authorized dealer from whom you purchased the product. Always provide your model number (MG330) and purchase date when seeking support.
