1. 소개 및 이상view
The Bosch BC884 QuietCast Premium Ceramic Disc Brake Pad Set is engineered to provide exceptional stopping power and quiet operation for the front axle of compatible Toyota Highlander vehicles. Leveraging Bosch's extensive experience in braking systems, these pads offer OE quality performance, advanced strength, and durability. The exclusive ceramic friction material is designed for superior performance with low dust, while pre-attached multi-layer rubber shims ensure quiet operation and enhanced corrosion resistance. OE-style slots and chamfers guarantee a precise fit and optimal functionality.
2. 안전 정보
Brake system work requires specialized knowledge and tools. Improper installation can lead to brake failure, serious injury, or death. If you are not confident in your ability to perform this installation safely and correctly, seek assistance from a qualified automotive technician. Always wear appropriate personal protective equipment, including safety glasses and gloves. Ensure the vehicle is securely supported on jack stands before beginning any work. Never rely solely on a jack. Disconnect the vehicle's battery before working on any electrical components. Refer to your vehicle's service manual for specific safety procedures and torque specifications.
3. 패키지 내용
The Bosch BC884 QuietCast Premium Ceramic Disc Brake Pad Set typically includes the following components:
- Brake pads for one axle (two wheels)
- Hardware kit (if applicable for your vehicle model)
- Synthetic lubricant for sliding contact points
4. 설치
This section provides general guidelines for installing the Bosch BC884 brake pads. Always consult your vehicle's specific service manual for detailed, step-by-step instructions and torque specifications.
- 준비: Park the vehicle on a level surface, engage the parking brake, and block the rear wheels. Loosen the lug nuts on the front wheels. Raise the front of the vehicle using a floor jack and secure it with jack stands. Remove the front wheels.
- 캘리퍼 제거: Locate the brake caliper. Remove the caliper guide pin bolts. Carefully slide the caliper off the rotor and support it to prevent strain on the brake hose. Do not let the caliper hang by the brake hose.
- 오래된 패드 제거: Remove the old brake pads and any existing hardware (shims, clips). Inspect the brake rotor for wear, scoring, or cracks. Replace the rotor if necessary.
- 캘리퍼 피스톤 후퇴: Use a caliper piston compression tool to retract the caliper pistons fully. This creates space for the new, thicker brake pads.
- 새 하드웨어 설치: Clean the caliper bracket thoroughly. Install the new hardware clips (if included in the kit) onto the caliper bracket. Apply a thin layer of the provided synthetic lubricant to the sliding contact points where the pads will sit and on the guide pins.
- 새 패드 설치: Install the new Bosch BC884 brake pads into the caliper bracket. Ensure the OE-style slots and chamfers align correctly. The pads should slide freely within the bracket.
- 캘리퍼 재설치: 캘리퍼를 새 패드와 로터 위로 조심스럽게 다시 밀어 넣습니다. 캘리퍼 가이드 핀 볼트를 다시 설치하고 제조사에서 지정한 토크로 조입니다.
- 마지막 단계: Reinstall the wheels and tighten the lug nuts hand-tight. Lower the vehicle and torque the lug nuts to the manufacturer's specifications. Pump the brake pedal several times until it feels firm before driving. This will seat the caliper pistons against the new pads. Check the brake fluid level and top off if necessary.

Image showing the Bosch BC884 QuietCast Premium Ceramic Disc Brake Pads, highlighting the ceramic friction material and multi-layer rubber shim design.
5. 작동 및 침입 절차
Proper break-in (also known as bedding-in) of new brake pads is crucial for optimal performance, longevity, and quiet operation. Follow these steps:
- 초기 운전: 몇 마일 동안은 차량을 적당한 속도(예: 30-40mph 또는 50-65km/h)로 운전하고, 급브레이크는 피하세요.
- 중간 정차: Perform approximately 10-15 moderate stops from 30 mph (50 km/h) down to about 5-10 mph (8-16 km/h). Allow a short cooling period between stops. Do not come to a complete stop during these initial cycles.
- 쿨다운: After the moderate stops, drive for several minutes without braking to allow the pads and rotors to cool down.
- 급브레이크를 피하세요: For the first 200-300 miles (320-480 km) after installation, avoid sudden, hard braking or prolonged heavy braking (e.g., towing or mountain driving). This allows the friction material to fully cure and mate with the rotor surface.
Following this procedure will help ensure quiet operation, consistent stopping power, and extended pad life.
6. 유지관리
Regular inspection of your brake system is essential for safety and performance.
- 정기 점검: 최소한 1년에 한 번 또는 12,000마일(20,000km)마다 브레이크 패드, 로터, 캘리퍼, 브레이크 유체 수준을 검사하거나 차량 제조업체의 권장 사항에 따라 검사하세요.
- 패드 마모: Replace brake pads when the friction material wears down to the minimum thickness specified by the manufacturer, typically around 2-3mm. Many pads include wear indicators that produce a squealing sound when replacement is needed.
- 로터 상태: Check rotors for excessive wear, deep grooves, or warping. Replace or resurface rotors as needed.
- 브레이크 오일: Ensure brake fluid is at the proper level and is clean. Contaminated or low brake fluid can compromise braking performance.
7. 문제 해결
If you experience any issues with your brake system after installing Bosch BC884 pads, consider the following:
- 브레이크 소음(삐걱거리는 소리/갈리는 소리):
- 적절한 침입 절차가 준수되었는지 확인하십시오.
- Verify all hardware was installed correctly and lubricated.
- Check for foreign objects between the pad and rotor.
- 로터의 불균등한 마모 또는 손상 여부를 검사하십시오.
- 제동 성능 저하:
- Confirm proper break-in.
- Check for air in the brake lines (may require bleeding).
- 브레이크 유체 누출이나 유체 수준 저하 여부를 점검하세요.
- 캘리퍼가 제대로 작동하고 눌리지 않았는지 확인하세요.
- 제동 중 진동:
- Often indicates warped or unevenly worn rotors. Inspect and replace/resurface rotors if necessary.
- 느슨한 휠 베어링이나 서스펜션 구성 요소가 있는지 확인하세요.
If troubleshooting steps do not resolve the issue, or if you are unsure about any aspect of brake system diagnosis, consult a professional automotive technician immediately.
8. 사양
| 사양 | 세부 사항 |
|---|---|
| 상표 | 보쉬 |
| 품목 모델 번호 | 기원전 884 |
| 제품 유형 이름 | 브레이크 패드 |
| 재료 | 세라믹 |
| Automotive Part Position | 앞쪽 |
| 차량 서비스 유형 | 자동차 |
| 사양 충족 | OEM |
| 자동차 적합 유형 | 차량 특정 맞춤 |
| 항목 수 | 1 (for 1 axle) |
| 제품 크기(L x W x H) | 21.59 x 13.46 x 8.46cm (약 8.5 x 5.3 x 3.3인치) |
| 품목 무게 | 1.59kg(3.5파운드) |
| 제조업체 | 보쉬 자동차 |
| ASIN | B00XM0HMIS |
| 한국어: | 077212160785 |
| International Article Number (EAN/GTIN) | 0077212160785 |
| 포함된 구성 요소 | 브레이크 패드 |
9. 보증 및 지원
For specific warranty information regarding your Bosch BC884 QuietCast Premium Ceramic Disc Brake Pad Set, please refer to the documentation included with your purchase or contact the retailer. General product support and additional information about Bosch automotive products can be found on the official Bosch website or by visiting the Bosch brand store.
Bosch Brand Store: Visit the Bosch Store