1. 서론
The TC Electronic JUNE-60 CHORUS pedal is an authentic recreation of the legendary synthesizer chorus from the 1980s. This pedal features a simple 2-button interface for intuitive modulation tone and utilizes all-analog BBD (Bucket Brigade Delay) circuitry to deliver its classic sound. Designed for guitarists seeking vintage chorus effects, the JUNE-60 CHORUS also includes True Bypass for ultimate signal integrity.
그림 1.1: 상향식 view of the TC Electronic JUNE-60 CHORUS Pedal, showcasing its two yellow buttons and True Bypass footswitch.
2. 중요 안전 지침
- 기기를 작동하기 전에 이 지침을 꼼꼼히 읽으십시오.
- 이 지침을 향후 참고용으로 보관하세요.
- 제품과 사용 설명서에 있는 모든 경고 사항을 주의 깊게 따르십시오.
- 이 기기를 물이나 습기가 있는 곳에서 사용하지 마십시오.
- 마른 천으로만 닦으십시오.
- 환기구를 막지 마십시오. 제조업체의 지침에 따라 설치하십시오.
- 라디에이터, 난방 조절기, 스토브 또는 기타 장치(다음을 포함)와 같은 열원 근처에 설치하지 마십시오. amp열을 생성하는 발전기.
- 제조사가 지정한 부속품/액세서리만 사용하세요.
- 모든 서비스는 자격을 갖춘 서비스 담당자에게 의뢰하십시오. 전원 코드나 플러그가 손상되었거나, 액체가 쏟아졌거나, 물체가 기기에 떨어졌거나, 기기가 비나 습기에 노출되었거나, 정상적으로 작동하지 않거나, 떨어졌을 때와 같이 기기가 어떤 식으로든 손상된 경우 서비스가 필요합니다.
3. 설정
3.1 전원 연결
The JUNE-60 CHORUS pedal can be powered by a 9V battery or an external 9V DC power supply (not included). Ensure the power supply provides at least 100 mA. Connect the power supply to the 9V DC input jack on the rear of the pedal.
- 배터리 전원: To install a 9V battery, open the battery compartment on the bottom of the pedal. Connect the battery to the clip and place it inside the compartment.
- 외부 전원 : Use a regulated 9V DC power supply with a center-negative plug, providing a minimum of 100 mA.
Figure 3.1: Rear panel of the JUNE-60 CHORUS Pedal, showing the INPUT (MONO), 9V DC power input (100 mA), and OUTPUT (MONO/STEREO) jacks.
3.2 오디오 연결
악기(예: 기타)를 연결하세요. INPUT (MONO) jack using a standard 1/4-inch instrument cable. Connect the 출력(모노/스테레오) 잭에게 amplifier or the next pedal in your signal chain. For stereo operation, use a Y-cable or two separate cables from the output to two amp앰프 또는 스테레오 입력 장치.
- 모노 설정: Connect a single 1/4-inch cable from the OUTPUT jack to your amp리퍼.
- 스테레오 설정: The JUNE-60 CHORUS supports stereo output. Consult your amplifier or audio interface manual for proper stereo input connections.
4. 운영
The JUNE-60 CHORUS pedal features a straightforward 2-button interface, replicating the classic chorus modes of its inspiration. The pedal is activated by the True Bypass footswitch.
4.1 효과 활용하기
를 누르세요 트루 바이패스 footswitch to toggle the effect on or off. When the effect is active, the LED indicator will illuminate.
4.2 Chorus Modes (Buttons I & II)
The two yellow buttons, labeled I 그리고 II, select different chorus modes. These buttons can be used individually or simultaneously to achieve distinct modulation characteristics.
- 버튼 I: Engages Chorus Mode I, offering a specific modulation rate and depth.
- 버튼 II: Engages Chorus Mode II, offering an alternative modulation rate and depth.
- Buttons I & II (Simultaneously): Pressing both buttons together activates a combined chorus mode, often resulting in a richer, more complex modulation. Experiment with these combinations to find your desired sound.
그림 4.1: 상단 view of the JUNE-60 CHORUS Pedal, highlighting the two yellow buttons (I and II) for chorus mode selection.
4.3 모노/스테레오 스위치
A small switch labeled 모노 / 스테레오 is located near the chorus mode buttons. This switch determines the output configuration of the pedal.
- 단 핵증: 싱글용 amp리파이어 설정.
- 스테레오 재생: For dual amplifier or stereo input setups, providing a wider, more immersive chorus effect.
5. 유지관리
5.1 청소
Clean the pedal's exterior with a soft, dry cloth. Do not use abrasive cleaners or solvents, as these may damage the finish or internal components.
5.2 배터리 교체
If using battery power, replace the 9V battery when the effect LED dims or the pedal's performance degrades. To replace, open the battery compartment on the bottom of the unit, disconnect the old battery, and connect a new one, ensuring correct polarity.
5.3 보관
When not in use for extended periods, disconnect the power supply and remove the battery to prevent leakage. Store the pedal in a cool, dry place away from direct sunlight and extreme temperatures.
6. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 페달을 밟아도 소리가 나지 않습니다. | No power, incorrect cable connection, faulty cable. |
|
| 소리가 약하거나 왜곡됨. | Low battery, incorrect input level from instrument. |
|
| Chorus effect is not noticeable. | Incorrect chorus mode selected, subtle setting. |
|
| Pedal does not power on with adapter. | Insufficient current from power adapter. |
|
7. 사양
| 특징 | 세부 사항 |
|---|---|
| 모델 | JUNE-60 CHORUS |
| 이펙트 타입 | 합창 |
| 회로 | All-analog BBD (Bucket Brigade Delay) |
| 우회로 | 진정한 우회 |
| 통제 수단 | 2 x Chorus Mode Buttons (I, II), MONO/STEREO Switch, True Bypass Footswitch |
| 입력 커넥터 | 1 x 1/4" TS, unbalanced (Mono) |
| 출력 커넥터 | 1 x 1/4" TS, unbalanced (Mono/Stereo) |
| 전원 입력 | Standard 9V DC, center-negative, >100 mA (Power supply not included) |
| 배터리 옵션 | 9V 배터리(포함되지 않음) |
| 치수(높이 x 너비 x 깊이) | 약 13.7 x 8.6 x 5.6인치 |
| 무게 | 8온스(0.5파운드) |
| 본체 소재 | 플라스틱, 금속 |
Figure 7.1: Bottom label of the JUNE-60 CHORUS Pedal, displaying model and regulatory compliance information.
8. 보증 및 지원
8.1 보증 정보
TC Electronic products are designed and manufactured to the highest standards. For detailed warranty terms and conditions, please refer to the official TC Electronic web사이트 또는 제품에 포함된 보증서를 확인하세요. 보증 청구를 위해 구매 증빙 자료를 보관하세요.
8.2 고객 지원
Should you encounter any issues or have questions regarding your JUNE-60 CHORUS pedal, please visit the official TC Electronic support page for FAQs, troubleshooting guides, and contact information. You can find support resources at the TC 전자 지원 Web대지.