소개
This instruction manual provides detailed guidance for the safe and proper installation, operation, and maintenance of your Rocketfish Tilting TV Wall Mount. This mount is designed to securely hold flat-panel TVs ranging from 32 to 90 inches, with a maximum weight capacity of 130 lbs. Please read this manual thoroughly before beginning installation.
중요한 안전 정보
경고: Failure to read and follow these instructions may result in serious personal injury, property damage, or voiding of your warranty. If you do not understand these instructions or have doubts about the safety of the installation, contact customer support or a qualified installer.
- Do not install this product if you cannot understand the installation instructions.
- 설치 표면이 마운트와 TV의 총 무게를 안전하게 지탱할 수 있는지 확인하십시오.
- Use only the provided hardware. Do not use the mount for any purpose not expressly specified by the manufacturer.
- 본 제품은 실내에서만 사용하도록 설계되었습니다.
- Always ensure the TV is securely attached to the mount before releasin지.
패키지 내용
Verify that all components are present and undamaged. If any parts are missing or damaged, do not attempt to install the mount. Contact Rocketfish customer service for assistance.
- 벽판 조립체
- TV 브래킷 (2)
- 장착 하드웨어 키트(다양한 나사, 와셔, 스페이서, 앵커)
- 사용 설명서(본 문서)
Image: Main components of the Rocketfish Tilting TV Wall Mount, including the wall plate and two TV brackets.
이미지: 분해된 모습 view of the Rocketfish Tilting TV Wall Mount, showing the wall plate and the two vertical TV mounting arms.
설정 및 설치
Proper installation is crucial for the safety and performance of your TV mount. It is highly recommended to have at least two people for installation.
필요한 도구 (포함되지 않음):
- 스터드 찾기
- 송곳
- 수준
- Phillips 헤드 스크루 드라이버
- 연필
- 줄자
단계별 설치:
- TV 준비: Lay your TV face down on a soft, clean surface. Attach the two TV brackets to the back of your TV using the appropriate screws and spacers from the hardware kit. Ensure the brackets are centered and securely fastened to the VESA mounting holes.
- 벽 스터드 찾기: Use a stud finder to locate the center of two adjacent wooden studs in your desired mounting location. Mark these locations with a pencil. For concrete or brick walls, use appropriate anchors (not always included, check hardware kit).
- 벽 플레이트 위치 지정: Hold the wall plate against the wall, aligning the mounting holes with the marked stud centers. Use a level to ensure the wall plate is perfectly horizontal. Mark the drill hole locations.
- 드릴 파일럿 홀: Drill pilot holes at the marked locations. The size of the drill bit will depend on the type of wall and the lag bolts being used. Refer to the hardware kit instructions for specific drill bit sizes.
- 벽면 플레이트 부착: Secure the wall plate to the wall using the lag bolts and washers. Tighten all bolts firmly, but do not overtighten.
- TV를 걸어 놓으세요: With assistance, carefully lift the TV and hook the TV brackets onto the top edge of the wall plate. Gently lower the TV until the brackets engage with the wall plate.
- TV를 보호하세요: TV 브래킷 하단에 있는 안전 나사 또는 잠금 장치를 찾으십시오. 이 나사를 조여 TV를 벽면 고정판에 단단히 고정하고 실수로 분리되는 것을 방지하십시오.
기울임 기능 작동하기
The Rocketfish Tilting TV Wall Mount allows for easy adjustment of your TV's vertical view잉 각도.
- To tilt the TV, gently push or pull the bottom edge of the TV to achieve the desired angle. The mount is designed for smooth, fingertip tilt action.
- The maximum tilt angle is approximately 10 degrees.
- Ensure all cables are clear and not pinched when adjusting the tilt.
유지
정기적인 유지 관리는 TV 거치대의 수명 연장과 안전한 작동을 보장합니다.
- 청소: 부드럽고 마른 천으로 마운트를 닦으세요. 연마성 세제나 용제를 사용하지 마세요.
- 정기 점검: 모든 나사와 볼트가 단단히 조여져 있는지 주기적으로 점검하십시오. 시간이 지남에 따라 진동이나 조정으로 인해 고정 장치가 헐거워질 수 있습니다.
- 중량 제한: Never exceed the maximum weight capacity of 130 lbs (58.9 kg).
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| TV가 수평이 아닙니다. | 설치 중 벽판이 수평이 아닙니다. | Remove TV, loosen wall plate bolts, adjust with a level, and re-tighten. |
| Difficulty plugging in cables after mounting. | Limited space between TV and wall. | It is recommended to connect all necessary cables to the TV before mounting. If already mounted, carefully tilt the TV to access ports or consider using right-angle adapters. |
| 산이 불안정하게 느껴집니다. | Loose fasteners or improper installation. | Immediately remove TV. Re-check all mounting points and fasteners for tightness. Ensure installation followed instructions for wall type. |
| TV does not tilt smoothly. | 기계가 뻣뻣하거나 막혔을 수도 있습니다. | Check for any obstructions behind the TV. Ensure the tilt mechanism is clean and free of debris. |
명세서
- 모델: RF-TVMLPT03
- 제품 크기: 1.9 x 28.5 x 17.5 인치
- 품목 무게: 6파운드
- 재료: 금속
- 장착 유형: 벽걸이형
- 이동 유형: 경사
- Minimum Compatible TV Size: 32 인치
- Maximum Compatible TV Size: 90 인치
- 최대 중량 용량: 최대 130kg(58.9파운드)
- 최대 기울기 각도: 10도
- 색상: 검은색
보증 및 지원
For warranty information or technical support, please refer to the official Rocketfish web해당 사이트를 방문하거나 고객 서비스 부서에 문의하세요. 보증 청구를 위해 구매 영수증을 보관하세요.
법적 고지사항: Up to 130 lbs. for sturdy support. (Product packaging may indicate compatibility with 32" - 56" flat-panel TVs.)
