1. 서론
Thank you for choosing the Brilliant Tanko 96162/06 Outdoor Wall Light with Motion Sensor. This manual provides essential information for the safe installation, operation, and maintenance of your new outdoor lighting fixture. Please read these instructions carefully before installation and retain them for future reference.
2. 안전 지침
- 전기 안전: Installation must be performed by a qualified electrician in accordance with all local and national electrical codes. Always disconnect power at the main circuit breaker before attempting any installation, maintenance, or bulb replacement.
- 야외 사용: This fixture is rated IP44, meaning it is protected against solid objects larger than 1mm and against splashing water from any direction. It is designed for outdoor use only.
- 전구 유형: Use only R7s halogen bulbs with a maximum wattage of 150W. Exceeding the maximum wattag이는 과열을 일으켜 기기를 손상시키거나 화재 위험을 초래할 수 있습니다.
- 손질: Do not touch the halogen bulb with bare hands during installation or replacement, as oils from your skin can cause premature failure. Use a clean cloth or gloves.
- 설치: 설치 표면이 구조적으로 견고하고 조명기구의 무게를 지탱할 수 있는지 확인하십시오.
3. 패키지 내용
모든 구성 요소가 있고 손상되지 않았는지 확인하세요.
- Brilliant Tanko 96162/06 Outdoor Wall Light Unit with Motion Sensor
- 설치용 하드웨어(나사, 벽 플러그)
- 사용 설명서(본 문서)
Note: R7s bulb is typically not included and must be purchased separately.
4. 설정 및 설치
시작하기 전에: 설치 구역으로의 전원 공급이 주 회로 차단기로 꺼져 있는지 확인하세요.
- 장착 표면 준비: Choose a suitable wall location for the fixture. Mark the drilling points for the mounting bracket.
- 브래킷을 장착합니다: Drill holes at the marked points and insert the wall plugs. Secure the mounting bracket to the wall using the provided screws.
- 배선: Connect the electrical supply wires to the terminal block inside the fixture. Ensure correct polarity (Live, Neutral, Earth) according to local wiring regulations. Secure all connections tightly.
- 전구를 설치하십시오: Carefully insert an R7s halogen bulb (max 150W) into the bulb holder. Avoid touching the glass part of the bulb with bare hands.
- 고정 장치를 부착하세요: Secure the main light unit to the mounted bracket. Ensure it is firmly attached and sealed against the wall to maintain its IP44 rating.
- Adjust Sensor and Light Head: The motion sensor and light head are adjustable. Position them to cover the desired detection area and illumination direction.
Figure 4.1: Brilliant Tanko 96162/06 Outdoor Wall Light with Motion Sensor. This image shows the complete fixture, including the main light housing and the adjustable motion sensor unit mounted below it.
그림 4.2: 클로즈업 view of the R7s bulb socket within the Brilliant Tanko fixture. This illustrates where the R7s halogen bulb should be inserted.
5. 사용 설명서
Once installed and power is restored, the Brilliant Tanko 96162/06 will operate as follows:
- 동작 감지: The integrated motion sensor detects movement within its adjustable range. When motion is detected, the light will automatically turn on.
- 빛 지속 시간: The light will remain on for a set period after motion is detected. This duration is typically adjustable via controls on the sensor unit (refer to specific markings on your sensor for adjustment dials for 'TIME' and 'LUX' settings, if present).
- Ambient Light Sensor (LUX): The sensor also includes an ambient light sensor. This prevents the light from activating during daylight hours, saving energy. The sensitivity of this sensor can often be adjusted to determine at what level of darkness the motion sensor becomes active.
6. 유지관리
- 청소: 조명기구를 청소하려면 전원이 꺼져 있는지 확인하십시오. 부드러운 천으로 닦으십시오.amp cloth. Do not use abrasive cleaners or solvents, as these can damage the finish or sensor.
- 전구 교체: Always disconnect power before replacing the bulb. Allow the old bulb to cool completely. Carefully remove the old R7s bulb and insert a new R7s bulb (max 150W), avoiding direct contact with the glass.
- 점검: 정기적으로 조명기구를 점검하여 손상, 연결 불량 또는 마모 흔적이 있는지 확인하십시오. 문제가 발견되면 전원을 차단하고 자격을 갖춘 전기 기술자에게 문의하십시오.
7. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 조명이 켜지지 않습니다. | No power supply. Blown bulb. Faulty wiring. Ambient light too high. | Check circuit breaker. Replace bulb. Verify wiring connections (consult electrician). Adjust LUX setting on sensor. |
| 표시등이 계속 켜져 있습니다. | Continuous motion detected. Sensor faulty. Wiring error. | Adjust sensor angle/sensitivity. Check for obstructions. Consult electrician. |
| 조명이 무작위로 켜집니다. | Sensor too sensitive. Environmental factors (wind, animals). | Reduce sensor sensitivity. Re-position sensor to avoid unwanted triggers. |
| 빛이 깜박입니다. | Loose bulb. Incorrect bulb type. Power fluctuations. | Ensure bulb is seated correctly. Verify R7s 150W bulb. Consult electrician for power issues. |
8. 사양
| 특징 | 세부 사항 |
|---|---|
| 상표 | 멋진 |
| 모델 번호 | 96162/06 |
| 제품 크기(L x W x H) | 14 x 21 x 22cm |
| 품목 무게 | 521그램 |
| IP 등급 | IP44 |
| 스타일 | 현대의 |
| 색상 | 검은색 |
| 재료 | 금속, 유리 |
| 전구의 수 | 1 |
| 권tage | 230 볼트 |
| 특정 용도 | 실외에서만 사용 가능 |
| 특별 기능 | Adjustable (sensor/light head) |
| 캡 타입 | R7 |
| 최대 와트tage | 150와트 |
| 전원 | Electrical Cable (Wired) |
| 설치 유형 | 벽면 장착 |
| 에너지 라벨 | A+ to E (for compatible bulbs) |
Figure 8.1: Energy label for the Brilliant Tanko 96162/06, indicating compatibility with bulbs from energy classes A++ to E.
9. 보증 및 지원
Information regarding specific warranty terms and spare parts availability for the Brilliant Tanko 96162/06 is not provided in the product data. For warranty claims, technical support, or inquiries about spare parts, please contact the retailer where you purchased the product or the manufacturer directly. Always have your proof of purchase and model number (96162/06) available when contacting support.
