1. 제품 오버view
The Fantech FB 6 In-line Filter Box is designed to enhance indoor air quality by providing additional filtration within your HVAC ductwork. It is typically installed after an HRV (Heat Recovery Ventilator) or an inline fan to filter incoming air. This unit includes a MERV 13 filter for efficient particle removal.
그림 1: 외부 view of the Fantech FB 6 In-line Filter Box, showing the duct connection on the left and the access knob on the right.
2. 안전 정보
Please read all instructions carefully before installation and operation. Failure to follow these instructions may result in property damage, injury, or death.
- Ensure power to the HVAC system is disconnected before installation or maintenance.
- 설치 및 유지관리 시에는 적절한 개인 보호 장비(PPE)를 착용하세요.
- Consult a qualified HVAC professional for complex installations or if you are unsure about any steps.
- 부품이 손상되었거나 누락된 경우 제품을 작동하지 마십시오.
- Dispose of old filters according to local regulations.
3. 패키지 내용
설치를 시작하기 전에 모든 구성 요소가 있는지 확인하세요.
- Fantech FB 6 In-line Filter Box
- MERV 13 Filter (pre-installed or separate)
- 설치 가이드(본 설명서)
4. 설치 및 설정
4.1 설치 전 체크리스트
- Confirm duct size compatibility (6-inch duct).
- Ensure adequate space for installation and future filter replacement.
- Gather necessary tools (e.g., duct cutters, sealant, screwdriver).
4.2 설치 단계
- 위치 선택: Install the filter box in the ductwork after your HRV or inline fan, ensuring it is accessible for maintenance.
- 덕트 작업 준비: Cut a section of the existing 6-inch ductwork to accommodate the filter box. Ensure clean, straight cuts.
- Connect to Ductwork: Slide the filter box onto the prepared duct ends. Secure connections using appropriate duct clamps or screws and seal with HVAC-approved tape or mastic to prevent air leaks.
- Verify Filter Installation: Open the access panel (refer to Figure 2) and ensure the MERV 13 filter is correctly seated.
- 보안 액세스 패널: Close and secure the access panel using the provided knobs/screws.
그림 2: 내부 view of the Fantech FB 6 In-line Filter Box with the access panel open, revealing the MERV 13 filter angled inside.
5. 운영
The Fantech FB 6 In-line Filter Box operates passively as part of your ventilation system. Once installed, it continuously filters the air passing through it. No user interaction is required for its daily operation.
6. 유지관리
6.1 필터 교체
Regular filter replacement is crucial for maintaining optimal air quality and system performance. The frequency of replacement depends on usage and environmental conditions, but it is generally recommended every 3-6 months.
- 전원 분리: Ensure the HVAC system connected to the filter box is powered off at the circuit breaker.
- 접근 패널 열기: Loosen the knobs/screws on the access panel and carefully open it.
- 오래된 필터 제거: Gently slide out the old MERV 13 filter. Note its orientation for correct installation of the new filter.
- 새 필터 삽입: Slide a new MERV 13 filter into the filter box, ensuring it is properly seated and oriented.
- 액세스 패널 닫기: Close the access panel and tighten the knobs/screws securely.
- 복원력 : Turn the power back on to the HVAC system.
7. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| Condensation/Sweating on unit (in cold climates) | Insufficient insulation around the unit, especially when used for fresh air intake. | Apply additional insulation around the exterior of the filter box to prevent condensation. Ensure proper sealing. |
| Access panel screws spin freely / do not tighten | Internal riveted nut may have come loose or stripped. | Carefully inspect the internal nut. If loose, attempt to secure it. If stripped, consider using a different fastening method or contacting Fantech support. |
| Filter does not fit perfectly or seal properly | Screw heads or internal components obstructing filter path; incorrect filter size. | Ensure you are using the correct filter size (e.g., 20x20x1 if adapting). Carefully position the filter to avoid obstructions. |
8. 사양
| 특징 | 세부 사항 |
|---|---|
| 모델 번호 | FB 6 (CECOMINOD072653) |
| 제조업체 | 팬텍 |
| 덕트 크기 호환성 | 6인치 |
| 필터 유형 포함 | 메르브 13 |
| 품목 무게 | 10파운드(4.54kg) |
| 패키지 크기 | 26.9 x 15.1 x 13.1인치(68.3 x 38.4 x 33.3cm) |
| 재료 | 22-gauge galvanized steel with baked powder coat finish |
| 한국어: | 650737403041 |
9. 보증 및 지원
For warranty information and technical support, please refer to the official Fantech web사이트를 방문하거나 고객 서비스에 문의하세요.
You can visit the official Fantech store on Amazon for more products and information: FANTECH Store.
