Ciays 32인치 프로판 가스 화덕 사용 설명서

중요한 안전 정보

Please read and understand all safety warnings and instructions before assembling, operating, or servicing this fire pit. Failure to follow these instructions could result in fire, explosion, property damage, personal injury, or death.

• 실외에서만 사용하십시오. 실내 또는 밀폐된 공간에서 사용하지 마십시오.
• Keep clear of combustible materials. Maintain a minimum clearance of 36 inches (91 cm) from the top and sides to any combustible construction.
• 이 기기나 다른 기기 근처에서 가솔린이나 기타 가연성 증기 및 액체를 보관하거나 사용하지 마십시오.
• 프로판 가스통은 항상 실외에서 연결하고 분리하십시오.
• 화덕을 사용할 때는 절대로 자리를 비우지 마십시오.
• Ensure all connections are tight and leak-free before operation. Perform a leak test with soapy water as instructed in the setup section.
• 어린이와 애완동물을 화덕 가까이 두지 마십시오.
• 화덕의 일부가 물에 잠긴 경우 사용하지 마십시오.
• 화덕을 옮기거나 보관하기 전에 완전히 식히십시오.

패키지 내용

Before beginning assembly, ensure all parts are present and undamaged. If any parts are missing or damaged, do not attempt to assemble the product. Contact customer service for assistance.

Image: All components of the fire pit table laid out, including the main table top, side panels, door panel, cylinder holder, and lava rocks.

• Table Top with Burner (A)
• Door Panel Frame (B)
• Back Panel (C)
• Side Panels (D) - 2 pieces
• Cylinder Holder (E)
• Lava Rocks (G)
• Top Lid (H)
• Hardware Pack (Bolts AA, Control Knob DD, Battery EE)

설치 및 조립 지침

It is highly recommended to assemble the fire pit table using the unfolded box or another soft surface to avoid scratching the tabletop during installation.

1. 베이스 준비: Place the main table top (A) upside down on a soft, clean surface to prevent scratches.
2. Attach Door Panel Frame: Attach the door panel frame (B) to the side of the table top that has the control knob shaft. Secure it with bolts (AA).
3. 뒷면 패널 부착: Attach the back panel (C) to the opposite side of the table top. Align holes and secure with bolts (AA).
4. 측면 패널 부착: Attach the two side panels (D) to complete the enclosure. Secure them with bolts (AA).
5. Install Cylinder Holder: Attach the cylinder holder (E) inside the fire pit base using bolts (AA).
6. 문 설치: Insert the bottom pivot of the door into the bottom hole. Then, pull the upper pivot down and align it with the upper hole. Release and fit the upper pivot into the hole to secure the door.
7. 프로판 탱크 연결: Place a standard 20lb propane tank (not included) into the cylinder holder (E). Connect the hose and regulator to the propane cylinder. Tighten the cylinder locking bolt to secure the propane cylinder.
   

   Image: Proper connection of the propane tank to the fire pit's regulator.
8. 배터리 설치 : Attach the control knob (DD). Remove the plastic cap from the igniter. Slide the battery (EE) into the battery slot. Attach and tighten the plastic cap.
9. Add Lava Rocks: Pour the lava rocks (G) into the burner area of the table top. Distribute them evenly around the burner.
   

   이미지: 클로즈업 view of the lava rocks in the burner area and the external control knob.

10. 누출 테스트: Before first use and after every cylinder change, perform a leak test. Apply soapy water to all gas connections. Open the propane cylinder valve. If no bubbles appear, the connection is secure. If bubbles appear, tighten the connection and retest. Do not use the fire pit if a leak is detected.

작동 지침

Ensure the area around the fire pit is clear of any flammable materials before lighting.

1. Prepare for Lighting: Ensure the control knob is in the "OFF" position. Open the valve on the propane cylinder.
2. 버너에 불을 붙이기: Push and turn the control knob to the "ON" position while simultaneously pressing the igniter button repeatedly until the burner ignites.
3. 화염 조절: Once ignited, continue to hold the control knob for 10-15 seconds to allow the thermocouple to heat up. Release the knob. You can then rotate the control knob to adjust the flame height from low to high.
4. 끄기: To turn off the fire pit, turn the control knob to the "OFF" position. Close the valve on the propane cylinder. Allow the unit to cool before covering or storing.

Image: The Ciays 32 Inch Propane Fire Pit in operation, displaying a vibrant flame.

유지

• 청소: Regularly clean the exterior surfaces with a mild soap and water solution. Rinse thoroughly and dry completely. Do not use abrasive cleaners or harsh chemicals.
• 용암 바위: The lava rocks may accumulate soot over time. They can be cleaned by rinsing with water and allowing them to dry completely before reuse. Replace any cracked or broken lava rocks.
• 저장: When not in use, especially during extended periods or inclement weather, cover the fire pit with the provided top lid (H) or a weather-resistant cover. Store the propane cylinder in a well-ventilated area, away from direct sunlight and heat sources.
• 점검: Periodically inspect the hose and connections for any signs of wear, cuts, or leaks. Replace if necessary.

문제 해결

If you encounter issues with your fire pit, refer to the table below for common problems and solutions.

이러한 해결 방법을 시도한 후에도 문제가 지속되면 고객 지원팀에 문의하세요.

명세서

Image: Dimensional diagram of the fire pit table, indicating key measurements.

보증 및 지원

For warranty information or technical support, please refer to the product packaging or contact Ciays customer service directly. Keep your purchase receipt for warranty claims.

For additional resources, you may refer to the official Installation Manual (PDF) available at: https://manuals.plus/m/c734cd11bac333aac9e0c81a00307b110939b49a283da0641ad324e27cf8de44