1. 서론
This manual provides detailed instructions for the installation, operation, and maintenance of your Hager EK570 battery-powered weekly thermostat. Please read this guide thoroughly before use to ensure proper function, safety, and to maximize the benefits of its programmable features. Keep this manual for future reference.
2. 안전 정보
- Always disconnect power to the heating system before attempting any installation or maintenance.
- 설치는 자격을 갖춘 전기 기술자 또는 유능한 사람만 수행해야 합니다.
- Do not expose the thermostat to extreme temperatures, direct sunlight, high humidity, or water.
- Use only LR6 (AA) batteries as specified. Do not mix old and new batteries or different types of batteries.
- 기기를 어린이의 손이 닿지 않는 곳에 보관하세요.
- Do not attempt to open or repair the thermostat yourself. Refer to qualified service personnel.
3. 패키지 내용
패키지에 모든 품목이 들어 있는지 확인하세요.
- Hager EK570 Thermostat Unit
- 2 x LR6 (AA) Batteries
- 장착 나사 및 벽 플러그(해당되는 경우)
- 이 사용 설명서
4. 제품 오버view
Familiarize yourself with the components of your Hager EK570 thermostat:
그림 1: 전면 view of the Hager EK570 thermostat. The device features a clear LCD display at the top, two square buttons below the display, and a central control cluster at the bottom with '-', 'OK', and '+' buttons.
- LCD 디스플레이: Shows current temperature, time, day, operating mode, and program status.
- 제어 버튼: Used for navigating menus, adjusting settings, and selecting modes. Typically includes 'Mode', 'Set', 'Up', 'Down', and 'OK' buttons.
- 배터리 칸: 유닛 뒤쪽에 위치해 있습니다.
5. 설정
5.1. 배터리 설치
- 온도 조절기의 뒷면 덮개를 제거하세요.
- Insert the 2 x LR6 (AA) batteries, ensuring correct polarity (+/-).
- Replace the back cover. The display should now activate.
5.2. 온도 조절 장치 장착
The Hager EK570 is designed for surface mounting.
- 직사광선, 외풍, 열원(예: 라디에이터, 벽난로)을 피해 실내 벽면의 적절한 위치를 선택하세요.amps). The recommended height is approximately 1.5 meters from the floor.
- Carefully detach the front part of the thermostat from its base plate.
- Mark the drilling points on the wall using the base plate as a template.
- 구멍을 뚫고 벽 플러그를 삽입합니다.
- 제공된 나사를 사용하여 받침대를 벽에 고정하십시오.
- Connect the heating system wires to the terminals on the base plate according to the wiring diagram provided with your heating system. Ensure all connections are secure and correct.
- Reattach the front part of the thermostat to the base plate, ensuring it clicks securely into place.
5.3. 초기 설정 (시간 및 날짜)
Upon first power-up or after battery replacement, you may need to set the current time and day.
- Press the 'SET' or 'MODE' button to enter the settings menu.
- Use the '+' or '-' buttons to navigate to 'Time' or 'Date' settings.
- Press 'OK' to confirm and then use '+' or '-' to adjust the values (hour, minute, day, month, year).
- Press 'OK' to save each setting and exit the menu.
6. 사용 설명서
The Hager EK570 offers various operating modes and programming options to optimize your heating.
6.1. 작동 모드 선택
The thermostat supports the following modes:
- 컴포트 모드: Maintains a comfortable temperature (e.g., 21°C) during occupied periods.
- 축소 모드: Maintains a lower, energy-saving temperature (e.g., 18°C) during unoccupied periods or at night.
- 서리 보호 모드: 배관 동결을 방지하기 위해 최소 온도(예: 5°C)를 유지합니다.
- 수동 모드: Allows you to set a constant temperature that overrides any programmed schedule.
- 휴일 모드: Maintains a specific temperature for an extended period (e.g., during vacation).
To switch between modes, press the 'MODE' button repeatedly until the desired mode is displayed.
6.2. 온도 설정값 조정
In any operating mode (except Frost Protection), you can temporarily adjust the temperature setpoint:
- Use the '+' or '-' buttons to increase or decrease the desired temperature.
