1. 서론
The MXR Distortion+ is a classic guitar effects pedal known for its distinctive distortion sounds. This compact unit is designed to deliver a range of tones from subtle overdrive to classic hard rock distortion. Its germanium-powered, soft-clipped distortion circuit has been a staple on countless recordings, offering a unique sonic character.
주요 특징:
- Germanium-powered, soft-clipped distortion
- Classic 70s distortion
- Classic early ’80s hard rock tone
- 컴팩트하고 내구성 있는 디자인
2. 설정
Before connecting your MXR Distortion+ pedal, ensure your amplifier is turned off. This prevents any potential damage to your equipment.
사이:
- 기타를 연결하십시오. 입력 페달 오른쪽 측면에 있는 잭에 표준 1/4인치 악기 케이블을 사용하여 연결합니다.
- 연결하다 산출 페달 왼쪽의 잭을 당신의 것에 연결하세요 amp앰프 입력단에 다른 1/4인치 계측기 케이블을 사용합니다.
페달에 전원 공급:
The MXR Distortion+ can be powered by a 9V battery or an optional 9V DC power adapter (center negative).
- 배터리 설치: To install a 9V battery, remove the bottom plate of the pedal by unscrewing the four screws. Connect the battery to the clip and place it inside the enclosure before reattaching the bottom plate.
- 전원 어댑터: Connect a 9V DC power adapter (not included) to the power jack on the side of the pedal.
이미지: 측면 view of the MXR Distortion+ pedal, highlighting the input, output, and 9V power jacks.
이미지: 하단 view of the MXR Distortion+ pedal, showing the four screws that secure the battery compartment.
3. 컨트롤
The MXR Distortion+ features two primary control knobs and a footswitch for activation.
이미지: 상단 view of the MXR Distortion+ pedal, clearly showing the 'Output' and 'Distortion' control knobs.
- 산출: This knob controls the overall output volume of the effect. Turn clockwise to increase volume, counter-clockwise to decrease.
- 왜곡: This knob adjusts the amount of distortion applied to your signal. Turn clockwise for more distortion, counter-clockwise for less.
- 풋스위치: 효과를 켜거나 끕니다. 효과가 활성화되면 LED가 켜집니다.
4. 운영
The MXR Distortion+ is straightforward to operate, allowing you to quickly dial in a variety of distorted tones.
- Classic Blues Tones: Set the DISTORTION control low (e.g., 9 o'clock to 12 o'clock) and adjust the OUTPUT knob to drive the front end of your amplifier. This will produce a warm, overdriven blues tone.
- Early '80s Hard Rock: Max out the DISTORTION knob (e.g., 3 o'clock to full clockwise) for a powerful, saturated hard rock tone. Adjust OUTPUT to match your desired volume.
- Subtle Boost/Overdrive: For a cleaner boost with a touch of grit, set DISTORTION very low and OUTPUT to unity gain or slightly above.
Demonstration Videos (for related MXR pedals):
Video: MXR Custom Badass Modified Overdrive, 78 Distortion M77, M78. This video demonstrates the sound of related MXR distortion and overdrive pedals.
Video: MXR Sugar Drive Pedal M294. This video demonstrates the sound of a related MXR overdrive pedal.
5. 사양
| 모델 번호 | M104 |
| 품목 무게 | 1 파운드 |
| 제품 치수 | 5.5인치 길이 x 2.5인치 너비 x 4.5인치 높이 |
| 본체 소재 | Germanium, Plastic |
| 색상 | 노란색 |
| 전원 | 배터리 작동식 (9V 배터리 1개 필요) |
| 권tage | 9.0V |
| 신호 형식 | 비슷한 물건 |
| 커넥터 유형 | 1/4인치 오디오 |
6. 유지관리
- 청소: 페달을 닦을 때는 부드럽고 마른 천을 사용하십시오. 연마성 세척제나 용제는 사용하지 마십시오.
- 저장: 페달은 건조하고 온도 변화가 심한 곳이나 직사광선을 피해 보관하십시오.
- 배터리 수명: If using a battery, disconnect the input cable when not in use to conserve battery life. Remove the battery if the pedal will not be used for an extended period.
7. 문제 해결
- 소리 없음:
- 모든 케이블 연결 상태를 확인하십시오 (기타와 입력 단자, 출력 단자 등). amp).
- Ensure the pedal is receiving power (check battery or power adapter).
- 기타를 확인하고 amplifier가 정상적으로 작동하고 있습니다.
- 소리가 약하거나 왜곡되는 현상(예상치 못한 경우):
- Replace the 9V battery if it's low.
- Ensure the power adapter meets the 9V DC (center negative) specification.
- Adjust the OUTPUT and DISTORTION knobs to find your desired tone.
8. 보증 및 지원
This product is covered by the manufacturer's warranty. For detailed warranty information or technical support, please refer to the official MXR web사이트를 방문하거나 고객 서비스에 직접 문의하세요. 보증 청구를 위해 구매 증빙 자료를 보관하세요.
