소개
This manual provides essential information for the safe and efficient operation, installation, and maintenance of your Pedrollo BCm 10/50-N Double Channel Submersible Pump. Please read this manual thoroughly before installation or use to ensure proper function and to prevent injury or damage.
Figure 1: Pedrollo BCm 10/50-N Double Channel Submersible Pump. This image shows the overall design of the pump, including its robust casing, handle, and float switch.
안전 정보
Always observe the following safety precautions to prevent accidents and ensure safe operation of the pump.
주의!
- Before installation and use, read all instructions carefully. The manufacturer declines all responsibility in the event of accident or damage due to negligence or failure to observe the instructions described in this booklet or in conditions that differ from those indicated on the rating plate.
- 또한 워터 펌프의 부적절한 사용으로 인해 발생한 손상에 대해서는 모든 책임을 지지 않습니다.
안전한
- Before carrying out checks or any maintenance, clear the system by disconnecting the voltage 소켓에서 펌프를 분리합니다.
- 워터 펌프를 설치하기 전에 전원 공급 주전원이 접지되어 있고 규정을 준수하는지 확인하십시오.
- During operation, the motor can get hot; be careful.
- 인화성 액체를 펌핑하거나 폭발 위험이 있는 장소에서 작동하는 데는 적합하지 않습니다.
- 전원 공급 장치와 펌핑할 액체가 접촉하지 않도록 하십시오.
- 워터 펌프는 절대로 공급 케이블을 이용해 들어 올리거나 운반해서는 안 됩니다.
The norm EN 60335-2-41 sets out what follows:
- The pump used for cleaning and other swimming pool maintenance purposes should not be used when there are people in the pool and.
- For pumping from ornamental garden ponds and similar places must be supplied through a residual current device (RCD) with a rated residual operating current not exceeding 30 mA.
- For pumps meant to be used in swimming pools and similar, to be used for outdoor, use the supply cord should not be any lighter than "HO7 RN-F" (245 IEC 66 denomination).
The appliance is not to be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. Children should be supervised to ensure that they do not play with the appliance.
예비 검사
- 포장을 풀고 완벽한 상태인지 확인하십시오.
- 주의! 또한 명판의 데이터가 요구되는 데이터와 일치하는지 확인하십시오.
- 주의! If there is any problem contact the supplier immediately, specifying the type of pump.
주의!
- If there is any doubt about the safety of the machine, do not use it.
설치
Installation must be a fairly complex operation and must therefore be carried out by competent and authorized installers.
주의! Do not install and apply all safety regulations issued by the competent authorities and use common sense at all times.
전기 연결
The appliance must be earthed and correctly connected.
- 주의! It is the installer's responsibility to perform the connections in compliance with the regulations in force in the country of installation.
- 볼륨이 없는지 확인하십시오.tage 연결하기 전에 라인 와이어 터미널에.
Figure 2: Technical Datasheet for Pedrollo Double Channel Submersible Pumps. This diagram illustrates typical installation setups, performance curves, and detailed component breakdowns, crucial for proper installation and understanding pump capabilities.
Installation and Use Guidelines (Refer to Figure 2)
Pedrollo BCm series pumps are designed for pumping drainage water, sewage water, and water mixed with mud. They are suitable for domestic, civil, and industrial applications. The pump can be installed in sumps, tanks, or wells, ensuring it is fully submerged during operation. The float switch automatically controls pump operation based on liquid levels.
Application Limits (Refer to Figure 2)
- Maximum operating depth: 5 m below water level.
- Maximum liquid temperature: +40 °C.
- Passage of suspended solids: up to 50 mm for BC 10/50-N.
- Minimum emptying level from bottom: 50 mm.
- Continuous service: S1.
작동 지침
Once properly installed and connected, the pump operates automatically via its float switch. Ensure the pump is fully submerged during operation to prevent dry running.
- The pump is designed for intermittent or continuous operation within its specified limits.
- Do not operate the pump if the liquid contains abrasive particles that could damage the impeller or pump body.
- Ensure the discharge pipe is clear and unobstructed.
유지
정기적인 유지관리는 펌프의 수명과 최적의 성능을 보장합니다.
- Before doing anything, make sure that the pump is disconnected from the power source and that there is no possibility of accidental connections.
- 제조업체가 승인하지 않은 사람이 펌프를 수리하면 보증이 무효화되고 잠재적으로 위험한 장비를 사용하게 됩니다.
- 주의! 모든 tamp오류가 발생하면 성능이 저하되고 사람 및/또는 사물에 위험이 발생할 수 있습니다.
- 주의! The loss of any lubricant contained within the pump will not result in the contamination of the pumped liquid.
- 주의! The apparatus is not intended for use by people (children included) with reduced physical, sensory or mental capabilities, or by those lacking the required experience or knowledge unless supervised or instructed in the use of the apparatus by a person responsible for their safety. Children should be supervised in order to ensure that they do not play with the apparatus.
Periodically check the pump for any blockages, especially around the impeller and suction inlet. Clean any debris to maintain efficient flow.
문제 해결
This section provides guidance for common issues. For problems not listed or if issues persist, contact authorized service personnel.
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 펌프가 시작되지 않습니다 | No power supply; Float switch stuck; Motor overload protection tripped; Impeller jammed. | Check power connection and circuit breaker; Ensure float switch moves freely; Allow motor to cool and reset; Disconnect power and clear impeller. |
| 펌프는 작동하지만 물이 나오지 않거나 유량이 적습니다. | Suction inlet blocked; Discharge pipe blocked or kinked; Air lock; Pump not fully submerged. | Disconnect power and clear inlet; Check and clear discharge pipe; Tilt pump to release air; Ensure pump is fully submerged. |
| 펌프가 자주 켜졌다 꺼졌다 합니다. | Float switch range too narrow; Inflow rate too low. | Adjust float switch position (if adjustable); Ensure adequate water level for operation. |
명세서
Key technical specifications for the Pedrollo BCm 10/50-N pump.
| 특성 | 값 |
|---|---|
| 모델 | BCm 10/50-N |
| 부품 번호 | 48SGM81A0A1 |
| 유형 | Double Channel Submersible Pump |
| 전원 | AC 어댑터 |
| 권tage | 230 볼트 |
| 최대 유량 | 분 당 600 리터 |
| 최대 작동 깊이 | 5 m below water level |
| 최대 액체 온도 | +40 °C |
| Passage of Suspended Solids | 최대 50mm |
| Minimum Emptying Level | 50 mm from bottom |
| 재료 | 스테인리스 스틸 |
| 품목 무게 | 12.4kg |
For detailed performance curves and dimensional drawings, please refer to Figure 2 in the Installation section.
보증 및 지원
For technical assistance, warranty claims, or further information, please contact Pedrollo S.p.A. or an authorized service center.
Figure 3: Pedrollo S.p.A. Contact Information and Declaration of Conformity. This image provides official contact details for Pedrollo and confirms the product's compliance with European directives.
제조업체 연락처 정보:
페드롤로 스파
E. Fermi를 통해, 7
37047 San Bonifacio (Verona) - Italy
전화 +39 045 6136311
팩스 +39 045 7614663
이메일: sales@pedrollo.com
Web대지: www.pedrollo.com
적합성 선언:
당사는 이에 전적인 책임 하에 문제의 제품이 최신 수정 사항을 포함하여 다음 커뮤니티 지침의 조항과 관련 동화된 국가 법률을 준수함을 선언합니다.
2006/42/EU, 2014/35/EU, 2014/30/EU, 2009/125/EU, 547/2012/EU, 2011/65/EU
Date: San Bonifacio, 03/08/2018
