1. 서론
This instruction manual provides essential information for the proper installation, operation, and maintenance of your GROHE 28947000 Rough Plumbing Pipe-Fittings. Please read this manual thoroughly before beginning installation to ensure correct setup and to prevent damage or injury. Keep this manual for future reference.
For more information about GROHE products, please visit the official 그로헤 스토어.
2. 안전 정보
Always observe basic safety precautions when installing or maintaining plumbing fixtures. Failure to follow these instructions could result in property damage or personal injury.
- 설치 작업을 시작하기 전에 반드시 메인 급수 밸브를 잠그십시오.
- 보안경, 장갑 등 적절한 개인 보호 장비를 착용하십시오.
- 설치 과정의 어떤 부분이든 확실하지 않은 경우 자격을 갖춘 배관공에게 문의하세요.
- Do not use excessive force when tightening connections to avoid damaging components.
- 작은 부품은 어린이의 손이 닿지 않는 곳에 보관하세요.
3. 패키지 내용
설치를 시작하기 전에 모든 구성품이 있고 손상되지 않았는지 확인하십시오. 패키지에는 다음이 포함되어야 합니다.
- 1 x GROHE 28947000 Basin U-Bend (Odour trap)
- Associated seals and connection components
Image 1: GROHE 28947000 Rough Plumbing Pipe-Fitting. This image shows the main component of the pipe fitting, a basin U-bend, in a Starlight Chrome finish.
4. 설정 및 설치
This GROHE pipe fitting is designed to be compatible with all GROHE washbasins. Follow these general steps for installation. Specific basin configurations may require slight adjustments.
필요한 도구 (포함되지 않음):
- 조절 렌치 또는 파이프 렌치
- 배관공용 테이프(PTFE 테이프)
- Bucket or towel for catching residual water
설치 단계:
- 지역 준비: b로 가는 물 공급을 차단하세요asin. Place a bucket or towels under the existing drain to catch any water.
- Remove Old Fitting (if applicable): Carefully disconnect and remove the old pipe fitting. Clean the drain opening and connecting pipes thoroughly.
- Assemble the U-Bend: Apply plumber's tape to threaded connections if recommended by local plumbing codes or if a tighter seal is desired. Connect the U-bend components according to the radial style design, ensuring all seals are correctly seated.
- Connect to Basin 배수: Attach the top section of the U-bend to the basin's drain tailpiece. Hand-tighten first, then use a wrench for a snug fit, being careful not to overtighten.
- 벽면 배수구에 연결하세요: Connect the horizontal outlet of the U-bend to the wall drain pipe. Ensure a proper seal with the provided washers or gaskets.
- 정렬 확인: Verify that the entire assembly is properly aligned and level to ensure efficient drainage.
- 누출 테스트: Slowly turn on the water supply and check all connections for leaks. Run water through the basin for several minutes, observing closely. Tighten any leaking connections slightly until the leak stops.
5. 운영
Once installed, the GROHE 28947000 pipe fitting operates passively as part of your basin's drainage system. Its primary function is to create a water seal (U-bend) that prevents sewer gases from entering your living space while allowing wastewater to drain freely.
- Ensure water flows smoothly down the drain without gurgling or backing up.
- Periodically check for any signs of leakage around the connections.
6. 유지관리
Regular maintenance will help prolong the life and maintain the appearance of your GROHE pipe fitting.
- 청소: Wipe the Starlight Chrome finish with a soft, dry cloth. Avoid abrasive cleaners, scouring pads, or chemical agents that can damage the chrome plating.
- 점검: Periodically inspect the pipe fitting for any signs of corrosion, loose connections, or leaks. Address any issues promptly.
- 장애물 제거: If a blockage occurs, the U-bend can typically be unscrewed from the bottom for cleaning. Place a bucket underneath before opening to catch water and debris.
7. 문제 해결
If you encounter issues with your GROHE pipe fitting, refer to the following common problems and solutions:
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 연결 부위 누출 | Loose connections, damaged seals, incorrect installation of plumber's tape. | Tighten connections carefully. Inspect and replace damaged seals. Reapply plumber's tape if necessary. |
| 배수가 느리거나 막힘 | Accumulation of hair, soap scum, or debris in the U-bend or drain pipe. | Turn off water supply. Place a bucket under the U-bend. Unscrew the bottom of the U-bend to clear debris. Reassemble and test. |
| Sewer gas odor | U-bend is dry (water seal evaporated), or improper seal at connections. | b에 물을 흘려보내세요asin to refill the U-bend. Check all connections for leaks and ensure they are tight. |
8. 사양
| 상표 | 그로 헤 |
| 모델 번호 | 28947000 |
| 재료 | 스테인리스 스틸 |
| 색상 | GROHE CHROME (Starlight Chrome) |
| 스타일 | Odour trap (Basin U-Bend), Radial |
| 마감 유형 | 우아한 |
| 제품 크기(D x W x H) | 4.41"D x 7.95"W x 2.91"H (11.2cm D x 20.2cm W x 7.4cm H) |
| 품목 무게 | 0.34 킬로그램 |
| 설치 유형 | 언더 마운트 |
| 배수 유형 | Pop-Up (refers to compatible drain type, not the fitting itself) |
| 호환성 | Fits all GROHE washbasins |
9. 보증 및 지원
GROHE products are manufactured to the highest quality standards and are backed by a manufacturer's warranty. For specific warranty details, please refer to the documentation included with your purchase or visit the official GROHE web대지.
If you require technical assistance, have questions about installation, or need to report a defect, please contact GROHE customer support. Contact information can typically be found on the GROHE web사이트 또는 구매 영수증에서 확인하세요.
온라인 지원: 아마존의 GROHE 스토어를 방문하세요
