중요한 안전 정보
화재, 감전 또는 부상의 위험을 줄이기 위해 본 제품을 사용하기 전에 모든 지침을 읽으십시오. 나중에 참조할 수 있도록 이 설명서를 보관하십시오.
- 전기 안전: 냉동고가 적절한 전압의 접지된 콘센트에 연결되어 있는지 확인하십시오.tage. 연장 코드나 어댑터 플러그를 사용하지 마십시오.
- 통풍: Maintain adequate air circulation around the freezer to prevent overheating. Do not block ventilation openings.
- 인화성 물질: 폭발성 물질이나 가연성 물질을 냉동고 안이나 근처에 보관하지 마세요.
- 아동 안전: Supervise children to ensure they do not play with the appliance. Old freezers can be dangerous if children are trapped inside. Remove doors before disposal.
- 수동 해동: This unit requires manual defrosting. Follow the defrosting instructions carefully to prevent damage.
설정 및 설치
짐 풀기
Remove all packaging materials, including foam, tape, and any protective film. Inspect the freezer for any shipping damage. Report any damage to the retailer immediately.
놓기
Place the freezer on a flat, stable surface strong enough to support the unit when fully loaded. Allow at least 4 inches (10 cm) of space at the back and sides, and 12 inches (30 cm) at the top for proper air circulation. Avoid placing the freezer in direct sunlight, near heat sources (e.g., stove, heater), or in areas with extreme temperature fluctuations.
영상: 뒤쪽 view of the Avanti VF58B0W upright freezer. This image illustrates the back of the unit, highlighting the compressor area and the need for adequate clearance for ventilation.
수준 측량
The freezer is equipped with two adjustable leveling legs at the front. Turn the legs clockwise to raise the unit or counter-clockwise to lower it. Ensure the freezer is level to prevent vibrations and ensure proper door sealing.
전기 연결
Before plugging in the freezer, allow it to stand upright for approximately 2-4 hours. This allows the refrigerant to settle. Connect the freezer to a dedicated, grounded 115 Volt, 60 Hz AC outlet. Do not use a two-prong adapter or an extension cord.
도어 리버설
The door hinge is reversible, allowing the door to open from either the left or right side. Refer to the detailed instructions in the separate door reversal guide (if provided) or contact customer support for assistance with this procedure.
작동 지침
온도 조절
The temperature control dial is located on the top front of the freezer. Turn the dial to adjust the internal temperature. Settings range from 'MIN' (least cold) to 'MAX' (coldest). The 'NORMAL' setting is recommended for general use. Allow several hours for the temperature to stabilize after adjustment.
영상: 상단 전면 view of the Avanti VF58B0W upright freezer. This image displays the top panel of the freezer, including the visible temperature control dial.
초기 운영
After plugging in the freezer, set the temperature control to 'NORMAL'. Allow the unit to operate empty for 2-3 hours to reach its operating temperature before loading food items.
냉동실에 넣기
The freezer features 5 fixed metal wire shelves for organized storage. Do not overload the shelves. Ensure there is sufficient space between items for cold air to circulate effectively. Avoid placing hot food directly into the freezer.
영상: 내부 view of the Avanti VF58B0W upright freezer with the door open. This image shows the internal layout with five fixed wire shelves, designed for organized storage of frozen goods.
유지
수동 해동
This freezer is a manual defrost model. Defrost the unit when ice accumulation on the freezer walls reaches approximately 1/4 inch (6 mm) thick. Frequent defrosting helps maintain efficiency.
- 전기 콘센트에서 냉동고의 플러그를 뽑습니다.
- 모든 식품을 꺼내어 다른 냉동고나 아이스박스에 넣어 얼린 상태로 보관하세요.
- Leave the freezer door open to allow ice to melt naturally. Place towels on the floor to absorb water. Do not use sharp objects or heating devices to speed up defrosting, as this can damage the freezer.
- 얼음이 모두 녹으면 내부를 깨끗이 청소하고 완전히 말리세요.
- Plug the freezer back in and allow it to cool for 2-3 hours before returning food items.
청소
내부: Clean the interior regularly with a solution of mild detergent and warm water. Rinse thoroughly and dry completely before closing the door. Do not use abrasive cleaners or solvents.
외부: Wipe the exterior surfaces with a soft cloth and mild detergent. Avoid getting water on electrical components.
파워 오우tage
정전이 발생한 경우tage, keep the freezer door closed to maintain the internal temperature for as long as possible. Avoid opening the door unnecessarily.
휴가
단기 휴가 : Leave the freezer operating. Remove perishable items if you will be away for an extended period.
장기 휴가 : If you will be away for a month or more, unplug the freezer, remove all food, defrost, clean, and dry the interior. Leave the door slightly ajar to prevent odors and mold growth.
냉동실 이동
When moving the freezer, secure the door with tape. Protect the exterior surfaces. Do not tilt the freezer more than 45 degrees. If tilted, allow it to stand upright for at least 2-4 hours before plugging it in.
문제 해결 가이드
서비스에 문의하기 전에 다시 문의하세요view 이 섹션에서는 일반적인 문제와 해결책을 다룹니다.
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 냉동고가 작동하지 않습니다 | 플러그가 꽂혀 있지 않음; 회로 차단기가 작동함; 전원이 꺼짐tage. | 플러그가 제대로 꽂혀 있는지 확인하고, 차단기를 점검하고, 전원 공급이 제대로 되는지 확인하십시오. |
| 온도가 충분히 낮지 않습니다 | Temperature control set too warm; door opened too frequently; heavy ice buildup; poor ventilation. | Adjust control to a colder setting; minimize door openings; defrost the unit; ensure adequate clearance around freezer. |
| 과도한 소음 | 냉동고가 수평이 아니며, 물체가 본체에 부딪혀 진동하고 있습니다. 압축기는 정상적으로 작동하고 있습니다. | Adjust leveling legs; ensure nothing is touching the freezer; some operational sounds are normal. |
| 문이 제대로 닫히지 않음 | Freezer not level; door gasket dirty or damaged; food packages blocking door. | 냉동고 수평을 맞추고, 고무 패킹을 청소하거나 교체하고, 식품들을 재배치하세요. |
명세서
The following specifications apply to the Avanti VF58B0W Upright Freezer:
영상: 앞쪽 view of the Avanti VF58B0W upright freezer with dimensions. This image clearly labels the height (56"), width (21.5"), and depth (22.5") of the unit.
| 특징 | 사양 |
|---|---|
| 상표 | 아반티 |
| 모델명 | VF58B0W |
| 용량 | 5.8 입방 피트 |
| 제품 크기(D x W x H) | 22.5 x 21.5 x 56 인치 |
| 품목 무게 | 90파운드 |
| 설치 유형 | 독립형 |
| 색상 | 하얀색 |
| 제상 유형 | 수동 |
| 선반 | 5 Fixed Metal Wire Shelves |
| 인증 | Energy Star 인증 |
보증 및 지원
For warranty information, please refer to the warranty card included with your product or visit the official Avanti website. If you require technical assistance or have questions not covered in this manual, please contact Avanti customer service.
- 고객 서비스: Refer to your product documentation for contact details.
- 온라인 리소스: 제조사 확인해보세요 website for FAQs, additional guides, or service request forms.
