1. 서론
This manual provides detailed instructions for the installation, operation, and maintenance of your PROFLO PF9412FLPK Residential Toilet Manual Flush Valve. Designed for residential toilet systems, this flush valve ensures efficient and reliable water flow for proper flushing. Please read this manual thoroughly before beginning installation or use to ensure correct setup and optimal performance.
Figure 1: PROFLO PF9412FLPK Residential Toilet Manual Flush Valve.
2. 안전 정보
배관 설비를 설치하거나 수리할 때는 항상 기본적인 안전 수칙을 준수하십시오. 이러한 지침을 따르지 않을 경우 재산 피해나 부상을 입을 수 있습니다.
- 작업을 시작하기 전에 변기의 메인 급수 밸브를 잠그십시오.
- 장갑, 보안경 등 적절한 개인 보호 장비를 착용하세요.
- 모든 연결 부분이 안전하게 되어 누출을 방지하세요.
- 어떤 단계에 대해 확신이 없다면 자격을 갖춘 배관공에게 문의하세요.
- 이 제품에는 캘리포니아주에서 암과 선천적 기형 또는 기타 생식 기능 장애를 유발하는 것으로 알려진 화학 물질이 포함되어 있습니다(제안 65호 경고).
3. 패키지 내용
설치를 시작하기 전에 모든 구성 요소가 있는지 확인하십시오.
- PROFLO PF9412FLPK Residential Toilet Manual Flush Valve (1 unit)
- Associated installation hardware (gaskets, nuts, etc.)
그림 2: 예ample of flush valve components.
4. 설정 및 설치
Follow these steps for proper installation of the PROFLO PF9412FLPK flush valve. This valve is designed for easy replacement in compatible PROFLO toilet tanks.
- 화장실 준비하기: Turn off the water supply to the toilet at the shut-off valve. Flush the toilet to empty the tank. Use a sponge to remove any remaining water from the tank.
- 기존 주입 밸브를 제거하십시오. Disconnect the water supply line from the bottom of the old fill valve. Unscrew the mounting nut from the underside of the tank and remove the old fill valve.
- 새 주입 밸브를 설치하세요: Insert the new PROFLO PF9412FLPK flush valve into the hole at the bottom of the toilet tank. Ensure the rubber washer is correctly seated on the outside of the tank. Secure the valve with the mounting nut from underneath the tank, tightening it hand-tight plus a quarter turn with a wrench. Do not overtighten.
- Connect Refill Tube: Attach the refill tube from the fill valve to the overflow pipe of the flush valve. Ensure it is securely placed to direct water into the overflow pipe during tank refill.
- 물 공급 연결: Reconnect the water supply line to the bottom of the new fill valve. Hand-tighten, then use a wrench for a final snug turn.
- 물 공급 복구: Slowly turn on the water supply to the toilet. Check for any leaks around the connections. Allow the tank to fill.
- 수위 조절: The water level should be approximately 1 inch below the top of the overflow pipe. Adjust the fill valve as necessary to achieve the correct water level.
Note: Some users have reported initial difficulty with adjustment or potential leaks if not installed correctly. Ensure all components are properly seated and tightened.
5. 운영
The PROFLO PF9412FLPK is a manual flush valve designed for straightforward operation.
- 홍조: Press down the toilet handle firmly. This action lifts the flapper, allowing water from the tank to flow into the toilet bowl, initiating the flush cycle.
- 리필: Once the tank is empty, the flapper will close, and the fill valve will automatically begin refilling the tank to the preset water level. The refill tube directs a small amount of water into the bowl to replenish the trap seal.
Video 1: Demonstration of the PROFLO PF9412FLPK flush valve in operation, showing the flushing and refilling process within a toilet tank.
6. 유지관리
Regular maintenance helps ensure the longevity and efficient operation of your flush valve.
- 청소: Periodically inspect the flush valve for mineral buildup or debris. Clean with a soft brush and mild detergent if necessary. Avoid harsh chemicals that could damage components.
- 점검: Check the flapper and seals for wear or damage. A worn flapper can cause leaks and continuous running water. Replace components as needed.
- 수위: Ensure the water level remains at the recommended height (approximately 1 inch below the overflow pipe). Adjust the fill valve if the water level is too high or too low.
7. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 변기 물이 계속 흘러나옴 | Worn flapper, improper water level, debris under flapper. | Inspect and clean flapper. Adjust water level. Replace flapper if worn. |
| 약하거나 불완전한 물내림 | Low water level, clogged rim jets, flapper closing too quickly. | Adjust water level higher. Clean rim jets. Ensure flapper chain has proper slack. |
| 탱크 바닥에서 물이 새고 있습니다. | Loose mounting nut, damaged gasket, cracked tank. | Tighten mounting nut (do not overtighten). Inspect and replace gasket. If tank is cracked, professional repair or replacement is needed. |
| Fill valve not filling tank | Water supply off, clogged fill valve, float mechanism stuck. | Check water supply. Clean or replace fill valve. Ensure float moves freely. |
8. 사양
- 모델 번호: PF9412FLPK
- 상표: 프로필
- 재료: 놋쇠
- 입구 연결 유형: 미늘
- 콘센트 연결 유형: 미늘
- 포트 수 : 2
- 콘센트 연결 크기: 2 인치
- 품목 무게: 6.9 온스
- 패키지 크기: 17.8 x 4.25 x 4.25 인치
- 한국어: 781889183038
9. 보증 및 지원
The PROFLO PF9412FLPK Residential Toilet Manual Flush Valve is covered under PROFLO's limited warranty. For specific warranty details, please refer to the documentation included with your purchase or visit the official PROFLO web대지.
For technical assistance or customer support, please contact PROFLO Customer Service:
- 전화 번호: 800-221-3379
- Web대지: Visit the PROFLO Store on Amazon
