Maxxima MRL-S40905

Maxxima 4 in. 5 CCT Ultra Thin Recessed LED Downlight Instruction Manual

모델: MRL-S40905

소개

This manual provides detailed instructions for the safe installation, operation, and maintenance of your Maxxima 4-inch 5 CCT Ultra Thin Recessed LED Downlight. Please read all instructions carefully before installation and retain this manual for future reference.

Maxxima 4-inch 5 CCT Ultra Thin Recessed LED Downlight

이미지: 앞면 view of the Maxxima 4-inch 5 CCT Ultra Thin Recessed LED Downlight.

안전 정보

화재, 감전 또는 부상의 위험을 줄이기 위해 다음 안전 수칙을 준수해 주십시오.

  • 설치 또는 유지 보수 작업을 시작하기 전에 항상 회로 차단기에서 전원을 차단하십시오.
  • 모든 전기 연결은 지역 규정 및 조례는 물론 국가 전기 규격(NEC)을 준수해야 합니다.
  • 배선에 대해 확실하지 않은 경우 자격을 갖춘 전기 기술자에게 문의하십시오.
  • 작동 온도가 제품의 정격 온도를 초과하는 장소에는 설치하지 마십시오.
  • 이 조명기구는 d에 적합합니다.amp locations and is IC Rated, meaning it is safe for direct contact with insulation.
  • 설비를 개조하거나 원래 용도 이외의 목적으로 사용하지 마십시오.

패키지 내용

설치를 시작하기 전에 모든 구성 요소가 있는지 확인하세요.

  • 1 x Maxxima 4 in. 5 CCT Ultra Thin Recessed LED Downlight
  • 1 x Junction Box (J-Box) with integrated power supply
  • 장착 하드웨어

명세서

특징사양
모델 번호MRL-S40905
크기4 인치
왓tage10W (60W 백열전구와 동일)
루멘 출력750루멘
색온도(CCT)색온도 선택 가능: 2700K, 3000K, 3500K, 4000K, 5000K
권tage120VAC
밝기 조절 가능Yes (20% - 100% with compatible LED dimmer)
크리82
재료알류미늄
설치 유형매립형, 캔리스
인증IC Rated, ETL Listed
접속함 치수높이 1.4인치 x 너비 2.7인치 x 깊이 4.11인치
정착물 차원4.8” Diameter x 0.87” Thickness

설정 및 설치

올바른 설치를 위해 다음 단계를 따르세요.

  1. 전원 끄기: Before starting any electrical work, ensure the power supply to the installation area is turned off at the circuit breaker.
  2. 천장 개구부 준비: 원하는 위치에 지름 15cm(4인치)의 구멍을 천장에 뚫으세요. 장선이나 배관과 같은 장애물이 없는지 확인하십시오.
  3. 배선 연결: Open the junction box cover. Connect the supply wires to the wires inside the junction box using the provided wire nuts:
    • Connect the black wire from the supply to the black wire of the J-Box.
    • Connect the white wire from the supply to the white wire of the J-Box.
    • Connect the ground wire from the supply to the green wire of the J-Box.
    Secure the junction box cover.
  4. Maxxima LED Downlight with J-Box

    Image: The LED downlight connected to its junction box.

  5. 색온도(CCT)를 선택하세요: Before inserting the light into the ceiling, locate the CCT selection switch on the side of the junction box. Choose your desired color temperature (2700K, 3000K, 3500K, 4000K, or 5000K) by sliding the switch.
  6. Close-up of CCT selection switch on J-Box

    이미지: 클로즈업 view of the CCT selection switch located on the side of the junction box.

  7. 접속 박스를 삽입하세요: Place the wired junction box into the ceiling opening.
  8. 다운라이트 설치: Connect the downlight to the junction box via the male/female connector. Push the spring clips on the sides of the downlight upwards and insert the fixture into the ceiling hole. The clips will automatically secure the light in place.
  9. 옆 view of downlight with spring clips

    이미지: 측면 view of the downlight showing the tension spring clips used for installation.

  10. 복원력 : 회로 차단기를 다시 켜세요.

작동 지침

색온도 선택

The Maxxima 4-inch LED Downlight features 5 CCT (Correlated Color Temperature) options, allowing you to customize the light output to your preference. The selection switch is located on the side of the junction box.

  • 2700K: Soft White (Warm, inviting light)
  • 3000K: Warm White (Slightly brighter, still warm)
  • 3500K: Bright White (Neutral, balanced light)
  • 4000K: Neutral White (Cooler, more energetic light)
  • 5000K: Daylight (Brightest, closest to natural daylight)

To change the CCT, you must access the junction box. It is recommended to select your preferred CCT before final installation into the ceiling. If changing after installation, ensure power is off before accessing the J-Box.

Diagram showing 5 CCT options

Image: Visual representation of the five selectable color temperatures.

디밍 기능

This LED downlight is dimmable from 20% to 100% when used with a compatible LED dimmer switch. Ensure your dimmer switch is rated for LED lighting to prevent flickering or damage to the fixture.

유지

The Maxxima LED Downlight requires minimal maintenance.

  • 청소: 청소하기 전에 전원이 꺼져 있는지 확인하십시오. 부드럽고 마른 천이나 약간 젖은 천으로 조명 기구를 닦으십시오.amp 천을 사용하십시오. 연마성 세척제나 용제를 사용하지 마십시오. 마감재나 전기 부품이 손상될 수 있습니다.
  • 사용자가 수리할 수 없는 부품: LED 광원은 일체형으로 교체할 수 없습니다. 제품을 열거나 수리하려고 시도하지 마십시오.

문제 해결

If you encounter issues with your downlight, refer to the following table:

문제가능한 원인해결책
불이 켜지지 않습니다전원 공급이 없습니다
느슨한 배선 연결
스위치 또는 회로 차단기 고장
Check circuit breaker and wall switch. Ensure all wiring connections are secure. Test with a known working fixture or consult an electrician.
조명이 부적절하게 깜빡이거나 어두워집니다.호환되지 않는 디머 스위치
느슨한 배선
Ensure an LED-compatible dimmer is used. Check wiring connections.
잘못된 색온도CCT 스위치 설정이 잘못되었습니다Turn off power, access the junction box, and adjust the CCT selection switch to the desired setting.

보증

This Maxxima LED Downlight is covered by a 3년 보증 from the date of purchase. This warranty covers defects in materials and workmanship under normal use. For warranty claims or further details, please contact Maxxima customer support.

고객 지원

For technical assistance, troubleshooting, or warranty inquiries, please contact Maxxima customer support. Refer to the product packaging or the official Maxxima web최신 연락처 정보는 사이트에서 확인하세요.

Please have your model number (MRL-S40905) and date of purchase available when contacting support.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.