Pronomic M-602

Pronomic M-602 Live/Studio Mixer Instruction Manual

모델: M-602

1. 서론

The Pronomic M-602 is a professional 6-channel mixer designed for versatile audio applications in both live performance and studio environments. It features robust construction, low-noise circuitry for clear audio, and a musical 3-band equalizer on each channel. This manual provides essential information for the safe and effective operation of your M-602 mixer.

2. 안전 지침

Please read and understand these safety instructions before operating the device. Keep this manual for future reference.

  • 전원: Only use the provided external power supply. Ensure the voltage는 장치에 명시된 요구 사항과 일치합니다.
  • 물과 습기: 제품을 비, 습기 또는 액체에 노출시키지 마십시오. 액체가 담긴 물건을 제품 위에 올려놓지 마십시오.
  • 통풍: 충분한 환기를 유지하세요. 환기구를 막지 마세요.
  • 열: 라디에이터, 난방 조절기, 스토브 또는 기타 장치(다음 포함)와 같은 열원 근처에 장치를 두지 마십시오. amp열을 생성하는 발전기.
  • 청소: 마른 천으로만 닦으십시오.
  • 서비스: 이 장치를 직접 수리하려고 하지 마십시오. 모든 수리는 자격을 갖춘 서비스 담당자에게 맡기십시오.
  • 케이블 : 전원 코드가 밟히거나 끼지 않도록 보호하세요. 특히 플러그, 편의용 콘센트 및 기기에서 나오는 부분은 보호하세요.

3. 패키지 내용

패키지에 모든 품목이 들어 있는지 확인하세요.

  • Pronomic M-602 Mixer Unit
  • 외부 전원 공급 장치
  • 사용 설명서(본 문서)

4. 제품 오버view

The Pronomic M-602 mixer features a compact design with intuitive controls. Below is an illustration of the mixer's layout and a description of its main components.

위에서 아래로 view of the Pronomic M-602 mixer, showing all controls and input/output jacks.
그림 1: 상향식 view of the Pronomic M-602 mixer, illustrating the layout of all controls and input/output jacks. This image displays the two mono channels with XLR/jack inputs, two stereo channels with jack inputs, the main section with CD/Tape I/O, and various output options.

4.1 Input/Output Panel (Top Rear)

  • 마이크 입력(XLR): Balanced inputs for microphones.
  • LINE Inputs (1/4" Jack): Balanced/unbalanced inputs for line-level instruments or devices.
  • STEREO AUX RETURN (1/4" Jack): Inputs for external effects processors.
  • MAIN OUT (1/4" Jack): Main stereo output to amplifier 또는 녹음 장치.
  • CTRL ROOM OUT (1/4" Jack): Output for control room monitors.
  • FX SEND (1/4" Jack): Output to send signal to external effects processors.
  • PHONES (1/4" Jack): 헤드폰 출력.

4.2 채널 제어

Each channel (2 mono, 2 stereo) features the following controls:

  • TRIM (Mono Channels): Adjusts the input gain for microphones and line inputs (max. +60 dB).
  • EQ(고, 중, 저): 3-band equalizer for tone shaping (High: 12 kHz, Mid: 2.5 kHz, Low: 80 Hz).
  • FX : Controls the amount of signal sent to the FX Send output (post-fader).
  • PAN(모노 채널) / BAL(스테레오 채널): 채널의 스테레오 위치를 조정합니다.
  • 클립 LED: 입력 신호가 너무 높을 때, 즉 클리핑이 발생할 가능성이 있을 때 점등됩니다.
  • 수준: 채널의 전체 출력 레벨을 메인 믹스에 맞춰 조정합니다.

4.3 주요 섹션 제어

  • CD/TAPE IN/OUT (RCA): Stereo RCA inputs/outputs for connecting CD players, tape decks, or other stereo devices. Assignable to Mix and Phones/CTRL.
  • PHANTOM +48V Switch: Activates +48V phantom power for condenser microphones. An LED indicates activation.
  • PHONES/CTRL Knob: Adjusts the level for the headphone and control room outputs.
  • 메인 믹스 노브: 메인 스테레오 믹스의 전체 출력 레벨을 조정합니다.
  • AUX RETURN Knob: Adjusts the level of the signal returning from external effects processors.
  • LEVEL METER (LED): 4-segment LED display showing the main mix output level.
  • 전원 LED : 기기의 전원이 켜져 있음을 나타냅니다.
각진 view of the Pronomic M-602 mixer, highlighting the control knobs and their color-coded design.
그림 2: 각도 view of the Pronomic M-602 mixer, providing a clearer perspective of the control knobs and their ergonomic, color-coded design for intuitive operation.

5. 설정

초기 설정을 위해 다음 단계를 따르세요.

  1. 전원 연결: Connect the external power supply to the mixer's power input and then to a suitable power outlet. Ensure the mixer is switched off before connecting.
  2. 출력 연결: Connect the MAIN OUT jacks to your amplifier, powered speakers, or recording interface. For monitoring, connect your headphones to the PHONES jack or control room monitors to the CTRL ROOM OUT jacks.
  3. 입력 연결:
    • For microphones, connect via the XLR inputs. If using condenser microphones, ensure the +48V PHANTOM power is activated (see Operating section).
    • For line-level instruments (keyboards, guitars with preamps) or other audio devices, connect via the 1/4" LINE inputs.
    • For stereo playback devices (CD player, smartphone), use the CD/TAPE IN RCA jacks.
  4. 초기 설정: Before powering on, set all LEVEL, TRIM, EQ, FX, PAN/BAL, MAIN MIX, PHONES/CTRL, and AUX RETURN knobs to their minimum (fully counter-clockwise) positions.
The external power supply unit for the Pronomic M-602 mixer, showing the power brick and connected cables.
Figure 3: The external power supply unit for the Pronomic M-602 mixer, featuring the power brick and its attached cables, essential for powering the device.