- The new setpoint will be active until the next programmed event or until you manually change it again. This is known as a temporary override.
6.3. 주간 프로그램
The EK570 is a weekly programmable thermostat, allowing you to set up to 48 program steps per day across 4 setpoints (Comfort, Reduced, etc.). It comes with 3 pre-recorded programs and 1 free program for customization.
- Press the 'PROG' or 'SET' button to enter programming mode.
- Use '+' or '-' to select the day of the week you wish to program (e.g., Monday, Tuesday, etc.).
- Press 'OK' to confirm the day.
- The display will show the first program period. Use '+' or '-' to set the start time and then 'OK'.
- Next, select the desired operating mode (Comfort, Reduced, etc.) for this period using '+' or '-' and confirm with 'OK'.
- Repeat steps 4 and 5 for all desired program periods for that day.
- You can copy programs from one day to another if needed (refer to specific instructions in the full manual for this feature).
- Exit programming mode by pressing 'PROG' or 'MODE' button.
7. 유지관리
7.1. 청소
온도 조절기를 청소하세요asing with a soft, dry cloth. Do not use abrasive cleaners, solvents, or chemical agents, as these can damage the plastic and electronic components.
7.2. 배터리 교체
The thermostat is powered by 2 x LR6 (AA) batteries. When the battery symbol appears on the display, or if the display becomes dim, it is time to replace the batteries.
- 온도 조절기의 뒷면 덮개를 제거하세요.
- 오래된 배터리를 제거하세요.
- Insert new 2 x LR6 (AA) batteries, observing correct polarity.
- 뒷면 덮개를 교체하십시오.
The thermostat has a power reserve of approximately 10 minutes, allowing for battery replacement without losing programmed settings, provided the replacement is done promptly.
8. 문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 디스플레이가 비어 있거나 어둡습니다. | 배터리가 부족하거나 잘못 삽입되었습니다. | Replace batteries with new LR6 (AA) batteries, ensuring correct polarity. |
| 온도 조절기가 난방을 제어하지 못하고 있습니다. | Incorrect wiring; heating system fault; thermostat in 'OFF' or 'Frost Protection' mode. | Check wiring connections (consult a professional); verify heating system power; ensure thermostat is in an active heating mode (Comfort, Reduced, Manual). |
| 온도 측정값이 정확하지 않은 것 같습니다. | 온도 조절 장치의 위치는 통풍, 직사광선 또는 열원의 영향을 받습니다. | Relocate the thermostat to a more suitable position, away from external influences. |
| Cannot program the thermostat. | Incorrect programming steps followed; thermostat locked. | Refer to Section 6.3 for programming instructions. Check if a child lock feature is active (consult full manual). |
9. 사양
| 특징 | 사양 |
|---|---|
| 모델 | EK570 |
| 전원 공급 장치 | 2 x LR6 (AA) Batteries (included) |
| Setpoint Adjustment Range | 5 °C ~ 30 °C |
| 작동 온도 | 0 °C ~ 45 °C |
| 보관/운반 온도 | -25 °C ~ 70 °C |
| 디스플레이 유형 | 백라이트가있는 LCD |
| 시계 타입 | 디지털 온도 조절기 |
| 센서 유형 | 전자 |
| 장착 유형 | 표면 실장 |
| 터미널 유형 | 1~1.5mm² |
| Rated Operating Current (AC1) | 5아 |
| 차단 용량 | 5A / 250V |
| IP 보호 등급 | IP30 |
| 파워 리저브 | 10 분 |
| Ecodesign Class | 4 |
| 치수(대략적) | 97mm(높이) x 70mm(폭) x 30mm(깊이) |
| 무게 (대략) | 340그램 (포장 포함) |
10. 보증 및 지원
For detailed warranty information, technical support, or service inquiries, please refer to the official Hager web해당 웹사이트를 방문하거나 공인 판매점에 문의하십시오. 구매 영수증을 보관하여 구매 증빙 자료로 활용하십시오.