Magic Lantern APP 사용 설명서

Based on the Magic Lantern APP manual and common troubleshooting for these LED controllers, here are the steps to address the blinking issue:

• Check the Mode: 난amp may have been set to a "Flash" or "Jump" mode within the app. Open the Magic Lantern app, go to the 스타일 or 방법 interface (as shown in section 3.2, step 6), and select a static color or "Auto Play" to see if the blinking stops.
• 전원 주기: Since you mentioned it blinks even when disconnected, it is likely that residual power in the capacitors or the controller's memory is maintaining the last state. Unplug the lamp from the power source for at least 30 seconds before plugging it back in.
• 연결을 확인하세요. Ensure the LED strip is securely connected to the controller. A loose connection can sometimes cause flickering or blinking.
• App Reset: Open the app, go to the Lamp 목록 (section 3.2, step 4), and ensure the device is properly connected via Bluetooth. You can try deleting the device from the list and letting the app auto-search to reconnect it.
• 밝기 및 색상: You noted the white light is pale; this is common for RGB strips that create white by mixing colors. In the 조정하다 interface, ensure the brightness slider is set to maximum.

l이면amp continues to blink rapidly while disconnected from power, there may be a hardware defect in the controller or power adapter of your specific double pack unit.

The Magic Lantern app provides several ways to customize colors if a specific preset like RWB is not immediately visible in the standard list. Based on the manual, you can try the following to achieve your desired combination:

• Modify Pin Sequence: Go to the "Modify Pin Sequence" interface (Step 10 in the manual). This allows you to manually set and reorder the 빨간색, 녹색, 그리고 파란색 light outputs.
• Manual RGB Adjustment: Use the "RGB manual adjustment view" (Step 5) to precisely input color values. While the app supports 60,000 colors, specific multi-color patterns are often found under the 스타일 or 방법 인터페이스.
• Pattern Classification: In the Mode interface (Step 6), you can slide up and down through various categories like "Basic," "Curtain," and "Trans" to find multi-color flashing sequences.

If a dedicated RWB "patriotic" mode is missing from the preset list, it may be a limitation of the current software version, but you can often simulate it using the manual RGB settings or by cycling through the available multi-color jump/flash modes.

예, 사용할 수 있습니다 Magic Lantern app on your tablet to turn your device on and off. The app is designed specifically to replace traditional control methods like infrared remotes.

To control your device using the app, follow these steps:

• 다운로드 및 설치: Ensure you have the "Magic Lantern" app installed on your tablet (available for Android 4.3+ and iOS 8.0+).
• 블루투스 활성화: Open the app and click [허용하다] when prompted to enable Bluetooth.
• 연결하다: Keep your light device powered on. The app should automatically search for and connect to your LED controller via Bluetooth. You can view the connection status by clicking the Lamp 목록 icon (the list icon in the top left).
• 전원 제어 : 연결되면 다음으로 이동하세요. Color and Brightness interface. You will find a Lamp 스위치 버튼 (a toggle switch icon) in the top right corner of the screen. Tapping this will turn your light on or off.

Additionally, the app allows you to set 타이밍 schedules to automatically turn the lights on or off at specific times, which can be found in the "Schedule" tab at the bottom of the interface.