소개
This manual provides essential instructions for the proper installation, operation, and maintenance of your Pentair Sta-Rite 25022-0201S Outer Replacement Module. This module is specifically designed for use with Pentair Sta-Rite System 3 SM-Series 21-inch pool and spa cartridge filter model S7M120. Adhering to these guidelines will ensure optimal performance and longevity of your filter system.
안전 정보
Always prioritize safety when working with pool equipment. Failure to follow safety instructions can result in serious injury or property damage.
- 전원 분리: Always turn off the pump and disconnect power to the filter system at the circuit breaker before performing any service or maintenance.
- 방출 압력: Before opening the filter housing, ensure all air pressure is released from the system. Refer to your main filter system manual for specific instructions on pressure release.
- 모든 지침 읽기: Read this entire manual and the main filter system manual before installation or service.
- 적절한 도구: Use appropriate tools for installation and removal to prevent damage to the filter or housing.
- 화학 물질 취급: If using cleaning chemicals, follow manufacturer instructions and wear appropriate personal protective equipment.
설정 및 설치
This section details the steps for replacing the outer filter module.
- Prepare the Filter System:
- Turn off the pool pump and disconnect power at the circuit breaker.
- Open the air relief valve on top of the filter to release any trapped air and pressure.
- Drain the filter tank by opening the drain plug at the bottom.
- Open the Filter Housing:
- cl을 제거하세요amp or locking mechanism securing the filter tank halves.
- Carefully lift the top half of the filter tank to expose the filter cartridges.
- Remove Old Outer Module:
- Locate the large outer cartridge. Gently lift and remove it from the filter manifold.
- Inspect the manifold and internal components for any debris or damage. Clean as necessary.
- Install New Outer Module:
- Carefully lower the new Sta-Rite 25022-0201S Outer Replacement Module onto the filter manifold. Ensure it seats properly and is aligned with the inner cartridge (if applicable).
- Verify that the module is securely in place and level.
- Close the Filter Housing:
- Replace the top half of the filter tank, ensuring the O-ring is clean and properly seated. Lubricate the O-ring with a silicone-based lubricant if needed.
- Secure the filter tank halves with the clamp or locking mechanism. Tighten according to the main filter system manual.
그림 1: The Sta-Rite 25022-0201S Outer Replacement Module, a cylindrical filter cartridge with pleated media, designed for pool and spa filtration systems. The top and bottom caps are black, and the pleated filter material is white, secured by two white bands.
작동 지침
After installation, follow these steps to resume filter operation:
- 여과조에 물을 채우세요: Close the filter drain plug. Open the air relief valve on top of the filter.
- 펌프 시작: Restore power to the pump at the circuit breaker and turn on the pump.
- 퍼지 공기: Allow the filter tank to fill with water. Once a steady stream of water (not air) emerges from the air relief valve, close the valve.
- 누출 확인: Inspect all connections and the filter tank for any signs of water leaks. Address any leaks immediately.
- 모니터 압력: Note the initial operating pressure on the filter gauge. This is your clean filter pressure. A rise of 8-10 PSI above this reading typically indicates that the filter needs cleaning.
유지
Regular maintenance is crucial for efficient filtration and extending the life of your filter module.
Cleaning the Filter Module
The filter module should be cleaned when the pressure gauge reads 8-10 PSI above the clean operating pressure, or if water flow to the pool/spa decreases significantly.
- 시스템 종료: Follow steps 1 and 2 from the 'Setup and Installation' section to safely shut down and open the filter housing.
- Remove Module: Carefully remove the outer filter module from the filter manifold.
- 헹구기: Use a garden hose with a spray nozzle to thoroughly rinse the pleated material. Spray from top to bottom, working between the pleats to dislodge debris. Do not use a high-pressure washer, as this can damage the filter media.
- 화학 세척(선택 사항): For stubborn dirt, oils, or calcium deposits, soak the module in a specialized filter cleaning solution according to the cleaner manufacturer's instructions. Always rinse thoroughly after chemical cleaning.
- 검사: While cleaning, inspect the filter media for tears, holes, or excessive wear. Check the end caps for cracks or damage.
- 재설치: Reinstall the cleaned module by following steps 4 and 5 from the 'Setup and Installation' section, then proceed with the 'Operating Instructions'.
교체 일정
The lifespan of a filter module varies depending on usage, water chemistry, and maintenance. Typically, filter modules should be replaced every 1-3 years, or sooner if visible damage or a persistent decrease in filtration efficiency is observed even after cleaning.
문제 해결
이 섹션에서는 일반적으로 발생할 수 있는 문제에 대해 설명합니다.
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 감소된 물 흐름 | Clogged filter module; Air in system; Pump issue | Clean or replace filter module; Purge air from system; Check pump for proper operation. |
| Cloudy Pool/Spa Water | Dirty or damaged filter module; Improper water chemistry | Clean or replace filter module; Test and adjust water chemistry (pH, alkalinity, sanitizer). |
| 필터 하우징에서 물이 새어 나옴 | Improperly seated O-ring; Damaged O-ring; Loose clamp | Inspect and clean O-ring, lubricate with silicone; Replace O-ring if damaged; Tighten clamp 안전하게. |
| High Filter Pressure | Clogged filter module | Clean or replace filter module. |
명세서
- 모델 번호: 25022-0201S
- 호환성: Pentair Sta-Rite System 3 SM-Series 21-inch pool and spa cartridge filter model S7M120
- 여과 면적: 200제곱 피트
- 치수(대략): 19 inches (Length) x 23 inches (Height) x 19 inches (Width)
- 제품 무게 (근사치): 25파운드
보증 및 지원
This Pentair product is covered by a manufacturer's warranty. For specific warranty details, please refer to the documentation included with your original filter system or visit the official Pentair website. For technical support, replacement parts, or further assistance, please contact Pentair customer service or your authorized Pentair dealer.
펜테어 고객 서비스: Refer to your original product packaging or the Pentair web최신 연락처 정보는 사이트에서 확인하세요.