6. 운영

6.1 전원 켜기/끄기

After all connections are made and initial settings are at minimum, power on your amplifier/speakers first, then the M-602 mixer. To power off, reverse the order: mixer first, then amp스피커

6.2 입력 레벨 조정

  1. TRIM (Mono Channels): For mono channels, gradually increase the TRIM knob until the CLIP LED flashes only occasionally during the loudest parts of the input signal. Then, slightly reduce TRIM until the LED no longer flashes.
  2. 채널 레벨: Slowly raise the LEVEL knob for the active channel to send its signal to the main mix.
  3. 메인 믹스: Gradually increase the MAIN MIX knob to set the overall output volume. Monitor the LED level meter to avoid clipping (red LEDs).

6.3 Using the Equalizer (EQ)

Each channel has a 3-band EQ (High, Mid, Low). The center position is flat (no boost or cut). Turn clockwise to boost frequencies, counter-clockwise to cut them. Experiment to achieve the desired tone for each input.

6.4 팬텀 전원(+48V)

If using condenser microphones, press the +48V PHANTOM switch. The corresponding LED will illuminate. Ensure dynamic microphones are not connected when phantom power is active, as this can cause damage to some dynamic microphones.

6.5 FX Send/Return

To use an external effects processor:

  1. Connect the FX SEND jack to the input of your effects processor.
  2. Connect the output of your effects processor to the STEREO AUX RETURN jacks.
  3. Use the FX knob on each channel to send signal to the processor.
  4. Use the AUX RETURN knob in the main section to control the overall level of the returned effect signal in the mix.

6.6 모니터링

Adjust the PHONES/CTRL knob to set the listening volume for your headphones or control room monitors.

7. 유지관리

적절한 유지관리는 믹서기의 수명과 최적의 성능을 보장합니다.

  • 청소: Disconnect the power supply before cleaning. Use a soft, dry cloth to wipe the surface of the mixer. Do not use liquid cleaners, solvents, or abrasive materials.
  • 저장: When not in use for extended periods, store the mixer in a dry, dust-free environment.
  • 케이블 관리: Avoid bending or kinking cables excessively. Store cables neatly to prevent damage.

8. 문제 해결

문제가 발생하면 고객 지원팀에 문의하기 전에 이 섹션을 참조하십시오.

문제가능한 원인해결책
사운드 출력이 없습니다
  • 전원이 연결되지 않았거나 꺼져 있습니다.
  • MAIN MIX knob is at minimum.
  • Channel LEVEL knob is at minimum.
  • Output cables are faulty or incorrectly connected.
  • Amp앰프/스피커가 꺼져 있거나 음소거되어 있습니다.
  • 전원 연결과 스위치를 확인하세요.
  • Increase MAIN MIX knob.
  • Increase relevant channel LEVEL knob.
  • Verify all output cable connections and test cables.
  • 보장하다 amp앰프/스피커가 켜져 있고 음소거가 해제되어 있습니다.
왜곡된 소리
  • 입력 신호가 너무 높습니다(클리핑).
  • MAIN MIX or channel LEVEL too high.
  • 연결됨 amplifier/speakers are clipping.
  • Reduce TRIM for mono channels until CLIP LED no longer flashes.
  • Reduce channel LEVEL and/or MAIN MIX.
  • Check input levels on connected amp스피커
험 또는 소음
  • 접지 루프 문제.
  • 케이블에 결함이 있습니다.
  • 다른 전자 장치의 간섭.
  • 모든 오디오 장비를 동일한 전원 콘센트에 연결해 보세요.
  • 다양한 케이블로 테스트해 보세요.
  • Move the mixer away from power supplies, computers, or other noise-emitting devices.
팬텀 파워가 작동하지 않습니다
  • +48V PHANTOM switch not engaged.
  • 마이크 또는 케이블에 문제가 있습니다.
  • Ensure the +48V PHANTOM switch is pressed and its LED is lit.
  • Test with a different condenser microphone and XLR cable.

9. 사양

특징세부 사항
모델엠-602
채널6 (2 Mono XLR/Jack, 2 Stereo Jack)
EQ3-band (Low 80 Hz, Mid 2.5 kHz, High 12 kHz) per channel
팬텀 파워+48V, 전환 가능
Input Gain (Mono)Trim control (max. +60 dB)
연결성XLR, 1/4" Jack, RCA (CD/Tape In/Out)
출력Main Out (1/4" Jack), Ctrl Room Out (1/4" Jack), FX Send (1/4" Jack), Phones (1/4" Jack)
치수(길이 x 너비 x 높이)24 x 19 x 24cm (약 9.4 x 7.5 x 9.4인치)
무게1.3kg(약 2.87파운드)
전원 공급 장치외부 AC 어댑터

10. 보증 및 지원

For warranty information, please refer to the documentation provided at the time of purchase or contact your retailer. For technical support or service inquiries, please contact Pronomic customer service through their official web사이트 또는 지역 대리점.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.