소개
This manual provides comprehensive instructions for the safe and efficient use of your Paulmann MaxLED 79797 RGBW Controller. This device allows you to control Paulmann MaxLED RGBW light strips, enabling functions such as switching, dimming, and changing light colors and effects via the included wireless remote control. The controller operates without requiring direct line-of-sight to the remote, offering a range of up to 30 meters.
중요 안전 지침
- 설치 및 작동 전에 모든 지침을 주의 깊게 읽으십시오.
- 이 설명서를 향후 참고용으로 보관하세요.
- 본 제품은 실내용으로만 설계되었습니다(IP20 등급). 습기나 극한 온도에 노출시키지 마십시오.
- 설치 또는 유지 보수 작업을 하기 전에 반드시 전원 공급 장치를 차단하십시오.
- Only use with Paulmann MaxLED RGBW strips and compatible 24V power supplies.
- Do not attempt to open or modify the controller or remote control. This will void the warranty.
- 배터리는 어린이의 손이 닿지 않는 곳에 보관하세요. 사용한 배터리는 책임감 있게 폐기하세요.
패키지 내용
패키지에 모든 구성 요소가 들어 있는지 확인하세요.
- 1x Paulmann MaxLED RGBW Controller (Model 79797)
- 1x 무선 리모컨
- 1x Assembly Instructions (this manual)
Image: The MaxLED RGBW Controller and its wireless remote control. The controller is a small white rectangular unit with a cable, and the remote is an oval-shaped white device with various buttons and a color wheel.
Image: Diagram showing the MaxLED RGBW Controller and remote control with their approximate dimensions. The controller measures 22.5x85x45mm and the remote 20x110x53mm. A 150mm cable connects the controller to the LED strip.
설정 및 설치
Follow these steps for proper installation of your MaxLED RGBW Controller:
- 설치 영역 준비: Ensure the surface where the LED strip will be mounted is clean, dry, and free of dust.
- LED 스트립 연결: Connect your Paulmann MaxLED RGBW strip to the output cable of the controller. The system uses an easy plug-in connection. Ensure the connectors are securely fastened.
- 전원 공급 장치 연결: Connect a compatible 24V Paulmann power supply (not included) to the input side of the MaxLED RGBW Controller.
- 컨트롤러 장착: The controller is designed for hidden installation. Place it in a discreet location where it is protected from physical damage and moisture, but still allows for proper signal transmission from the remote (up to 30m range).
- 전원 켜기: Once all connections are secure, plug the power supply into a suitable electrical outlet.
- Pairing the Remote Control (if necessary): The remote control is usually pre-paired. If not, refer to the "Operating Instructions" section for pairing procedures.
Image: This image illustrates the MaxLED expandable component system, highlighting three key aspects: "Easy to connect" (showing a hand connecting an LED strip), "Easy to mount" (showing an LED strip being applied to a surface), and "Easy to control" (showing the remote control). This demonstrates the simplicity of the setup process.
작동 지침
The wireless remote control allows full command over your MaxLED RGBW strips.
원격 제어 기능:
이미지: 자세한 view of the MaxLED RGBW remote control, showing its various buttons and the central color wheel. The remote features power, brightness, mode, speed, and color selection controls.
- 전원 버튼 (O): Press to turn the LED strips On or Off.
- 밝기 조절(B +/-): Use the '+' button to increase brightness and '-' to decrease brightness.
- 색상 휠: Touch the color wheel to select a desired static color for your LED strips.
- Mode Selection (M): Cycle through various pre-programmed light effects and color changing modes.
- 속도 제어(S +/-): When in a dynamic mode, use the '+' button to increase the speed of the effect and '-' to decrease it.
리모컨 페어링:
If your remote control is not responding, it may need to be paired with the controller:
- 컨트롤러의 전원이 켜져 있는지 확인하세요.
- Within 3 seconds of powering on the controller, press and hold the "Mode" (M) button on the remote control for a few seconds.
- The LED strips should flash to indicate successful pairing.
유지
청소:
To clean the controller and remote control, gently wipe with a soft, dry cloth. Do not use abrasive cleaners, solvents, or excessive moisture, as this can damage the components.
원격 제어 배터리 교체 :
The remote control requires batteries (type not specified in product data, typically CR2032 or similar button cell). If the remote's range decreases or it stops responding, replace the battery:
- 리모콘 뒷면에서 배터리함을 찾으세요.
- 작은 드라이버를 사용하거나 덮개를 밀어서 칸을 여세요.
- 기존 배터리를 제거하고 새 배터리를 삽입할 때 극성(+/-)을 반드시 확인하십시오.
- 배터리 칸을 단단히 닫으세요.
- 오래된 배터리는 해당 지역 규정에 따라 폐기하세요.
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| LED strips do not light up. | No power, loose connection, faulty power supply, remote not paired. | Check power supply connection. Ensure all cables are securely plugged in. Verify power outlet is functional. Re-pair the remote control (see Operating Instructions). |
| 리모컨이 응답하지 않습니다. | Dead battery, remote not paired, out of range. | Replace remote control battery. Re-pair the remote control. Move closer to the controller (within 30m). |
| 색상이 잘못되었거나 일관성이 없습니다. | Loose connection to LED strip, faulty LED strip. | Check the connection between the controller and the LED strip. Ensure the strip is fully compatible. |
| Dimming or effects not working. | Remote control issue, incompatible LED strip. | Ensure the remote control battery is good and it is paired. Verify the LED strip is an RGBW dimmable type. |
명세서
| 상표 | 파울만 |
| 모델 번호 | 79797 |
| 제품 크기(L x W x H) | 5.3 x 11 x 2 cm (Controller); 20 x 110 x 53 mm (Remote) |
| 무게 | 102그램 |
| IP 등급 | IP20(실내 전용) |
| 재료 | 플라스틱 |
| 최대 와트tage | 144 와트 |
| 권tage | 24 볼트 |
| 광원 유형 | LED (for compatible strips) |
| 전원 | AC (via external 24V power supply) |
| 특별 기능 | Dimmable, Variable Intensity, Remote Control, RGBW Color Change |
| 원격 제어 주파수 | 2.4 GHz RF |
| 원격 제어 범위 | Up to 30 meters (non-line-of-sight) |
| 필요한 배터리(리모컨) | 예(포함되지 않음) |
Image: The MaxLED RGBW Controller and its remote control, emphasizing the 2.4 GHz RF wireless technology for reliable communication.
보증 및 지원
보증:
Paulmann offers a 1-year availability for spare parts for this product. For specific warranty terms and conditions, please refer to the official Paulmann web사이트를 방문하거나 판매점에 문의하세요.
고객 지원:
For further assistance, technical support, or inquiries regarding your Paulmann MaxLED RGBW Controller, please visit the official Paulmann website or contact their customer service department. Contact information can typically be found on the product packaging or the Paulmann web대지.
파울만 Web대지: www.paulmann.com
