JEAREY 9FT Outdoor Patio Umbrella with Solar LED Lights

1. 서론

Thank you for choosing the JEAREY 9FT Outdoor Patio Umbrella with Solar LED Lights. This manual provides essential information for the safe assembly, operation, and maintenance of your new patio umbrella. Please read these instructions carefully before use and retain them for future reference.

2. 안전 정보

• 우산을 단단히 고정하세요: A weighted base is NOT included and is REQUIRED for safe use. Ensure the umbrella is securely anchored to prevent tipping or blowing away.
• 바람 상태: Always close the umbrella during windy conditions or when not in use to prevent damage and ensure safety.
• 태양광 패널: The solar panel is designed for outdoor use. Ensure the plug connection is secure before initial use.
• 정리: Maintain adequate clearance around the umbrella when opening, closing, or tilting to avoid obstructions or injury.
• 어린이와 애완동물: 우산을 사용하는 동안 어린이와 애완동물이 우산에 가까이 가지 않도록 하십시오.

3. 패키지 내용

조립을 시작하기 전에 모든 구성 요소가 있는지 확인하세요.

• Umbrella Canopy with integrated LED lights
• Upper Pole Section (with crank mechanism)
• 하부 기둥 섹션
• Solar Panel (pre-attached or separate for connection)

4. 설정

1. Attach Lower Pole: Insert the lower pole section into your weighted umbrella base (not included). Tighten any securing knobs on the base to hold the pole firmly.
2. 기둥 부분 조립: Carefully insert the upper pole section (with the canopy attached) into the lower pole section. Ensure the spring button clicks into place, securing the two sections.
3. 태양광 패널 연결: If the solar panel is not pre-attached, follow the steps below to connect it. Ensure the plug connection is firm.

Image: This image shows the four steps for installing the solar panel: preparing components, connecting wires, aligning the bayonet, and screwing the solar panel into place.

5. 사용 설명서

5.1. 우산 펼치고 접기

1. 열려면: Turn the hand-crank clockwise until the canopy is fully extended and taut.
2. 닫기: Turn the hand-crank counter-clockwise until the canopy is fully retracted. Secure the canopy with the sewn-in Velcro straps.

Image: The umbrella is equipped with an easy crank system for opening and closing, and an air vent at the top to promote airflow and stability.

5.2. Tilting the Umbrella

The umbrella features a push-button tilt mechanism for adjustable shade.

1. 기울이려면: Locate the push-button on the umbrella pole. Press the button and gently push the canopy in the desired direction to tilt it.
2. 똑바로 세우려면: Press the push-button and gently push the canopy back to its vertical position.

Image: A closer look at the push-button mechanism on the umbrella pole, which controls the tilt function.

5.3. Using the Solar LED Lights

The umbrella is equipped with 32 solar-powered LED lights for nighttime illumination.

1. 충전 중: The built-in solar panel on top of the umbrella charges the LED lights during daylight hours. Ensure the solar panel is exposed to direct sunlight for optimal charging.
2. 조명 활성화: Locate the ON/OFF switch on the umbrella pole. Flip the switch to the 'ON' position to activate the LED lights.
3. Deactivating Lights: Flip the switch to the 'OFF' position to turn off the LED lights.

Image: This image illustrates the umbrella's appearance during the day, providing shade, and at night, with its 32 solar-powered LED lights illuminated.

6. 유지관리

• 청소: Wipe the umbrella canopy and pole with a damp cloth. For stubborn dirt, use a mild soap solution and rinse thoroughly. Allow to air dry completely before closing or storing.
• 저장: When not in use for extended periods, especially during winter or severe weather, close the umbrella and secure it with the Velcro straps. Store the umbrella in a dry, protected area to prolong its lifespan.
• 점검: Periodically inspect the umbrella for any signs of wear, tear, or damage to the fabric, ribs, pole, or solar components.

7. 문제 해결

• 불이 작동하지 않음:
  • Ensure the ON/OFF switch on the pole is in the 'ON' position.
  • Check the solar panel connection by unscrewing the panel and verifying the plug.
  • Allow the solar panel to charge in direct sunlight for at least 6-8 hours.
• Crank Mechanism Stiff:
  • Ensure no fabric or debris is obstructing the mechanism.
  • Apply a silicone-based lubricant to moving parts if necessary.
• Umbrella Not Tilting:
  • Ensure the push-button is fully depressed when attempting to tilt.
  • Check for any obstructions around the tilting joint.

8. 사양

9. 보증 및 지원

For warranty information or technical support, please refer to the product packaging or contact JEAREY customer service directly. Keep your purchase receipt for warranty claims.