ACI 377140

ACI 377140 윈드실드 와셔 펌프 사용 설명서

모델: 377140

상표: 미국상공회의소(ACI)

1. 제품 오버view

The ACI 377140 Windshield Washer Pump is engineered to meet or exceed Original Equipment (OE) performance standards. This pump is designed for reliable and durable operation, ensuring effective windshield cleaning. It features an OE-style electrical connector and is equipped with three nozzles for efficient fluid delivery.

ACI 377140 Windshield Washer Pump

그림 1: ACI 377140 Windshield Washer Pump. This image shows the complete pump unit, including the main body, electrical connector at the top, and the fluid outlet with three nozzles at the bottom.

2. 제품 특징

3. 설치 가이드

Installation of the ACI 377140 Windshield Washer Pump typically involves replacing the existing pump. While the process can vary by vehicle model, the general steps are outlined below. It is recommended to consult your vehicle's service manual for specific instructions related to your make and model.

  1. 안전이 최우선입니다. Ensure the vehicle is turned off and the parking brake is engaged. Disconnect the negative terminal of the battery to prevent electrical hazards.
  2. Locate the Washer Reservoir: The windshield washer pump is usually located at the bottom of the windshield washer fluid reservoir. Access to the reservoir may require removing fender liners, bumper components, or other under-hood parts depending on the vehicle.
  3. 배액액: 가능하다면 펌프 분리 시 워셔액 유출을 최소화하기 위해 워셔액 저장통에서 워셔액을 빼내십시오.
  4. 전기 커넥터 분리: Carefully disconnect the electrical connector from the old pump.
  5. Remove Hoses: Disconnect the washer fluid hoses from the old pump. Be prepared for some fluid to leak out.
  6. 오래된 펌프 제거: The pump is typically held in place by a rubber grommet or a clip. Gently pull or unclip the old pump from the reservoir.
  7. 새 펌프 설치: Insert the new ACI 377140 pump into the reservoir opening, ensuring it seats firmly in the grommet.
  8. Reconnect Hoses and Electrical: Reattach the washer fluid hoses to the new pump and securely connect the electrical connector.
  9. 리필 저수조: Fill the washer fluid reservoir with appropriate windshield washer fluid.
  10. 테스트 작업: Reconnect the battery, turn on the vehicle, and test the windshield washer system to ensure proper function and check for leaks.

Note: Some vehicle designs may require significant disassembly of surrounding components to access the washer pump. Patience and proper tools are essential for a successful installation.

4. 사용 설명서

The ACI 377140 Windshield Washer Pump operates as part of your vehicle's existing windshield washer system. Once installed, its operation is integrated with your vehicle's controls.

Ensure the washer fluid reservoir is adequately filled for optimal performance.

5. 유지관리

The ACI 377140 Windshield Washer Pump is designed for durability and requires minimal direct maintenance. However, maintaining the overall windshield washer system will ensure the longevity and performance of the pump.

6. 문제 해결

If you experience issues with your windshield washer system after installing the ACI 377140 pump, consider the following troubleshooting steps:

문제가능한 원인해결책
No fluid sprays or weak spray
  • Low or empty fluid reservoir.
  • Clogged washer nozzles.
  • Kinked or disconnected hose.
  • Blown fuse for washer pump.
  • Faulty electrical connection to pump.
  • Pump motor issue (less likely if new).
  • Refill reservoir with appropriate fluid.
  • Clear nozzles with a fine pin.
  • Inspect and reattach/straighten hoses.
  • 차량 퓨즈 박스에서 해당 퓨즈를 점검하고 필요하면 교체하십시오.
  • Ensure electrical connector is securely attached to the pump.
  • If all else fails, consult a professional mechanic.
Fluid leaks around pump area
  • Improperly seated pump grommet.
  • 호스 연결이 느슨합니다.
  • Cracked reservoir or hose.
  • Ensure pump is fully seated in the reservoir grommet.
  • Check and tighten hose clamps or connections.
  • Inspect reservoir and hoses for damage; replace if necessary.
펌프가 작동하지만 유체가 없음
  • Empty reservoir.
  • 시스템에 공기가 있습니다.
  • Severe clog in line or nozzles.
  • 저수조를 다시 채우세요.
  • Run pump for a few seconds to prime the system.
  • Inspect and clear all lines and nozzles.

7. 사양

기인하다
제조업체미국상공회의소(ACI)
상표미국상공회의소(ACI)
품목 모델 번호377140
제조업체 부품 번호377140
품목 무게3.2 온스
제품 치수3.3 x 3.5 x 2.6 인치
ASINB00FAMAEP4
첫 번째 이용 가능 날짜18년 2013월 XNUMX일

8. 보증 및 지원

Specific warranty details for the ACI 377140 Windshield Washer Pump are typically provided at the point of purchase or can be found on the manufacturer's official web사이트. 보증 청구를 위해 구매 증빙 자료를 보관해 주세요.

For technical support, installation assistance, or warranty inquiries, please contact ACI customer service or the retailer from whom the product was purchased. Always refer to the official ACI resources for the most accurate and up-to-date information.