소개
구매해주셔서 감사합니다asing the YABER YA30 Jump Starter with Air Compressor. This device is designed to provide emergency jump-starting for vehicles, inflate tires, and serve as a portable power bank. Please read this manual thoroughly before use to ensure safe and optimal operation. Keep this manual for future reference.
제품 끝view
The YABER YA30 combines multiple essential functions into one compact device:
- 점프 스타터: Powerful 3000A peak current for 12V vehicles (all gasoline engines, up to 8.0L diesel engines).
- 공기 압축기: Built-in inflator with a maximum pressure of 150 PSI, capable of inflating a tire in approximately 3 minutes. Features pressure preset and auto-stop functions.
- 휴대용 보조 배터리: 24800mAh capacity with two fast-charging USB output ports for electronic devices.
- DC 전원 출력: 100W (12V/10A) output for powering various 12V car appliances.
- LED 조명: 360-degree rotatable LED light with three modes: illumination, strobe, and SOS signal.
Image: YABER YA30 device highlighting its jump-starting and air compressor capabilities, suitable for various vehicle types.
안전 지침
Always adhere to the following safety guidelines to prevent injury or damage to the device and vehicle:
- Ensure the device is fully charged before use, especially for jump-starting.
- 얼어붙은 배터리를 점프 스타트하려고 하지 마세요.
- Do not use the device if the smart clamp cable or the device itself is damaged.
- 어린이의 손이 닿지 않는 곳에 보관하세요.
- 장시간 극한의 온도나 직사광선에 기기를 노출시키지 마세요.
- 스마트 클amp cable features eight protection functions: low voltag전자, 높은 볼륨tage, reverse connection, short circuit, multi-frequency, standby display, reverse charge, and high temperature protection. These features are designed to protect both the jump starter and your car battery.
Image: Smart clamp cables with integrated safety features for secure operation.
작동 지침
1. 차량 점프 스타트
- Ensure the jump starter is sufficiently charged.
- 빨간색 cl을 연결하세요amp 자동차 배터리의 양극(+) 단자에 연결하세요.
- 검은색 cl을 연결하세요amp 자동차 배터리의 음극(-) 단자에 연결하세요.
- 스마트 CL 플러그amp cable into the jump starter's port.
- 차량의 엔진을 시동하십시오.
- Once the engine starts, disconnect the smart clamp cable from the jump starter, then remove the clamp자동차 배터리에서 나온 것입니다.
2. 에어 컴프레서 사용
- 공기 호스를 타이어 밸브에 연결합니다.
- Turn on the air compressor function on the device. The LCD display will show the current tire pressure.
- Use the '+' and '-' buttons to set the desired pressure (units can be switched between PSI, BAR, kPa, kg/cm²).
- 시작 버튼을 눌러 공기 주입을 시작하세요. 설정된 압력에 도달하면 컴프레서가 자동으로 멈춥니다.
Image: The YABER YA30 inflating a car tire, demonstrating its air compressor function.
3. Mobile Power Bank Function
- Connect your smartphone, tablet, or other USB-powered devices to the USB output ports (USB1-OUT, USB2-OUT) using a compatible charging cable.
- The device will automatically begin charging. The 24800mAh capacity and fast-charging ports allow for quick replenishment of your devices.
Image: The YABER YA30 functioning as a mobile power bank, charging multiple devices.
4. DC Power Output
- Connect the included DC cigarette lighter adapter to the DC output port (DC-OUT) of the jump starter.
- Plug your 12V car appliances (e.g., car refrigerator, handheld vacuum cleaner, dash cam) into the cigarette lighter adapter.
- The device provides a rated output of 100W (12V/10A).
5. LED 조명 사용
- Press the 'On/Off Light' button to cycle through the LED light modes: steady illumination, strobe, and SOS signal.
- The LED light can be rotated 360 degrees to adjust the angle for optimal illumination during nighttime operations or emergencies.
Image: The YABER YA30's 360-degree rotatable LED light providing illumination in a camp시나리오.
유지
- 충전 중: 배터리 수명 유지를 위해 사용하지 않을 때에도 3~6개월에 한 번씩 기기를 충전하십시오.
- 저장: 직사광선과 습기가 없는 서늘하고 건조한 곳에 장치를 보관하십시오.
- 청소: 부드럽고 마른 천을 사용하여 기기를 닦으세요. 강한 화학 물질이나 연마성 세제는 사용하지 마세요.
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 장치가 켜지지 않습니다. | 배터리 부족 또는 기기 오작동. | Charge the device. If it still doesn't turn on, contact support. |
| Vehicle does not jump-start. | 잘못된 clamp connection, low device battery, or severely damaged car battery. | 확인 CLamp connections (red to +, black to -). Ensure jump starter is fully charged. If car battery is severely damaged, it may need replacement. |
| 공기압축기가 작동하지 않습니다. | Hose not properly connected, incorrect pressure setting, or device malfunction. | Ensure hose is securely attached. Verify pressure setting. Check device battery level. |
| 스마트 CLamp shows error. | Reverse connection, short circuit, or other protection triggered. | Review safety instructions and ensure correct connection. Disconnect and reconnect clamps. |
명세서
| 특징 | 사양 |
|---|---|
| 상표 | 야 베르 |
| 모델 번호 | YA30 |
| 배터리 유형 | 리튬 이온 |
| 권tage | 12 볼트 |
| 배터리 용량 | 24800mAh |
| 피크 전류 | 3000 Amps |
| 호환 차량 유형 | 12V Cars, Gasoline Cars, Diesel Cars (up to 8.0L) |
| 공기 압축기 최대 압력 | 150파운드 |
| DC 출력 | 12V/10A(100와트) |
| 제품 무게 | 2.74 킬로그램 |
제품 비디오 끝view
비디오: 오버view of the YABER YA30 Jump Starter with Air Compressor, showcasing its design, features, and various applications including jump-starting vehicles, inflating tires, and charging devices.
보증 및 지원
YABER provides quality assurance for this product. Should you encounter any issues during use, please do not hesitate to contact us via email. We are committed to ensuring your satisfaction and will provide appropriate support. Please give us the opportunity to assist you.
For support, please refer to the contact information provided with your purchase or visit the official YABER web대지.