CREWORKS DUC-1003-00

CREWORKS 3L Ultrasonic Cleaner User Manual

Model: DUC-1003-00 | Brand: CREWORKS

소개

This manual provides detailed instructions for the safe and efficient operation, maintenance, and troubleshooting of your CREWORKS 3L Ultrasonic Cleaner. Please read this manual thoroughly before initial use and retain it for future reference.

안전 예방 조치

  • 장치를 분해하지 마십시오.
  • Do not use flammable or corrosive liquids.
  • Always use sufficient fluid to cover items.
  • Unplug before filling & draining.
  • 장치가 안정적이고 평평한 표면에 놓여 있는지 확인하십시오.
  • 어린이의 손이 닿지 않는 곳에 보관하세요.
CREWORKS 3L Ultrasonic Cleaner with digital display and open lid

Figure 1: CREWORKS 3L Ultrasonic Cleaner with its digital control panel and open lid, showcasing the stainless steel tank.

상자 안에 무엇이 들어있나요?

포장을 풀 때 모든 구성 요소가 들어 있고 손상되지 않았는지 확인하세요.

  • 초음파 세척기 1대
  • 1 x Stainless Steel Basket
  • 1 X 전원 코드
  • 1 x 사용자 매뉴얼(이 문서)

설정

  1. 놓기: Place the ultrasonic cleaner on a firm, level, and dry surface, away from direct sunlight and heat sources. Ensure adequate ventilation around the unit.
  2. 전원 연결: Connect the power cord to the unit and then to a grounded electrical outlet. Ensure the power switch on the back of the unit is in the OFF position before plugging in.
  3. 탱크 채우기: Open the lid and fill the stainless steel tank with an appropriate cleaning solution. The liquid level should be between the MIN and MAX marks, ensuring items to be cleaned are fully submerged but not overflowing. Do not operate the unit without liquid in the tank.
  4. 품목 삽입: Place items to be cleaned into the stainless steel basket. Lower the basket gently into the tank. Avoid direct contact of items with the tank bottom to ensure optimal cavitation.
CREWORKS 3L Ultrasonic Cleaner control panel showing temperature and timer settings

Figure 2: Close-up of the intuitive digital control panel, displaying temperature and timer settings for easy operation.

작동 지침

  1. 전원 켜기: Flip the main power switch located on the back of the unit to the ON position. The digital display will illuminate.
  2. 설정 온도: Press the "TEMP" button to adjust the desired cleaning solution temperature. Use the up/down arrows to set the temperature between 68°F and 176°F (20°C and 80°C). The unit will begin heating automatically.
  3. 타이머 설정 : Press the "TIME" button to adjust the desired cleaning duration. Use the up/down arrows to set the timer for up to 30 minutes.
  4. 청소 시작: Once temperature and time are set, the ultrasonic cleaning process will begin. The display will show the remaining time.
  5. 작동 중: The unit will produce a slight humming sound and visible cavitation bubbles. This is normal. Avoid touching the tank or solution during operation.
  6. 사이클 종료: 타이머가 0에 도달하면 장치가 자동으로 멈춥니다.
  7. 항목 제거: Carefully lift the basket out of the tank. Rinse the cleaned items under clean water and dry them thoroughly.
Diagram illustrating the ultrasonic cavitation process: formation, expansion, and bursting of bubbles for cleaning.

Figure 3: Illustration of the powerful ultrasonic cavitation process, where 40 kHz frequency sound waves create microscopic bubbles that implode, effectively cleaning intricate surfaces.

Before and after images showing cleaned glasses, razor, and circuit board using the ultrasonic cleaner.

Figure 4: Visual comparison demonstrating the effective cleaning results on various items, including eyeglasses, a razor, and a circuit board.

유지

  • 탱크 배수: After each use, especially if the solution is dirty, unplug the unit and drain the liquid using the built-in drain valve. Tilt the unit slightly towards the drain for complete emptying.
  • 탱크 청소: 스테인리스 스틸 탱크를 깨끗한 물로 헹구십시오. 부드러운 천으로 제품의 내부와 외부를 닦으십시오.amp 천으로 닦아주세요. 연마성 세제를 사용하거나 본체를 물에 담그지 마세요.
  • 저장: 사용하지 않을 때는 서늘하고 건조한 곳에 보관하십시오. 보관하기 전에 탱크가 완전히 건조되었는지 확인하십시오.
  • 퓨즈 교체: In case of power issues, check the fuse located near the power inlet. Replace with a fuse of the same rating if necessary. (Note: Refer to the product's electrical specifications for fuse type and rating).
Images showing the stainless steel basin, noise-reducing cover, and non-skid rubber feet of the ultrasonic cleaner.

Figure 5: Key design features contributing to durability and stable operation, including the robust stainless steel basin, noise-reducing cover, and non-skid rubber feet.

문제 해결

문제가능한 원인해결책
장치의 전원이 켜지지 않습니다.전원 코드가 연결되지 않았습니다. 전원 스위치가 꺼져 있습니다. 퓨즈가 끊어졌습니다.Ensure power cord is securely plugged in; Turn power switch ON; Check and replace fuse if necessary.
No ultrasonic sound/cavitation.Insufficient liquid; Unit not started; Malfunction.Ensure liquid level is adequate; Press start button; Contact customer support if problem persists.
세척 결과가 좋지 않음.Incorrect cleaning solution; Insufficient cleaning time; Overloaded tank; Items touching tank bottom.Use appropriate cleaning solution for items; Increase cleaning time; Do not overload; Use basket to suspend items.
난방 기능이 작동하지 않습니다.Temperature not set; Heater malfunction.Set desired temperature using the control panel; Contact customer support if problem persists.

명세서

특징세부 사항
모델 번호DUC-1003-00
탱크 용량3L(0.8갤런)
초음파 파워120와트
가열 전력100와트
초음파 주파수40kHz
온도 범위68-176°F(20-80°C)
타이머 범위1-30분
탱크 소재식품 등급 304 스테인리스 스틸
제품 치수13.5 x 7.6 x 11.81 인치
품목 무게7.41 파운드
Diagram showing the dimensions of the CREWORKS 3L Ultrasonic Cleaner and its internal basket.

Figure 6: Detailed dimensions of the ultrasonic cleaner unit and its removable cleaning basket.

보증 및 지원

CREWORKS stands behind the quality of its products. This ultrasonic cleaner comes with a 1-Year Promise문의사항, 기술 지원 또는 보증 청구 관련 사항은 당사로 연락주시기 바랍니다. 24/7 고객 서비스. Refer to the product packaging or the official CREWORKS web연락처 정보 사이트.

For more information and support, visit the official CREWORKS Store: CREWORKS Store on Amazon.

© 2024 CREWORKS. 모든 권리 보유.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.