DIRECTV RC73, 4336303112

DIRECTV RC73 IR/RF 리모컨 사용 설명서

Model: RC73, 4336303112

제품 끝view

The DIRECTV RC73 IR/RF Remote Control is designed for seamless control of your DIRECTV Genie system and other compatible devices. It features both Infrared (IR) and Radio Frequency (RF) technologies, allowing for flexible operation without needing to point the remote directly at the receiver when in RF mode. This remote offers a streamlined layout with essential buttons for navigating your entertainment.

Two DIRECTV RC73 remote controls side-by-side.

Image: Two DIRECTV RC73 remote controls, showcasing their black and white design and button layout.

설정

1. 배터리 설치

Your DIRECTV RC73 remote control requires two AA batteries for operation. These batteries are typically included with your purchase.

  1. 리모콘 뒷면에 있는 배터리함 덮개를 찾으세요.
  2. Slide the cover downwards or press the release tab (if present) and lift the cover off.
  3. AA 배터리 두 개를 넣고 양극(+)과 음극(-) 단자가 배터리 보관함 내부의 표시기와 올바르게 맞춰지도록 합니다.
  4. 배터리 칸 덮개를 다시 끼우고, 딸깍 소리가 날 때까지 밀어서 제자리에 고정합니다.
Two DIRECTV RC73 remotes with included AA batteries and a Genie Remote Guide.

Image: Two DIRECTV RC73 remote controls shown with two AA batteries and a small instruction guide, illustrating the contents of the package.

2. Pairing the Remote to Your DIRECTV Genie Receiver (RF Mode)

To enable RF (Radio Frequency) control, allowing you to operate your receiver without direct line-of-sight, follow these steps:

  1. Point the remote at your DIRECTV receiver.
  2. 동시에 눌러서 유지하세요 음소거 버튼과 선택하다 button on the remote for approximately 5 seconds.
  3. Release the buttons when the green light on the remote blinks twice.
  4. Using the number pad on the remote, enter the code 961.
  5. 를 누르세요 채널 업 버튼을 한 번 누릅니다.
  6. 를 누르세요 입력하다 button (located below the number pad).
  7. Observe your TV screen. A message should appear indicating "Applying RF/IR Setup. Please Wait..." followed by "Your Remote is now setup for RF."
  8. 를 누르세요 선택하다 (OK) button on the remote to confirm.

3. Programming the Remote to Your TV (Volume Control)

To control your TV's volume and power with the RC73 remote, you need to program it to your television. This process typically involves selecting your TV's brand from the receiver's menu.

  1. 를 누르세요 메뉴 button on your DIRECTV remote.
  2. Navigate down using the 채널 다운 button to find and select 설정.
  3. Once in Settings, use the directional arrows to navigate to the right until you find and select 원격 제어.
  4. From the Remote Control Setup menu, select 페어링/프로그램 원격.
  5. 선택하다 Program Audio Device.
  6. You will be prompted to select your TV's brand. Use the keypad or navigate through the list to find your brand (e.g., Samsung). If you don't know the specific model, select "I don't know my model" if available.
  7. Follow the on-screen prompts to test the code. This usually involves pressing the button on the remote to see if your TV turns off.
  8. If the TV turns off, select "It Worked" to confirm the programming. If not, select "Try Next Code" and repeat the test until a working code is found.

작동 지침

The DIRECTV RC73 remote control features a user-friendly layout for intuitive navigation and control of your DIRECTV system and connected devices.

Detailed diagram of the DIRECTV RC73 remote control with labels for each button's function.

Image: A detailed diagram of the RC73 remote, illustrating the function of each button for comprehensive control.

키 버튼 기능
단추기능
ON/OFF (RC73)Turns both DIRECTV Receiver and TV ON or OFF at the same time. (Remote must be programmed for TV; HD DVR still records when off.)
가이드Press once for On-Screen Guide. Press twice for programming grouped into categories.
메뉴Accesses the main menu for settings, recordings, and more.
목록Displays the LIST of your recorded programs.
EXITExits the current menu and returns to the previous channel view편집.
선택하다Selects the item highlighted on screen.
정보Displays INFORMATION about the program now playing or highlighted in the On-Screen Guide.
VOL (볼륨)Adjusts the volume of your TV or audio device (if programmed).
CH (채널)채널을 위 또는 아래로 변경합니다.
이전Returns to the PREVIOUS channel view편집.
RECORD (Red Circle)Records the program now playing or highlighted in the On-Screen Guide. Press twice to record the entire series.
음소거소리를 음소거합니다.
다시 하다Replays the previous six seconds.
되감기Rewinds at increasing speeds—press up to four times.
재생/일시정지Plays the current program. Press once while the program is playing to PAUSE.
DASH (-)Press for Guide Options while viewing On-Screen Guide. Press for playlist options while viewing playlist. Press to display last 6 digits of receiver ID, satellite signal type (SWiM or Multiswitch) and Internet status.
전진Advances 30 seconds. Press and hold to jump ahead to the end of a recorded program.
빨리 감기Fast-forwards at increasing speeds—press up to four times.
ENTER (Input)Press for Mini Guide while viewing your program and dismiss with EXIT. ENTER also replaces TV INPUT button: to cycle through the equipment connected to your TV, press and hold for three seconds until LED light at top turns green. Then scroll through inputs by pressing ENTER again.

