Trevi 0SL3P50

Trevi SLD 3P50 Digital Clock Thermometer

사용자 설명서

제품 끝view

The Trevi SLD 3P50 is a digital clock thermometer featuring a large, backlit LCD display. It includes a programmable alarm and a snooze function, designed for clear readability and ease of use in various indoor environments.

Trevi SLD 3P50 Digital Clock Thermometer front view showing time, date, day, and temperature

이미지: 앞면 view of the Trevi SLD 3P50 Digital Clock Thermometer, displaying the current time, date, day of the week, and indoor temperature.

패키지 내용

  • 1 x Trevi SLD 3P50 Digital Clock Thermometer
  • 1 x 사용자 매뉴얼(이 문서)
  • 참고: 배터리는 포함되어 있지 않으므로 별도로 구매해야 합니다.

설정

1. 배터리 설치

  1. 장치 뒷면에서 배터리함을 찾으세요.
  2. 배터리 덮개를 엽니다.
  3. Insert the required batteries (typically AAA, refer to the compartment label for exact type and polarity). Ensure correct polarity (+/-).
  4. 배터리 덮개를 단단히 닫으세요.

2. 초기 전원 켜기

Upon battery installation, the device will power on automatically. The display will show default time and date settings, and the current temperature.

3. 시간 및 날짜 설정

  • 를 누르세요 방법 button to cycle through display modes until the time setting mode is active (usually indicated by flashing digits).
  • 사용하세요 UP 그리고 아래에 시간을 조정하려면 버튼을 누른 다음 누르세요. 방법 확인하고 회의록으로 이동합니다.
  • Repeat this process for setting the year, month, and day.
  • 누르다 방법 설정 모드를 종료하려면 다시 누르세요.

작동 지침

1. 디스플레이 모드

를 누르세요 방법 button to switch between different display modes, such as Time, Date, and Alarm settings.

2. 알람 설정

  1. 누르다 방법 until the alarm time is displayed (often indicated by an alarm icon).
  2. 누르고 있으세요 방법 알람 시간 숫자가 깜박일 때까지.
  3. 사용하세요 UP 그리고 아래에 원하는 알람 시간을 설정하는 버튼입니다.
  4. 누르다 방법 to confirm and move to minutes, then set minutes.
  5. 누르다 방법 again to save the alarm setting.
  6. 알람을 활성화/비활성화하려면 다음을 누르세요. 알람 ON / OFF button (or similar, refer to device buttons). An alarm icon will appear/disappear on the display.

3. 스누즈 기능 사용하기

알람이 울리면 버튼을 누르세요. 스누즈 / 라이트 button (usually located on top) to temporarily silence the alarm. The alarm will sound again after a few minutes (typically 5-10 minutes).

4. 백라이트 활성화

를 누르세요 스누즈 / 라이트 button to activate the display backlight for a few seconds, improving visibility in low-light conditions.

5. 온도 표시

The device continuously displays the ambient temperature. Some models may allow switching between Celsius and Fahrenheit. If available, press a dedicated ° C / ° F button or refer to the manual for specific button combinations.

유지

1. 청소

  • 부드럽고 마른 천으로 기기를 닦으십시오.
  • Do not use abrasive cleaners, solvents, or chemical sprays, as these may damage the surface or internal components.

2. 배터리 교체

When the display dims or functions become erratic, it is time to replace the batteries. Follow the battery installation steps in the 설정 section. Always replace all batteries at the same time with new ones of the same type.

3. 보관

장기간 기기를 사용하지 않을 경우, 누액 및 손상을 방지하기 위해 배터리를 제거하십시오.

문제 해결

문제가능한 원인해결책
디스플레이가 비어 있거나 어둡습니다.배터리가 부족하거나 방전됨, 배터리가 잘못 설치됨.배터리를 새 배터리로 교체하고 극성이 올바른지 확인하세요.
알람이 울리지 않습니다.Alarm is not activated; alarm volume is too low (if adjustable).Ensure the alarm function is turned ON. Check if there's a volume setting.
시간/날짜가 잘못되었습니다.Time/date was not set correctly or reset after battery change.Follow the "Setting Time and Date" instructions in the Setup section.
온도 측정값이 정확하지 않은 것 같습니다.Device placed near heat sources, direct sunlight, or drafts.Relocate the device to a stable indoor environment away from extreme temperature fluctuations.

명세서

Trevi SLD 3P50 Digital Clock Thermometer with dimensions labeled

Image: Trevi SLD 3P50 Digital Clock Thermometer, illustrating its approximate height (11.18 cm) and width (13.46 cm).

특징세부 사항
모델 번호0SL3P50
치수(길이 x 너비 x 높이)50 x 50 x 28cm
무게160그램
상표트레비
색상빨간색
디스플레이 유형디지털, 백라이트 LCD
특별 기능Temperature display, Large screen, Alarm, Snooze
전원배터리 구동
배터리 포함아니요
장착 유형테이블 마운트
재료스테인리스 스틸
작동 모드전기 같은
시계 운동 유형석영

보증 및 지원

This product is covered by a standard manufacturer's warranty. For detailed warranty information, please refer to the warranty card included with your purchase or contact Trevi customer support.

For technical assistance, troubleshooting not covered in this manual, or service inquiries, please visit the official Trevi web사이트 또는 고객 서비스 부서에 문의하세요. 연락처 정보는 일반적으로 제품 포장이나 제조업체의 web대지.

  • 제조업체: 트레비
  • 모델: SLD 3P50 (0SL3P50)
  • ASIN: B07Y3T2BFV

© 2023 Trevi. 모든 권리 보유.

본 설명서는 정보 제공 목적으로만 제공됩니다. 제품 사양은 예고 없이 변경될 수 있습니다.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.