소개
This manual provides essential information for the proper setup, operation, and maintenance of your HAIBOXING 2.4GHz Radio Transmitter, model 12670-2.4G. This transmitter is designed for use with HAIBOXING RC car models 16889, 903, 905, and 2995. Please read this manual thoroughly before use to ensure optimal performance and safety.
상자 안에 무엇이 들어있나요?
- One (1) Radio Transmitter (Model 12670-2.4G)
Note: Additional components such as receivers, ESCs, motors, and batteries are typically sold separately or included with the RC vehicle.
제품 끝view
The HAIBOXING 2.4GHz Radio Transmitter provides reliable control for your compatible RC vehicles. It features a pistol-grip design with various controls for precise operation.
이미지 설명: 자세한 view of the HAIBOXING 2.4GHz Radio Transmitter, highlighting its key components such as the Steering Trim, Power ON/OFF switch, Steering Direction Reverse Switch, Throttle Limiter, Control Wheel, Trigger, and AUX. Button. The image also indicates "RTR Ready to Run", "2.4GHz Proportional Control", and "280 feet Control Range".
설정 및 바인딩
To establish communication between your transmitter and receiver, follow these binding instructions. Ensure all components are powered off before starting.
바인딩 절차
- 수신기를 전원(예: BEC가 내장된 ESC 또는 별도의 수신기 배터리)에 연결하십시오.
- Power on the receiver. The LED on the receiver should flash, indicating it is in binding mode.
- 송신기의 전원을 켭니다.
- Locate the "BIND" button on the receiver. Press and hold the "BIND" button for approximately 3 seconds.
- Observe the LED on the receiver. Once the LED changes from fast flashing to a solid light, the binding process is complete.
- Verify binding by connecting a servo to Channel 1 on the receiver and turning the steering wheel on the transmitter. The servo should respond.
비디오 설명: This video demonstrates the binding method for a DUMBORC X4 Radio Transmitter with an X6F Receiver. It shows how to power on the receiver, then the transmitter, and then press the bind button on the receiver until the LED light becomes solid, indicating successful binding. A servo is then connected to verify the binding.
비디오 설명: This video provides a connection schematic diagram for a 4-channel RC Transmitter with a Receiver, showing how to connect the various components like the ESC, motor, servo, and battery to the receiver and transmitter for proper operation and binding.
송신기 작동
The 2.4GHz Radio Transmitter features several adjustable controls to fine-tune your RC vehicle's performance.
- Steering Trim (ST/TRIM): Adjusts the neutral position of the steering. Use this to make the vehicle drive straight when the steering wheel is centered.
- Throttle Trim (TH/TRIM): Adjusts the neutral position of the throttle. Use this to ensure the vehicle remains stationary when the throttle trigger is released.
- Steering Dual Rate (ST D/R): 최대 조향각을 조절합니다.
- Throttle Dual Rate (TH D/R): Adjusts the maximum throttle output.
- Steering Direction Reverse Switch (ST DIR): 조향 방향을 반대로 합니다.
- Throttle Direction Reverse Switch (TH DIR): 스로틀 방향을 반대로 합니다.
- 방아쇠: 전진/후진 움직임과 속도를 제어합니다.
- 컨트롤 휠: Controls left/right steering.
- 전원 켜기/끄기: 송신기를 켜거나 끕니다.
- LED 표시등: Shows the power and binding status.
문제 해결
If you encounter issues with your HAIBOXING 2.4GHz Radio Transmitter, refer to the following common troubleshooting steps:
Throttle or Steering Not Responding
- 바인딩 확인: Ensure the transmitter and receiver are properly bound. Refer to the "Setup and Binding" section.
- Adjust Throttle Trim (TH/TRIM): If the steering works but the throttle does not, adjust the TH/TRIM knob to the neutral (center) position. The ESC may not recognize the throttle input if the trim is off-center.
- Adjust Throttle Dual Rate (TH D/R): If the motor does not respond or moves slowly, adjust the TH D/R to its maximum value.
- Adjust Steering Dual Rate (ST D/R): If there is no steering response, adjust the ST D/R to its maximum value.
- ESC 보정: If the issue persists, check the Electronic Speed Controller (ESC). Calibrate it and ensure it is in the correct two-way working mode.
비디오 설명: This video addresses common issues where the throttle or steering may not work on an RC vehicle. It demonstrates how to adjust the throttle sub-trim and throttle dual rate (TH D/R) on the transmitter to resolve these problems, ensuring the ESC recognizes the throttle input and the motor responds correctly.
명세서
| 특징 | 세부 사항 |
|---|---|
| 예비 부품 번호 | 12670-2.4G |
| 품목 이름 | 무선 송신기 |
| 호환성 | HAIBOXING RC Car Models: 16889, 903, 905, 2995 |
| 제품 치수 | 10 x 5 x 7 인치 |
| 품목 무게 | 6.7 온스 |
| 제조업체 권장 연령 | 14세 이상 |
유지
To ensure the longevity and optimal performance of your HAIBOXING 2.4GHz Radio Transmitter, follow these general maintenance guidelines:
- Keep the transmitter clean and free from dust, dirt, and moisture. Use a soft, dry cloth for cleaning.
- 송신기를 극한 온도나 직사광선에 장시간 노출시키지 마십시오.
- 장기간 사용하지 않을 경우 누출을 방지하기 위해 송신기에서 배터리를 제거하세요.
- 송신기를 물리적 손상을 방지하기 위해 안전한 장소에 보관하십시오.
보증 및 지원
Specific warranty information for the HAIBOXING 2.4GHz Radio Transmitter (Model 12670-2.4G) is not provided in this document. For detailed warranty terms, technical support, or replacement parts, please refer to the official HAIBOXING web사이트에서 확인하거나 고객 서비스에 직접 문의하세요. 구매 증빙 자료로 구매 영수증을 보관하세요.
You can visit the official HAIBOXING store for more products and support: HAIBOXING Store