유지

배터리 교체

When the remote's performance degrades or the green light no longer blinks during operation, it's time to replace the batteries. Always use two new AA batteries for optimal performance.

  1. Remove the battery compartment cover as described in the Setup section.
  2. 오래된 배터리를 제거하세요.
  3. Insert two new AA batteries, observing the correct polarity (+/-).
  4. 배터리 덮개를 다시 장착하세요.

청소

To maintain the remote's appearance and functionality, periodically wipe it with a soft, dry cloth. Avoid using abrasive cleaners, solvents, or harsh chemicals, as these can damage the remote's surface or internal components.

문제 해결

일반적인 문제 및 솔루션
문제가능한 원인해결책
리모컨이 수신기에 반응하지 않습니다.Low or dead batteries; Remote not paired in RF mode; Obstruction between remote and receiver (if in IR mode).Replace batteries. Ensure remote is paired in RF mode (refer to Setup section). Remove any obstructions.
Volume or TV power buttons not working.Remote not programmed to TV.Program the remote to your TV (refer to Setup section, "Programming the Remote to Your TV").
Green light on remote blinks slowly or not at all.배터리 전원이 부족합니다.배터리를 즉시 교체하십시오.
Remote controls receiver but not client device (e.g., Genie Mini).Client device not properly paired or connected.Ensure the client device is correctly connected and powered on. Re-pair the remote with the client device if necessary (consult your Genie Mini's specific instructions).

명세서

보증 및 지원

For specific warranty information regarding your DIRECTV RC73 remote control, please refer to the documentation included with your original purchase or visit the official DIRECTV web사이트. 보증 약관은 다를 수 있습니다.

For technical support, troubleshooting assistance beyond this manual, or to inquire about replacement parts, please contact DIRECTV customer service directly. Contact information can typically be found on your DIRECTV bill, their official website, or through your service provider.

온라인 리소스:

관련 문서 - RC73, 4336303112

사전view DIRECTV Genie 및 범용 리모컨 사용 설명서
DIRECTV Genie 및 Universal 리모컨의 기능을 완벽하게 이해할 수 있도록 자세한 버튼 설명과 다양한 DIRECTV 수신기 및 TV에 대한 프로그래밍 방법을 안내하는 종합 가이드입니다.
사전view DIRECTV Wireless Genie Mini 설정 및 활성화 가이드
새로운 DIRECTV Wireless Genie Mini를 연결, 설정, 활성화 및 프로그래밍하여 원활한 비디오 엔터테인먼트를 즐기는 방법에 대한 단계별 지침입니다.
사전view DIRECTV 범용 리모컨 사용 설명서: 시작하기 및 프로그래밍
DIRECTV 범용 리모컨 사용법, 버튼 기능 이해, 그리고 비즈니스 계정용 RC73 리모컨 프로그래밍 방법을 알아보세요. 설정 방법 및 기능에 대한 설명이 포함되어 있습니다.
사전view DIRECTV Genie 2 서버 활성화 및 장비 반납 지침
DIRECTV Genie 2 서버 교체를 활성화하고 기존 장비를 반품하여 미반품 수수료를 면제받는 방법을 단계별로 안내합니다. 설치, 페어링, 반품 절차가 포함되어 있습니다.
사전view DIRECTV Genie 2 제품 설명서 - 기능, 사양 및 안전 정보
DIRECTV Genie 2 위성 수신기의 하드웨어 세부 정보, 기능, 문제 해결, LED 표시등, 안전 주의 사항 및 보증 정보를 포함하는 종합 제품 설명서입니다. 설치 및 작동 안내도 포함되어 있습니다.
사전view DIRECTV Wireless Genie Mini C41W Installation Guide
Step-by-step guide to installing and connecting the DIRECTV Wireless Genie Mini (Model C41W) to your Genie HD DVR for enhanced home entertainment.