1. 서론
This manual provides comprehensive instructions for the proper setup, operation, and maintenance of your Compustar 700R replacement remote for remote starter systems. Please read this manual thoroughly before attempting to use or program your new remote to ensure correct functionality and to avoid potential issues.
The Compustar 700R is designed as a direct replacement for compatible Compustar remote starter systems, offering reliable control over your vehicle's remote start, lock, unlock, and other auxiliary functions.
Image: The Compustar 700R replacement remote, a compact black device with multiple control buttons for vehicle functions.
2. 안전 정보
- 리모컨을 물이나 과도한 습기로부터 멀리하십시오.
- 리모컨을 극한의 온도(고온 또는 저온)에 노출시키지 마십시오.
- Do not attempt to disassemble or modify the remote control. This may void the warranty and cause damage.
- 사용한 배터리는 해당 지역 규정에 따라 폐기하십시오. 배터리를 소각하지 마십시오.
- 배터리는 어린이의 손이 닿지 않는 곳에 보관하십시오. 삼켰을 경우 즉시 의사의 진료를 받으십시오.
3. 패키지 내용
패키지에 다음 품목이 포함되어 있는지 확인하십시오.
- Compustar 700R Replacement Remote (1 unit)
- Lithium Metal Battery (pre-installed or separate, typically 1 unit)
If any items are missing or damaged, please contact your retailer or Compustar support.
4. 설정
4.1 배터리 설치
The Compustar 700R remote typically comes with a pre-installed battery. If you need to install or replace the battery, follow these steps:
- 리모컨 뒷면에서 배터리 덮개를 찾으세요.
- Carefully open the cover using a small coin or screwdriver if necessary.
- Insert the new Lithium Metal battery (e.g., CR2032) with the positive (+) side facing up, observing the polarity markings inside the compartment.
- 배터리 덮개를 단단히 닫으세요.
4.2 리모컨 프로그래밍
The 700R remote must be programmed to your vehicle's Compustar remote starter system to function. The programming procedure can vary slightly depending on your specific Compustar system and vehicle model. Always refer to your vehicle's remote starter system manual for the most accurate programming instructions. A common programming method involves the following general steps:
- Locate the Valet Switch: Find the Valet switch in your vehicle. This is usually a small button located near the steering column, under the dash, or in the fuse box area.
- 프로그래밍 모드로 들어가기:
- Insert your vehicle's key into the ignition.
- Turn the ignition to the ON position (do not start the engine).
- Within 5 seconds, press and release the Valet switch 5 times. The vehicle's parking lights should flash, or the horn may chirp, indicating entry into programming mode.
- 리모컨 프로그래밍하기:
- While the system is in programming mode, press and hold the 잠그다 button (or the primary function button) on your new 700R remote for approximately 2 seconds.
- The vehicle's parking lights should flash again, or the horn may chirp, confirming that the remote has been programmed.
- 프로그래밍 모드 종료: Turn the ignition OFF. The system will automatically exit programming mode after a few seconds of inactivity.
- 리모컨 테스트: Test all functions of the remote (lock, unlock, remote start) to ensure successful programming.
메모: If you are programming multiple remotes, program them one after another without exiting programming mode. If an existing remote stops working after programming a new one, you may need to re-program all remotes simultaneously.
5. 운영
The Compustar 700R remote provides control over various vehicle functions. Button labels and functions may vary slightly based on your specific Compustar system configuration.
- 잠금 버튼: Press once to lock the vehicle doors.
- 잠금 해제 버튼: Press once to unlock the vehicle doors.
- 원격 시작 버튼: Press and hold for approximately 2-3 seconds to initiate remote engine start. The vehicle's parking lights will flash, and the engine will start.
- Remote Stop Button: While the engine is running via remote start, press and hold the Remote Start button again for 2-3 seconds to turn off the engine.
- Trunk Release / Auxiliary Button: Press and hold for approximately 2-3 seconds to open the trunk or activate a programmed auxiliary function (e.g., power sliding doors).
- Panic / Car Finder Button: Press and hold for approximately 2-3 seconds to activate the vehicle's alarm (panic mode) or to locate your vehicle in a parking lot (car finder). Press any button to deactivate.
Refer to your Compustar system's main user manual for detailed information on specific button combinations and advanced features.
6. 유지관리
6.1 배터리 교체
When the remote's range decreases or it becomes unresponsive, it may be time to replace the battery. Follow the steps outlined in Section 4.1 Battery Installation. The 700R remote uses one Lithium Metal battery (e.g., CR2032).
6.2 청소
To clean the remote, wipe it gently with a soft, dry cloth. Do not use harsh chemicals, abrasive cleaners, or immerse the remote in water.
6.3 보관
장기간 사용하지 않을 때는 리모컨을 직사광선과 극한 온도 변화를 피해 서늘하고 건조한 곳에 보관하십시오.
7. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| Remote not responding / No functions work | 배터리가 방전되었거나 배터리가 부족합니다 리모컨이 범위를 벗어났습니다. 리모컨이 프로그래밍되지 않았습니다. |
배터리 교체(섹션 4.1) 차량에 더 가까이 다가가세요 Re-program the remote (Section 4.2) |
| 짧은 작동 범위 | 배터리 부족 환경 간섭 Obstructions between remote and vehicle |
배터리 교체(섹션 4.1) Move away from sources of interference (e.g., power lines, large metal structures) Ensure clear line of sight if possible |
| 차량은 원격 시동이 걸리지 않습니다. | Vehicle conditions not met (e.g., hood open, door ajar, low fuel) Remote not programmed correctly |
Check vehicle status indicators Ensure vehicle is in 'ready mode' for remote start Re-program the remote (Section 4.2) |
| Existing remote stopped working after programming new one | System exited programming mode before all remotes were programmed | Re-program all remotes (old and new) in a single programming session (Section 4.2) |
If you continue to experience issues after attempting these troubleshooting steps, please contact Compustar customer support or an authorized dealer.
8. 사양
- 모델: 700R
- 품목 무게: 0.96 온스
- 패키지 크기: 4.65 x 2.72 x 0.59 인치
- 배터리: 1개의 리튬 금속 배터리 필요(포함)
- 제조업체 부품 번호: 700R
- 특징: 인체공학적 디자인
- 연결 기술 : Infrared (Note: Some Compustar systems use RF, verify compatibility with your system)
- 색상: 검은색
9. 보증 및 지원
For detailed warranty information regarding your Compustar 700R replacement remote, please refer to the official Compustar website or the warranty card included with your original remote starter system. Warranty terms typically cover manufacturing defects for a specified period from the date of purchase.
If you require technical assistance, have questions about programming, or need to report a defect, please contact Compustar customer support through their official website or consult an authorized Compustar dealer. Providing your product model (700R) and any relevant system information will help expedite support.
온라인 리소스: Visit the official Compustar web자주 묻는 질문(FAQ), 업데이트된 설명서 및 지원 연락처 정보를 제공하는 사이트입니다.
