HAIBOXING 7.4V 1600mAh Li-Po Battery (Model T2119)

소개

This instruction manual provides essential information for the safe and effective use of your HAIBOXING 7.4V 1600mAh Soft Pack Li-Po Battery, Model T2119. This battery is designed as an original spare part, 100% applicable for HAIBOXING 1/12 Scale RC Cars including models HBX 2995, 905, 903, and 903A. Please read this manual thoroughly before use to ensure optimal performance and safety.

안전 정보

Lithium Polymer (Li-Po) batteries require careful handling. Failure to follow these safety guidelines can result in fire, personal injury, and property damage.

• 충전 중: Always use a Li-Po compatible charger. Never leave charging batteries unattended. Charge on a non-flammable surface away from flammable materials.
• 저장: Store Li-Po batteries in a cool, dry place, away from direct sunlight and extreme temperatures. Do not store fully charged or fully discharged for extended periods.
• 손질: Do not puncture, drop, short-circuit, or disassemble the battery. If the battery swells, leaks, or shows any signs of damage, discontinue use immediately and dispose of it properly.
• 처분: Dispose of damaged or depleted Li-Po batteries according to local regulations. Never dispose of them in regular household waste.
• 어린이들: 배터리를 어린이의 손이 닿지 않는 곳에 보관하세요.

패키지 내용

패키지에는 다음 항목이 포함되어 있어야 합니다.

• 1 x HAIBOXING 7.4V 1600mAh Soft Pack Li-po Battery (Model T2119)

Image: HAIBOXING 7.4V 1600mAh Li-Po Battery (Model T2119)

호환성

This 7.4V 1600mAh Soft Pack Li-po Battery (T2119) is 100% applicable and compatible with the following HAIBOXING 1/12 Scale RC Car models:

• HBX 2995
• HBX 905
• HBX 903
• HBX 903A

배터리 설치

Follow these steps to safely install or replace the battery in your compatible HAIBOXING RC car:

1. Remove the RC Car Shell: Locate the four small cotter pins (or similar fasteners) securing the RC car's outer shell. Carefully remove these pins and lift the shell off to expose the internal components.
2. 배터리함을 찾습니다: The battery is typically secured within a compartment or with Velcro straps.
3. Disconnect Old Battery (if applicable): If replacing an old battery, carefully disconnect its power connector from the RC car's electronic speed controller (ESC).
4. 새 배터리를 삽입하세요: Place the new 7.4V 1600mAh Li-Po battery into the battery compartment. Ensure it fits snugly and is secured, often with Velcro straps, to prevent movement during operation.
5. 배터리 연결: Connect the battery's power connector to the corresponding port on the RC car's ESC. Ensure the connection is firm and correct polarity is observed (red to red, black to black).
6. Reattach the RC Car Shell: Carefully align the shell back onto the chassis and secure it with the four cotter pins. Ensure all pins are fully inserted to prevent the shell from detaching during use.

이미지: 전ample of RC car internal components, including battery area.

배터리 충전

To charge your HAIBOXING 7.4V 1600mAh Li-Po Battery, follow these general guidelines:

• Use only a charger specifically designed for 7.4V (2S) Li-Po batteries. Using an incompatible charger can cause severe damage or fire.
• Connect the battery's balance lead to the balance port on your charger, and the main power lead to the charger's output port.
• Set the charger to the correct battery type (Li-Po) and voltage (7.4V or 2S).
• Set the charging current. For a 1600mAh battery, a common safe charging rate is 1C, which means 1.6 Amps. Refer to your charger's manual for specific instructions.
• Monitor the battery during the entire charging process. Disconnect immediately if you notice any swelling, overheating, or unusual behavior.
• 충전이 완료되면 배터리를 충전기에서 분리하세요.

운영 지침

Once the battery is fully charged and correctly installed in your HAIBOXING RC car, you are ready to operate. Ensure your remote control is also powered on and properly linked to the RC car.

• 전원 켜기: Turn on the RC car's power switch, usually located near the battery compartment or ESC.
• 스로틀 제어: Use the remote control's throttle trigger to control forward and reverse movement.
• 조향 제어: Use the steering wheel on the remote control to direct the RC car left or right.
• 속도 설정: Some RC car models and remote controls offer adjustable speed settings (e.g., 70% or 100% speed). Adjust as needed for your skill level and operating environment.
• 실행 시간: A fully charged 1600mAh battery typically provides approximately 25-40 minutes of run time, depending on driving style and terrain.
• 낮은 볼륨tage 컷오프: Most modern RC cars have a low voltage cutoff (LVC) feature to protect Li-Po batteries from over-discharge. When the car slows down significantly or stops, it indicates the battery is low and needs recharging.

유지 관리 및 보관

Proper maintenance and storage will extend the life of your Li-Po battery:

• 청소: After use, gently clean any dirt or debris from the battery and its connectors.
• 점검: 배터리에 부풀어 오르거나, 구멍이 나거나, 전선이 닳는 등의 손상 징후가 있는지 정기적으로 점검하십시오.
• 스토리지 볼륨tage: 장기간 보관할 경우, 배터리를 보관 용량까지 충전 또는 방전하십시오.tag(일반적으로 셀당 3.8V). 완전히 충전되거나 완전히 방전된 상태로 보관하지 마십시오.
• 온도: Store in a cool, dry environment (around 15-25°C or 59-77°F).

문제 해결

배터리에 문제가 발생하면 다음 사항을 고려하십시오.

• 배터리가 충전되지 않음:
  • Ensure the charger is correctly connected and set for Li-Po 2S (7.4V) battery type.
  • Check for damaged battery leads or charger connections.
• 짧은 실행 시간:
  • 사용하기 전에 배터리가 완전히 충전되어 있는지 확인하세요.
  • Driving aggressively or on challenging terrain can reduce run time.
  • Battery may be aging or damaged; consider replacement if performance significantly degrades.
• Battery Swelling/Overheating:
  • 즉시 사용 및 충전을 중단하십시오. This indicates a damaged or faulty battery.
  • 배터리는 현지 규정에 따라 안전하게 폐기하십시오.

명세서

보증 및 지원

For warranty information, technical support, or inquiries regarding your HAIBOXING 7.4V 1600mAh Li-Po Battery, please refer to the official HAIBOXING web사이트를 방문하거나 고객 서비스에 직접 문의하세요. 보증 청구에 대비해 구매 증빙 자료로 구매 영수증을 보관하세요.