Ciays 43-Inch Rectangular Propane Fire Pit with Windshield User Manual

1. 서론

This manual provides essential information for the safe assembly, operation, and maintenance of your Ciays 43-Inch Rectangular Propane Fire Pit. Please read all instructions carefully before using the product to ensure proper function and safety.

Image 1.1: Ciays 43-Inch Rectangular Propane Fire Pit with windshield and protective cover.

2. 중요한 안전 정보

경고: 이 지침을 따르지 않을 경우 화재, 폭발 또는 일산화탄소 중독이 발생하여 재산 피해, 부상 또는 사망에 이를 수 있습니다.

• Always maintain a safe distance from the fire pit to combustible materials.
• Use only approved fuel types (Liquefied Petroleum Gas).
• Keep children and pets away from the fire pit when in use.
• Always extinguish the fire before leaving or going to sleep.
• Store the fire pit in a cool, dry place when not in use.
• 이 기기나 다른 기기 근처에서 가솔린이나 기타 가연성 증기 및 액체를 보관하거나 사용하지 마십시오.
• 사용 목적으로 연결되지 않은 LP 실린더는 이 기기나 다른 기기 근처에 보관해서는 안 됩니다.
• 실외에서만 사용하십시오. 실내에서는 사용하지 마세요.
• 조립 및 작동 전에 모든 지침을 읽으십시오.

3. 패키지 내용

Verify that all components are present before beginning assembly. If any parts are missing or damaged, do not attempt to assemble or operate the fire pit. Contact customer service for assistance.

• Fire Pit Table Unit
• 304 Stainless Steel H-Burner (pre-installed)
• Glass Stones (for burner area)
• Transparent Wind Guard (glass panels and corner brackets)
• Protective Cover (for tabletop)
• Ignition Battery (AAA or AA, typically included)
• 하드웨어 팩 (나사, 와셔, 너트)
• 사용 설명서

4. 조립 설명서

Assembly typically requires two people and takes approximately 60-90 minutes. Tools required: Phillips head screwdriver, adjustable wrench (not included).

1. 구성 요소 풀기: 모든 부품을 포장에서 조심스럽게 꺼내세요. 긁힘을 방지하기 위해 부드럽고 깨끗한 표면에 놓으세요.
2. 기본 구조 조립: Follow the diagrams in the included paper manual to connect the side panels and base frame. Ensure all screws are tightened securely.
3. 테이블탑 부착: Carefully place the tabletop onto the assembled base. Secure it using the provided hardware.
4. Install Propane Tank Holder: If not pre-installed, secure the propane tank retention screw or strap inside the cabinet.
5. 가스 배관 연결: Connect the gas hose from the burner to the control valve, then to the propane tank regulator. Ensure all connections are hand-tight, then use a wrench for a final snug fit. Do not overtighten.
6. Place Glass Stones: Distribute the glass stones evenly over the burner area, ensuring not to block the igniter or burner holes.
7. Assemble Wind Guard: Attach the glass panels to the corner brackets using the provided hardware. Place the assembled wind guard around the burner opening.
8. Install Ignition Battery: Insert the specified battery (e.g., AAA) into the igniter button compartment.

Image 4.1: The fire pit features a spacious 43-inch top and a cabinet for a standard 20 lb propane tank (not included).

5. 사용 설명서

5.1. 프로판 탱크 연결

1. 화덕의 조절 손잡이가 "OFF" 위치에 있는지 확인하십시오.
2. Open the cabinet door and place a standard 20 lb propane tank upright inside.
3. Connect the regulator hose to the propane tank valve. Turn the black coupling nut clockwise until fully tightened.
4. Secure the propane tank using the internal retention mechanism.
5. Perform a leak test: Apply a soapy water solution to all gas connections. Open the propane tank valve. If bubbles appear, there is a leak. Close the tank valve immediately and re-tighten connections. Repeat until no bubbles are present. Do not operate if a leak persists.

5.2. 화덕에 불 붙이기

1. 프로판 탱크 밸브가 완전히 열려 있는지 확인하세요.
2. Push and hold the control knob in, then slowly turn it to the "LOW" position.
3. While holding the control knob in, press and hold the igniter button repeatedly until the burner ignites.
4. Once ignited, continue to hold the control knob in for 15-20 seconds to allow the thermocouple to heat up.
5. Release the control knob. If the flame extinguishes, repeat steps 2-4.

5.3. 불꽃 조절하기

The fire pit features an infinite adjustment knob, allowing precise control over flame height and heat output.

• To increase flame height and heat, slowly turn the control knob towards the "HIGH" position.
• To decrease flame height and heat, slowly turn the control knob towards the "LOW" position.

Image 5.1: The stepless adjustment switch allows for precise control of flame intensity.

5.4. Turning Off the Fire Pit

1. 조절 손잡이를 "OFF" 위치로 돌리십시오.
2. Close the valve on the propane tank by turning it clockwise until fully closed.
3. 화덕이 완전히 식을 때까지 덮거나 옮기지 마십시오.

6. 유지관리

6.1. 청소

• 외부 표면: Wipe with a soft cloth and mild soapy water. Rinse thoroughly and dry completely. Do not use abrasive cleaners or solvents.
• 연소기: Periodically inspect the burner for obstructions (e.g., spider webs, debris). Use a soft brush to clean burner ports.
• Glass Stones: The glass stones can be rinsed with water and allowed to dry before being placed back in the fire pit.
• 바람막이: Clean glass panels with a glass cleaner and a soft cloth.

6.2. 보관

• Always ensure the fire pit is completely cool before covering or storing.
• Use the included protective cover to shield the fire pit from weather elements when not in use.
• Store the fire pit in a cool, dry location, away from direct sunlight and moisture.
• Disconnect the propane tank and store it in a well-ventilated area outdoors, away from heat sources and open flames.

7. 문제 해결

If you encounter issues with your fire pit, refer to the following common problems and solutions:

8. 사양

• 상표: 시아이스
• 모델 번호: CIFPT53B-43-US
• 제품 크기: 43인치 깊이 x 25인치 너비 x 25인치 높이
• 재료: 합금강
• 마감 유형 : 래커칠
• 모양: 직사각형
• 품목 무게: 63.93 파운드
• 연료 유형: Liquefied Petroleum Gas (LP Gas)
• 열 출력 : 60,000비티유
• 색상: 검은색
• 한국어: 810158829602

9. 보증 및 지원

For warranty information or technical support, please refer to the contact details provided with your purchase documentation or visit the official Ciays web사이트. 보증 청구에 대비해 구매 증빙 자료로 구매 영수증을 보관하세요.