소개
This manual provides comprehensive instructions for the installation, operation, and maintenance of the Hunter 99179 Original Ceiling Fan Remote Control and Canopy Kit. This kit is specifically designed to enhance the functionality of Hunter "Original" series ceiling fans by adding remote control capabilities for fan speeds and lighting.
The kit includes a remote control unit and a canopy designed to house the receiver. It integrates with your existing two-wire fan setup, offering convenient control over three fan speeds and the fan's light fixture.
중요한 안전 정보
- 전기 안전: Always disconnect power at the circuit breaker or fuse box before attempting any installation, maintenance, or repair. Failure to do so can result in serious injury or death.
- 호환성: This kit is designed for use 오직 with Hunter "Original" series ceiling fans. It is not compatible with other fan models or brands.
- Downrod Requirement: Installation requires a downrod of 12 inches or longer (sold separately). The receiver unit is designed to fit within the canopy, which necessitates sufficient space provided by a longer downrod.
- 전문적인 설치: If you are unfamiliar with electrical wiring or ceiling fan installation, it is recommended to consult a qualified electrician.
- 지역 코드: Ensure all installation procedures comply with local electrical codes and ordinances.
- 제품 무결성: 제품을 개조하거나 본래 용도 이외의 목적으로 사용하지 마십시오.
패키지 내용
설치를 시작하기 전에 모든 구성 요소가 있는지 확인하세요.
- 원격 제어 장치
- 원격 수신기
- Canopy (for receiver housing)
- Mounting Hardware (screws, wire nuts, etc. - specific items may vary)
Image: A Hunter ceiling fan, representative of the type of fan compatible with the 99179 remote and canopy kit.
설정 및 설치
Follow these steps carefully to install your Hunter 99179 Remote Control and Canopy Kit:
- 전원 차단: Before starting, turn off the electrical power to your ceiling fan at the main circuit breaker or fuse box.
- 접속 배선: Carefully lower the existing canopy from your Hunter Original ceiling fan to expose the wiring connections.
- Remove Old Receiver (if applicable): If an old receiver is present, disconnect its wiring and remove it.
- Install New Receiver: Connect the new remote receiver's wires to the corresponding fan and household wires. Ensure all connections are secure using wire nuts. The receiver is designed to fit within the new canopy.
- 캐노피 위치 지정: Carefully tuck the wired receiver into the new canopy. Ensure no wires are pinched.
- 안전한 캐노피: Mount the new canopy securely to the fan's mounting bracket. Confirm that the downrod is at least 12 inches long to accommodate the receiver within the canopy.
- 복원력 : Once installation is complete and all connections are secure, restore power to the ceiling fan at the circuit breaker.
- 원격 페어링: Follow the instructions provided with the remote control unit to pair it with the newly installed receiver. This typically involves pressing a button on the remote within a short time after restoring power.
메모: The new canopy is designed to accommodate the receiver. Some older Hunter Original fan mounting plates or downrods may not be compatible with the new canopy's dimensions. Verify fit before final installation.
작동 지침
Your Hunter 99179 remote control provides convenient operation of your ceiling fan and light:
- 팬 속도 제어: Use the designated buttons on the remote to cycle through three fan speeds (Low, Medium, High) or to turn the fan off.
- 조명 제어: Use the light button to turn the fan light on or off. Some remotes may also support dimming functions if your fan and light kit are compatible.
- 배터리 교체: If the remote control stops responding, replace the batteries. Refer to the remote's specific instructions for battery type and replacement procedure.
유지
To ensure optimal performance and longevity of your Hunter 99179 kit:
- 청소: Periodically wipe the remote control and canopy with a soft, dry cloth. Do not use abrasive cleaners or solvents.
- 배터리 점검: 리모컨의 배터리는 필요에 따라 교체하여 안정적인 작동을 유지하십시오.
- 배선 검사: Annually, or if issues arise, ensure all electrical connections within the canopy are secure and free from corrosion. Always disconnect power before inspection.
문제 해결
If you encounter issues with your remote control and canopy kit, refer to the following common solutions:
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| Remote not responding / Fan or light not working |
|
|
| Canopy does not fit / Receiver cannot be housed |
|
|
| 다른 장치의 간섭 |
|
|
명세서
- 모델 번호: 99179
- 제조업체: 헌터 팬 컴퍼니
- 제품 크기: 약 6 x 6 x 7인치
- 품목 무게: 약 2.35파운드
- 권tage: 120 볼트
- 전원: 코드식 전기식
- 재료: 금속
- 인증: ETL 등록됨
- 용법: Ceiling fan remote control and canopy accessory
- 특징: 견고한 구조
- 호환 장치: Hunter "Original" series ceiling fans
보증 정보
No specific warranty description is provided for the Hunter 99179 Remote Control and Canopy Kit in the product details. For warranty inquiries, please contact Hunter Fan Company directly or refer to the documentation included with your original Hunter "Original" ceiling fan.
고객 지원
For further assistance, technical support, or to inquire about parts, please visit the official Hunter Fan Company web사이트 또는 고객 서비스 부서에 문의하십시오.
헌터 팬 컴퍼니 Web대지: 아마존에서 헌터 스토어를 방문하세요.
