소개
This manual provides comprehensive instructions for the assembly, operation, and maintenance of your robbe Happy-Fly Electric Glider Assembly Kit 3157. Please read this manual thoroughly before beginning assembly or operation to ensure safe and correct usage. This product is an electric glider model designed for enthusiasts aged 14 years and older.
안전 정보
Always prioritize safety when assembling and operating your electric glider.
- 성인 감독: 본 제품은 14세 이상에게 권장됩니다. 14세 미만의 어린이는 반드시 보호자의 감독 하에 사용하시기 바랍니다.
- 집회: Follow all assembly instructions carefully. Incorrect assembly can lead to malfunction or injury.
- 배터리 안전: The product is battery-powered (batteries not included). Use only recommended battery types and follow all battery charging and handling safety guidelines. Do not short-circuit or expose batteries to extreme temperatures.
- 운영 환경: Operate the glider in open, clear areas away from people, animals, buildings, power lines, and other obstacles. Avoid flying in strong winds or adverse weather conditions.
- 비행 전 점검: 비행 전에는 항상 철저한 점검을 실시하여 모든 구성 요소가 단단히 부착되어 있고 올바르게 작동하는지 확인하십시오.
- 유지: Regularly inspect the glider for damage or wear. Do not operate a damaged glider.
- 장난감이 아님: While categorized as a toy, this is a sophisticated model aircraft requiring careful handling and operation.
패키지 내용
The robbe Happy-Fly Electric Glider Assembly Kit 3157 includes the following components:
- Glider airframe components (wings, fuselage, tail sections)
- Electric motor and propeller assembly
- Control surfaces (ailerons, rudder, elevator)
- Small parts bag (screws, connectors, pushrods, hinges)
- 취급 설명서(본 문서)
메모: Batteries, charger, and remote control are 포함되지 않음 별도로 구매해야 합니다.
설정 및 조립
Assembly of the Happy-Fly Electric Glider requires patience and attention to detail. Ensure you have a clean, well-lit workspace.
- 구성 요소 풀기: 모든 부품을 포장에서 조심스럽게 꺼내고 포장 내용물 목록과 비교하세요.
- 동체 조립: Assemble the fuselage sections according to the diagrams. Secure all joints with appropriate adhesive (not included, recommended type specified in diagrams).
- 날개 부착: Attach the wings to the fuselage. Ensure they are securely seated and aligned.
- 꼬리 부분 설치: Install the horizontal and vertical stabilizers. Pay close attention to alignment for proper flight characteristics.
- Motor and Propeller: Mount the electric motor securely in its designated position. Attach the propeller, ensuring it is balanced and facing the correct direction for thrust.
- Control Surface Linkages: Connect the pushrods from the servos (if applicable, or direct linkages) to the control surfaces (ailerons, rudder, elevator). Ensure free movement and correct throw.
- 전자 설치: Install your receiver, Electronic Speed Controller (ESC), and servos (if not pre-installed) into the fuselage. Secure wiring to prevent interference with moving parts.
- 배터리 칸: Ensure the battery compartment is accessible and secure for battery installation.
- 중심(CG): Crucially, balance the glider to achieve the recommended Center of Gravity (CG) as indicated in the assembly diagrams. This is vital for stable flight. Adjust battery position if necessary.
Figure 1: An assembled robbe Happy-Fly Electric Glider, showcasing its sleek white design with red "Happy-Fly" branding on the wings. The glider features a long, slender fuselage, broad wings, and a T-tail configuration, set against a clear blue background.
작동 지침
Once assembled and balanced, your Happy-Fly Electric Glider is ready for flight.
- 배터리 설치: Insert the fully charged flight battery into the designated compartment, ensuring it is secured and connected correctly to the ESC.
- 송신기 설정: Turn on your remote control transmitter first, then power on the glider's receiver. Ensure proper binding between the transmitter and receiver.
- 통제 점검: Before launch, verify that all control surfaces (ailerons, elevator, rudder) respond correctly to transmitter inputs. Check for full and free movement.
- 시작하다: For hand launch, hold the glider firmly and launch it into the wind with a gentle, level throw while applying throttle. For ground launch, ensure sufficient runway and apply throttle smoothly.
- 비행 제어:
- 엘리베이터: 기수(코)의 높이(위/아래)를 조절합니다.
- 키: 기수 좌우 회전(yaw)을 제어합니다.
- 에일러론: Controls roll (wing tilt), used for banking turns.
- 조절판: 모터 속도와 고도를 제어합니다.
- 활공: Once at desired altitude, reduce or cut throttle to enter gliding mode. Utilize thermals for extended flight.
- 착륙: Approach the landing area into the wind. Reduce throttle and gently guide the glider down, flaring just before touchdown to reduce speed.
- 비행 후: Disconnect the flight battery from the glider first, then turn off your transmitter. Inspect the glider for any damage.
유지
Regular maintenance will extend the lifespan and performance of your glider.
- 청소: 기체를 부드러운 천으로 닦으십시오.amp cloth after each flight to remove dirt and debris. Avoid harsh chemicals.
- 점검: Before and after each flight, inspect all components for cracks, dents, loose connections, or wear. Pay close attention to wings, tail, propeller, and control linkages.
- 프로펠러 점검: Ensure the propeller is free from nicks or cracks. A damaged propeller can cause vibrations and reduce efficiency. Replace if necessary.
- 배터리 관리 : Store batteries in a cool, dry place. Do not leave batteries fully charged or fully discharged for extended periods. Follow manufacturer guidelines for battery charging and storage.
- 저장: Store the glider in a safe place, away from direct sunlight, extreme temperatures, and moisture. Consider disassembling wings for compact storage if needed.
- 예비 부품: Keep essential spare parts on hand, such as propellers, control horns, and pushrods, for quick repairs.
문제 해결
이 섹션에서는 일반적으로 발생할 수 있는 문제에 대해 설명합니다.
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| Glider does not respond to controls. |
|
|
| Poor flight stability / difficult to control. |
|
|
| 모터가 회전하지 않거나 추진력이 약합니다. |
|
|
명세서
| 특징 | 세부 사항 |
|---|---|
| 상표 | 로베 |
| 모델명 | Happy-Fly Electric Glider (Bandit des phoques) |
| 모델 번호 | 229943 (Kit 3157) |
| 제품 유형 | Electric Glider Assembly Kit |
| 추천연령 | 14세 이상 |
| 주요소재 | 플라스틱 |
| 조립이 필요합니다 | 예 |
| 필요한 배터리 | Yes (Not included) |
| 원격 제어 포함 | 아니요 |
| 전원 | 배터리 구동 |
| 특징 | 전기 같은 |
| 만화 캐릭터 | Bandit des phoques (Seal Bandit) |
보증 및 지원
Information regarding specific warranty terms for the robbe Happy-Fly Electric Glider Assembly Kit 3157 is not provided in this manual. Please refer to the original product packaging or contact robbe customer support directly for warranty details and technical assistance.
For further support or to inquire about spare parts availability, please visit the official robbe web사이트를 방문하거나 현지 유통업체에 문의하세요.
제조업체: 로베 모델스포츠
제품 참조: 229943
