소개
This manual provides comprehensive instructions for the safe and effective use, installation, and maintenance of your MIPRO MB-70 Replacement Rechargeable 12V Battery. Please read this manual thoroughly before using the product to ensure optimal performance and longevity.
중요한 안전 정보
부상이나 배터리 및 연결 장비의 손상을 방지하기 위해 항상 다음 안전 수칙을 준수하십시오.
- 하지 마세요 배터리 단자를 단락시킵니다.
- 하지 마세요 expose the battery to extreme temperatures, direct sunlight, or fire.
- 하지 마세요 immerse the battery in water or other liquids.
- 하지 마세요 attempt to open, disassemble, or modify the battery.
- 배터리를 어린이와 애완동물의 손이 닿지 않는 곳에 보관하십시오.
- 다 쓴 배터리는 현지 규정에 따라 폐기하십시오.
- Use only chargers specified for 12V lead-acid batteries.
제품 끝view
The MIPRO MB-70 is a high-quality, rechargeable 12V lead-acid battery designed as a replacement for compatible MIPRO audio equipment and other devices requiring a 12V power source. It provides reliable and consistent power for extended operation.
Image 1: The MIPRO MB-70 Replacement Rechargeable 12V Battery. This image shows the compact, rectangular form factor of the battery, typically black or dark gray, with visible terminals for connection.
설치 지침
Follow these steps to safely install the MIPRO MB-70 battery into your compatible device:
- 전원 끄기 장치: Ensure the device requiring the battery replacement is completely powered off and disconnected from any power sources.
- 배터리 칸 찾기: Identify and open the battery compartment on your device. Refer to your device's manual for specific instructions.
- 오래된 배터리 제거: Carefully disconnect the old battery, noting the polarity (positive and negative terminals). Remove the old battery from the compartment.
- 새 배터리를 삽입하세요: Insert the MIPRO MB-70 battery into the compartment, ensuring the terminals align correctly with the device's connectors. Connect the positive (+) terminal first, then the negative (-) terminal.
- 보안 구획: 배터리 구획을 닫고 고정합니다.
- 초기 청구 : It is recommended to fully charge the battery before its first use. Refer to the "Charging the Battery" section.
배터리 충전
To ensure optimal performance and battery life, follow these charging guidelines:
- Use a compatible 12V lead-acid battery charger. Using an incorrect charger can damage the battery or pose a safety risk.
- Connect the charger to the battery terminals, ensuring correct polarity (positive to positive, negative to negative).
- 충전기를 적합한 전원 콘센트에 연결하십시오.
- Allow the battery to charge until the charger indicates a full charge (refer to your charger's instructions).
- Avoid overcharging, as this can reduce battery life. Disconnect the charger once the battery is fully charged.
- 환기가 잘 되는 곳에서 배터리를 충전하십시오.
Battery Maintenance and Storage
Proper maintenance and storage will extend the life of your MIPRO MB-70 battery:
- 일반 충전: If the battery is not used for extended periods, recharge it every 3-6 months to prevent deep discharge, which can permanently damage lead-acid batteries.
- 깨끗한 터미널: 배터리 단자를 깨끗하게 유지하고 부식이 생기지 않도록 하십시오. 필요한 경우 마른 천으로 닦아주십시오.
- 보관 조건: Store the battery in a cool, dry place, away from direct sunlight and extreme temperatures. The ideal storage temperature is between 20°C and 25°C (68°F and 77°F).
- 심부방전을 피하세요: Do not allow the battery to completely discharge. Recharge it as soon as possible after use.
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 배터리가 충전되지 않음 | Charger not connected properly; Faulty charger; Deeply discharged battery; Damaged battery. | Check charger connections; Try a different charger; Allow extended charging time for deeply discharged batteries (if applicable); Replace battery if damaged. |
| 충전 후 작동 시간이 짧음 | Battery capacity degradation; Incomplete charge; High power consumption by device. | Ensure full charge cycle; Consider battery replacement if capacity is significantly reduced; Check device for abnormal power draw. |
| 배터리 단자가 부식되었습니다 | 습기에 노출되거나 부적절하게 보관한 경우. | Clean terminals with a dry cloth or a soft brush. Ensure proper storage conditions. |
여기에 나열되지 않은 문제가 발생하거나 해결 방법으로 문제가 해결되지 않을 경우 고객 지원팀에 문의하세요.
명세서
| 상표 | 미프로 |
| 모델 번호 | D5741 (MB-70) |
| 권tage | 12 볼트 |
| 배터리 셀 구성 | 납산 |
| 배터리 용량 | 4.5 Amp 시간 |
| 품목 무게 | 3파운드(약 1.36kg) |
| 한국어: | 806593457418 |
| 첫 번째 가능한 날짜 | 14년 2012월 XNUMX일 |
보증 및 지원
For warranty information and technical support, please refer to the documentation provided with your original MIPRO product or visit the official MIPRO web사이트. 보증 청구를 위해 구매 증빙 자료로 구매 영수증을 보관하세요.
추가적인 도움이 필요하시면 구매가 이루어진 플랫폼을 통해 판매자에게 직접 문의하실 수 있습니다.
제품 비디오
현재로서는 임베드 가능한 공식 제품 영상이 없습니다.