TRUE GDM-19T-HC~TSL01

TRUE GDM-19T-LD 유리문 진열대 사용 설명서

Model: GDM-19T-HC~TSL01

제품 끝view

The TRUE GDM-19T-LD Glass Door Merchandiser is a commercial refrigeration unit designed for displaying and storing various products. It features a single swing glass door, LED interior lighting, and adjustable wire shelves. This unit is engineered for energy efficiency and reliable temperature maintenance, typically maintaining temperatures between +33°F and +38°F.

TRUE GDM-19T-LD Glass Door Merchandiser, front view

앞쪽 view of the TRUE GDM-19T-LD Glass Door Merchandiser, showcasing its single glass door and internal shelving.

설정 및 설치

Proper setup is crucial for optimal performance and longevity of your merchandiser. Follow these steps carefully:

  1. 짐 풀기: Carefully remove all packaging materials. Inspect the unit for any shipping damage. Report any damage immediately to your carrier.
  2. 위치: Place the merchandiser on a level, sturdy surface capable of supporting its weight when fully loaded. Ensure adequate ventilation around the unit. Avoid direct sunlight or heat sources.
  3. 정리: Maintain a minimum of 3 inches (7.6 cm) clearance from walls or other obstructions on the sides and rear for proper airflow.
  4. 전기 연결: Connect the unit to a dedicated grounded electrical outlet. Refer to the specifications section for electrical requirements. Do not use extension cords.
  5. 초기 청소: Before first use, clean the interior and exterior surfaces with a mild soap and water solution. Rinse thoroughly and dry.
  6. 수준 측량: Use a level to ensure the unit is perfectly level. Adjust the leveling feet as needed.
  7. 선반 설치: Install the adjustable wire shelves as desired. Ensure they are securely seated on the shelf clips.
TRUE GDM-19T-LD Glass Door Merchandiser, interior view 선반이 있는

내부 view of the merchandiser, showing the adjustable wire shelves and LED lighting.

작동 지침

Once installed, operating your TRUE merchandiser is straightforward:

  • 전원 켜기: Plug the unit into the electrical outlet. The internal lighting and refrigeration system will activate.
  • 온도 조절: The unit is designed to maintain a temperature between +33°F and +38°F (0.5°C and 3.3°C). The temperature control is typically located inside the unit or on the front panel. Adjust as necessary within the recommended range.
  • 제품 로딩 중: Load products evenly on the shelves. Do not block the air vents inside the unit, as this can impede airflow and affect cooling efficiency.
  • 문 가동: Ensure the glass door closes completely after each opening to maintain internal temperature and energy efficiency. The door features a self-closing mechanism.
  • 해동 주기: This unit features an automatic defrost system. During defrost, the evaporator coil is warmed to melt any accumulated ice. Water drains into an evaporator pan and is evaporated.

유지

Regular maintenance ensures efficient operation and extends the life of your merchandiser.

일일 유지 관리:

  • Wipe down the exterior and interior surfaces with a clean cloth and mild, non-abrasive cleaner.
  • Check that the door gasket is clean and sealing properly.

월간 유지 관리 :

  • 응축기 코일 청소: The condenser coil should be cleaned monthly or more frequently in dusty environments. Unplug the unit before cleaning. Use a stiff brush or vacuum cleaner to remove dust and debris from the coil. A dirty coil reduces efficiency and can lead to compressor failure.
  • 전원 코드에 손상이 있는지 검사하십시오.

연간 유지 관리:

  • It is recommended to have a qualified refrigeration technician inspect the unit annually for optimal performance.

문제 해결 가이드

서비스 요청 전에 다음 일반적인 문제들을 확인해 주세요:

문제가능한 원인해결책
장치가 냉각되지 않음
  • 전원 코드 뽑힘
  • 회로 차단기가 트립됨
  • 온도 조절이 너무 높게 설정되었습니다
  • 더러운 콘덴서 코일
  • 도어가 제대로 닫히지 않음
  • 플러그 인 유닛
  • 리셋 차단기
  • 온도 조절 조절
  • 콘덴서 코일 청소
  • Check door gasket and alignment
과도한 소음
  • 단위가 수평이 아님
  • 느슨한 구성 요소
  • 단위를 수평으로 맞추세요
  • Contact service if noise persists
바닥에 물
  • 배수관 막힘
  • Evaporator pan overflowing
  • 배수관을 청소하세요
  • 서비스에 연락하세요

명세서

특징세부 사항
상표진실
모델GDM-19T-HC~TSL01
용량19입방 피트
설치 유형독립형
문 개수1 (유리)
제상 시스템오토매틱
선반 유형Wire (4 adjustable shelves)
온도 범위+33°F ~ +38°F(0.5°C ~ 3.3°C)
외부 마감Non-chip, non-peel vinyl (Black or White) or Stainless Steel
내부 마감NSF approved white anodized aluminum
조명Standard LED interior lighting

보증 및 지원

For warranty information and technical support, please refer to the official TRUE Manufacturing website or contact their customer service department. Keep your purchase receipt and model number readily available when contacting support.

확장된 보장 범위에 대한 보호 계획이 제공됩니다.

  • 2년 보호 계획: 159.99달러
  • 3년 보호 계획: 239.99달러
  • Complete Protect (monthly): $16.99/월

추가 지원이 필요하면 다음을 방문하세요. TRUE Store on Amazon.

© 2024 TRUE Manufacturing. 모든 권리 보유.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.