소개
This manual provides essential information for the installation, operation, maintenance, and troubleshooting of your InSinkErator F-HC2200CRB Antique Instant Hot and Cold Water Dispenser Faucet. This faucet is designed to deliver near-boiling hot water and filtered cold water instantly, enhancing convenience in your kitchen. Please read these instructions thoroughly before installation and use.
메모: This faucet requires a compatible InSinkErator hot water tank and filtration system (e.g., HWT-F1000S), which are sold separately, to function as an instant hot water dispenser.
중요한 안전 정보
- Always disconnect power to the hot water tank before performing any service or maintenance.
- 누수를 방지하기 위해 모든 배관 연결부가 단단히 고정되었는지 확인하십시오.
- Near-boiling water can cause severe burns. Exercise caution when operating the hot water dispenser.
- Do not allow children to operate the hot water dispenser without supervision.
- 본 제품은 가정용으로만 사용하도록 제작되었습니다.
제품 구성 요소
The InSinkErator F-HC2200CRB faucet package typically includes:
- 수도꼭지 조립
- 급수관
- Flexible outlet tube
- Flexible vent tube
- 장착 하드웨어
Additional items required (sold separately):
- InSinkErator HWT-F1000S Hot Water Tank
- InSinkErator Water Filtration System (e.g., F-1000 or F-2000)
설정 및 설치
Installation of the InSinkErator F-HC2200CRB faucet involves mounting the faucet to your sink or countertop, connecting it to the hot water tank, and integrating it with your water supply and filtration system. Due to the complexity of plumbing and electrical connections, professional installation is recommended. Refer to the detailed installation guide provided with your InSinkErator hot water tank and faucet for complete step-by-step instructions.
그림 1: 전면 view of the InSinkErator F-HC2200CRB Antique Instant Hot and Cold Water Dispenser Faucet.
그림 2: 측면 view of the InSinkErator F-HC2200CRB faucet, showing the two levers for hot and cold water.
주요 설치 고려 사항:
- Countertop Hole: Ensure your sink or countertop has a standard faucet hole (typically 1-3/8 to 1-1/2 inches in diameter).
- 탱크 배치: The hot water tank should be installed under the sink, close to the faucet.
- 전기 콘센트: A grounded 115-volt, 3-prong electrical outlet is required for the hot water tank.
- 상수도: Connect to a cold water supply line with a shut-off valve.
작동 지침
Once properly installed and the hot water tank is heated (allow approximately 15-20 minutes for initial heating), your InSinkErator F-HC2200CRB faucet is ready for use.
뜨거운 물 추출:
- Locate the hot water lever (typically marked with red or on the left side).
- Push the hot water lever 뒤로 to activate the flow of near-boiling water.
- The hot water lever is designed to automatically shut off when released, preventing continuous flow for safety.
- Exercise extreme caution as the water dispensed is very hot.
냉수 분배:
- Locate the cold water lever (typically marked with blue or on the right side).
- Push the cold water lever 앞으로 to activate the flow of filtered cold water.
- The cold water lever is designed to stay on until manually turned off, allowing for continuous flow.
Figure 3: The faucet in use, dispensing hot water for instant meals.
Figure 4: The faucet can be used for various tasks, including warming baby bottles.
유지
Regular maintenance ensures optimal performance and longevity of your InSinkErator faucet.
청소:
- Clean the faucet exterior with a soft, damp cloth and mild soap. Avoid abrasive cleaners, polishes, or harsh chemicals, as these can damage the finish.
- For the Classic Oil Rubbed Bronze finish, gentle cleaning is recommended to preserve its appearance.
필터 교체:
The water filtration system (e.g., F-1000 or F-2000) connected to your hot water tank requires periodic filter replacement to maintain water quality and flow. Refer to your filter's specific instructions for replacement frequency, typically every 6-12 months depending on water usage and quality.
Figure 5: InSinkErator F-1000 and F-2000 water filters, essential for maintaining water quality.
Figure 6: The InSinkErator instant hot water tank, which supplies the hot water to the faucet.
문제 해결
If you encounter issues with your faucet, consult the following common troubleshooting steps. For more complex problems, refer to the full hot water tank manual or contact customer support.
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 뜨거운 물이 없습니다 | Hot water tank not plugged in or powered on; tank not heated; water supply valve closed. | Check power to the tank; allow 15-20 minutes for heating; ensure water supply valve is open. |
| Slow flow from faucet | Clogged filter; low water pressure. | Replace water filter; check household water pressure. |
| Water dripping after hot water shut-off | Normal residual drip due to expansion/contraction; minor internal component issue. | A few drops are normal. If dripping is continuous or excessive, contact customer support. |
| 찬물 없음 | Cold water supply valve closed; clogged filter. | Ensure cold water supply valve is open; replace water filter. |
명세서
| 특징 | 세부 사항 |
|---|---|
| 모델 번호 | F-HC2200-CRB |
| 색상 | Classic Oil Rubbed Bronze |
| 스타일 | 뜨겁고 차갑다 |
| 재료 | 놋쇠 |
| 품목 무게 | 6파운드 |
| 제품 치수 | 5.25 x 5.25 x 8 인치 |
| 핸들 수 | 2 |
| 전원 | Corded Electric (for tank, not faucet) |
| 인증 | 인증된 좌절 없는 |
보증 및 지원
보증 정보:
This InSinkErator faucet is backed by a 5-Year We Come To You In-Home Service Warranty. This warranty covers parts and labor for defects in materials or workmanship under normal use. Please retain your proof of purchase for warranty claims.
고객 지원:
For technical assistance, warranty service, or to purchase replacement parts, please contact InSinkErator customer support. Visit the official InSinkErator web최신 연락처 정보와 지원 리소스를 제공하는 사이트입니다.
온라인 리소스: www.insinkerator.com
