Futaba DLPH-3 10-channel Dual Receiver Connection Power Hub User Manual

1. 서론

The Futaba DLPH-3 is a compact and robust 10-channel dual receiver connection power hub designed to enhance the reliability and power distribution in RC aircraft, particularly for 50-70cc models. It features a dual Rx link system, allowing for the connection of two receivers and two batteries, providing critical redundancy and safety. The integrated electronic switch utilizes a FET circuit for efficient current control, and a telemetry function provides real-time power supply voltage monitoring. Its design also ensures compatibility with various battery types, incorporating protection mechanisms for safe operation.

2. 패키지 내용

짐을 풀 때 다음 품목이 모두 있는지 확인하세요.

• Futaba DLPH-3 Dual Receiver Connection Power Hub
• Switch/receiver connection cords (x3)
• Gyro connection cords (x3)
• Flange damper
• 구멍
• 나무나사

3. 설정 및 연결

The DLPH-3 is designed for straightforward installation. Refer to the diagram below for port identification and connection points.

3.1 Connecting Receivers

• Connect your primary receiver to the RX1 포트.
• Connect your secondary receiver to the RX2 포트.
• The DLPH-3 operates as a dual Rx link system, providing redundancy.

3.2 배터리 연결하기

• The DLPH-3 features an XT60 커넥터 for battery input.
• It is designed to connect two batteries for enhanced power supply and safety.
• Ensure batteries are compatible and correctly polarized before connection. The system includes protection for connecting different types of batteries, but it is always best practice to use matched batteries where possible.

3.3 Servo and S.BUS2 Connections

• Connect your servos to the designated servo ports (1-10) on the left side of the unit.
• 그만큼 CH3 port is available for specific channel output.
• 활용하다 에스버스2 port for S.BUS2 compatible devices, allowing for advanced telemetry and control.

3.4 장착

Use the provided flange damper, eyelets, and wood screws to securely mount the DLPH-3 within your aircraft. Ensure it is placed in a location that is protected from vibrations and potential damage, and allows for adequate airflow if needed.

4. 사용 설명서

Once all connections are made and verified, the DLPH-3 operates as an electronic switch, managing power distribution to your receivers and servos.

• 전원 켜기: Connect your batteries to the XT60 connector. The internal electronic switch will activate, providing power to the connected components.
• 상태 표시기 : Observe the LEDs for RX1 and RX2 (as shown in Figure 2) to confirm proper receiver connection and status.
• 원격 측정 : The DLPH-3 features a telemetry function that displays the power supply voltage. This information can be accessed via your compatible Futaba S.BUS2 telemetry system, allowing you to monitor battery health during flight.

5. 유지관리

To ensure the longevity and reliable performance of your Futaba DLPH-3, follow these general maintenance guidelines:

• Keep the unit clean and free from dust, dirt, and moisture.
• Regularly inspect all connections for signs of wear, corrosion, or looseness.
• 장시간 극한의 온도나 직사광선에 장치를 노출시키지 마십시오.
• c를 열려고 시도하지 마십시오.asing or modify the internal circuitry, as this will void the warranty and may cause damage.

6. 문제 해결

If you encounter issues with your DLPH-3, consider the following troubleshooting steps:

• 전원 없음: Check battery connections, ensure batteries are charged, and verify the XT60 connector is fully seated.
• 수신기가 응답하지 않습니다: Confirm both receivers are correctly connected to RX1 and RX2 ports and are bound to your transmitter. Check the status LEDs on the DLPH-3 for receiver activity.
• 간헐적 작동: Inspect all servo and S.BUS2 connections for secure fit. Ensure no wires are pinched or damaged.
• 원격 측정 문제: Verify your S.BUS2 telemetry system is correctly configured and compatible with the DLPH-3.

If problems persist after these checks, contact Futaba customer support or your authorized dealer.

7. 사양

8. 보증 및 지원

For warranty information, technical support, or service inquiries, please contact your authorized Futaba dealer or visit the official Futaba web사이트. 보증 청구를 위해 구매 증빙 자료를 보관하세요.