SmartHeart 01-539WR
SmartHeart Automatic Blood Pressure Monitor
Model: 01-539WR
중요한 안전 정보
Please read this instruction manual thoroughly before using your SmartHeart Blood Pressure Monitor. Keep this manual for future reference.
- 질병이 있는 경우 이 기기를 사용하기 전에 의사와 상담하세요.
- 건강 문제나 질병의 진단이나 치료를 위해 이 장치를 사용하지 마십시오.
- Measurements taken with this device are for reference only. Always consult a healthcare professional for interpretation of results.
- 어린이의 손이 닿지 않는 곳에 보관하세요.
- 장치를 분해하거나 수리하려고하지 마십시오.
- 승인된 액세서리 및 부품만 사용하십시오.
패키지 내용
- SmartHeart Automatic Blood Pressure Monitor Unit
- Wide-Range Arm Cuff (fits arm circumference 8.6 in. - 16.5 in. / 22 cm - 42 cm)
- 사용 설명서
- 보관 가방
제품 끝view
혈압계의 구성 요소를 숙지하십시오.

그림 1: SmartHeart Automatic Blood Pressure Monitor with its wide-range arm cuff and storage bag. The monitor features a large digital display and two buttons: MEM and START.

그림 2: 상세한 view of the monitor's display. It shows systolic (SYS), diastolic (DIA) pressure in mmHg, and pulse rate per minute. A hypertension indicator is visible on the left side of the screen.

그림 3: Intelligent Inflation Technology. This feature uses previous measurement history to determine the optimal inflation level, resulting in faster and more comfortable readings.

그림 4: Wide-Range Arm Cuff details. The cuff fits arm circumferences from 8.6 to 16.5 inches (22-42 cm), features a traditional D-ring style, soft fabric, and hook & loop closure for a comfortable fit. It is not made with natural rubber latex.
설정
1. 배터리 설치
Open the battery compartment cover on the back of the unit. Insert four (4) AA alkaline batteries, ensuring correct polarity (+/-). Close the cover securely.
2. 팔 커프 연결하기
팔 커프의 공기 튜브 커넥터를 모니터 장치 왼쪽의 공기 잭에 단단히 삽입합니다.
3. Setting Date and Time (if applicable)
Refer to the specific instructions in your manual for setting the date and time, usually involving pressing the 'MEM' button in a specific sequence while the unit is off or in setup mode.
작동 지침
측정 준비
- 측정 최소 30분 전에는 음식 섭취, 음주, 흡연 또는 운동을 삼가십시오.
- 측정하기 전에 최소 5분간 휴식을 취하세요.
- 등을 받치고 발을 바닥에 짚은 채 똑바로 앉으세요.
- 팔을 평평한 곳에 놓고 커프가 심장 높이에 오도록 하세요.
- 커프는 옷 위가 아닌 맨살에 직접 착용해야 합니다.
암 커프 적용
- 왼팔을 커프 고리에 끼우세요. 공기 튜브는 팔 안쪽으로 지나가야 합니다.
- Position the cuff so the bottom edge is approximately 1 inch (2-3 cm) above your elbow.
- Wrap the cuff snugly around your arm, securing it with the hook and loop fastener. Ensure it is not too tight or too loose.
측정하기
- With the cuff correctly applied and the unit connected, press the 시작 단추.
- 커프가 자동으로 팽창합니다. 측정하는 동안 움직이지 말고 조용히 계십시오.
- 측정이 완료되면 커프의 공기가 빠지고 수축기 혈압, 이완기 혈압 및 맥박수가 화면에 표시됩니다.
- The unit will automatically store the reading in its memory.
- 를 누르세요 시작 button again to turn off the unit, or it will automatically shut off after 1 minute of inactivity.
메모리 기능
The SmartHeart monitor stores previous readings for easy review.
View저장된 판독값 가져오기
- From the OFF state, press the 멤 단추.
- 가장 최근 측정값이 먼저 표시됩니다.
- 를 누르세요 멤 button repeatedly to scroll through older readings.
- The unit will display the average of the last three readings (if available) before showing individual readings.
메모리 지우기
To clear all stored readings, press and hold the 멤 button for approximately 5 seconds while in memory recall mode until "CLR" or "---" appears on the display, indicating memory has been cleared.
유지 보수 및 관리
- Clean the monitor unit and cuff with a soft, dry cloth. Do not use abrasive cleaners or immerse in water.
- Store the unit in its storage bag in a cool, dry place, away from direct sunlight and extreme temperatures.
- 장기간 사용하지 않을 경우 배터리 누출을 방지하기 위해 배터리를 제거하세요.
- Do not drop or subject the unit to strong impacts.
- Regularly check the air tube and cuff for any signs of damage or wear.
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 전원을 켜도 화면이 표시되지 않습니다. | 배터리가 소진되었거나 잘못 삽입되었습니다. | 배터리를 새 배터리로 교체하고 극성이 올바른지 확인하세요. |
| "E1" or "Err" displayed. | Cuff not applied correctly or movement during measurement. | Reapply cuff snugly. Remain still and silent during measurement. |
| 일관성 없는 판독값. | Improper measurement technique, stress, or environmental factors. | Ensure proper preparation and technique (see Operating Instructions). Take multiple readings over time. Consult a physician if concerns persist. |
| 커프가 팽창하지 않습니다. | Air tube not connected properly or leak in cuff/tube. | Check air tube connection. Inspect cuff and tube for damage. |
명세서
- 모델: 01-539WR
- 측정 방법: 오실로 메트릭
- 측정 범위:
- 압력: 0-300mmHg
- 맥박수: 40~199회/분
- 정확성:
- 압력 : ± 3 mmHg
- 펄스: 판독값의 ±5%
- 커프 크기 : Wide-Range Arm Cuff (fits arm circumference 8.6 in. - 16.5 in. / 22 cm - 42 cm)
- 메모리: 최대 99개의 판독값 저장
- 전원: AA 배터리 4개(포함되지 않음)
- 자동 차단 : Approximately 1 minute after last operation
- 작동 조건: 50°F - 104°F (10°C - 40°C), 15-90% RH non-condensing
- 보관 조건: -4°F - 140°F (-20°C - 60°C), 10-95% RH non-condensing
- 무게: 약 8온스(배터리 제외)
- 제조업체: 베리디안 헬스케어
- 한국어: 845717009201
보증 및 지원
SmartHeart products are manufactured to strict quality standards. For warranty information or technical support, please refer to the contact details provided on the product packaging or visit the official SmartHeart web사이트. 보증 청구를 위해 구매 증빙 자료로 구매 영수증을 보관하세요.
참고: 보증 조건은 지역에 따라 다를 수 있습니다.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.