소개
Thank you for choosing the Physio Logic Digital 10 Thermometer. This device is designed to provide fast, accurate, and reliable temperature readings for personal health monitoring. Please read this manual thoroughly before use to ensure proper operation and to maintain the accuracy and longevity of your thermometer.
Image: The Physio Logic Digital 10 Thermometer, a white, slender device with a digital display and the Physio Logic logo.
제품 특징
- Provides clinically proven accuracy for temperature readings.
- Delivers results in less than ten seconds.
- Displays temperature in either Fahrenheit or Celsius.
- Accurate within 0.2 degrees F / 0.1 degrees C.
- Beeps when peak temperature has been reached.
- Conveniently water resistant for easy cleaning and hygiene.
- Includes auto shut-off for extended battery life.
- Comes with a handy storage case for safe keeping.
Image: The retail packaging for the Physio Logic Digital 10 Thermometer, highlighting its 10-second results and water-resistant features.
설정
배터리 설치
The Physio Logic Digital 10 Thermometer comes with one product-specific battery included and pre-installed. If the battery needs replacement, carefully open the battery compartment located at the end opposite the tip. Insert a new battery, ensuring correct polarity, and securely close the compartment.
Initial Power-On and Unit Selection
- Press the power button to turn on the thermometer. A short beep will sound, and the display will show all segments briefly, followed by the last measured temperature.
- To switch between Fahrenheit (°F) and Celsius (°C), ensure the thermometer is off. Press and hold the power button for approximately 3 seconds until the unit changes on the display. Release the button to set the desired unit.
- 이제 온도계를 사용할 준비가 되었습니다.
작동 지침
온도 판독
- 전원 버튼을 눌러 온도계를 켭니다.
- Place the thermometer tip according to the desired measurement method:
- 구두 사용 : Place the tip under the tongue, as close to the heat pocket as possible. Keep mouth closed.
- Axillary (Underarm) Use: Place the tip in the armpit, ensuring good skin contact. Hold arm firmly against the body.
- 직장 사용 : 끝부분에 수용성 윤활제를 바르십시오. 끝부분을 직장에 1/2인치(약 1.2cm) 이상 넣지 말고 부드럽게 삽입하십시오.
- Hold the thermometer in place until the peak temperature is reached, indicated by a series of beeps (approximately 10 seconds).
- 화면에 표시된 온도를 읽으십시오.
- 온도계를 끄려면 전원 버튼을 누르십시오. 배터리 수명 절약을 위해 약 10분 동안 사용하지 않으면 자동으로 꺼집니다.
유지
세척 및 소독
The thermometer is water resistant and can be easily cleaned. After each use, wipe the tip and shaft with a soft cloth dampened with isopropyl alcohol (70% concentration) or soap and water. Do not immerse the entire thermometer in water or any cleaning solution. Allow to air dry before storing.
저장
Store the thermometer in its handy storage case when not in use. Keep it in a cool, dry place, away from direct sunlight and extreme temperatures. Ensure the thermometer is clean and dry before storing.
Image: The Physio Logic Digital 10 Thermometer resting inside its protective clear plastic storage case.
배터리 교체
When the battery symbol appears on the display, it indicates that the battery is low and needs replacement. Refer to the 'Battery Installation' section under Setup for instructions.
문제 해결
-
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.