Roline 19401205

Roline DesignSecure 525 UPS Instruction Manual

모델: 19401205

1. 서론

This manual provides essential information for the safe and efficient operation of your Roline DesignSecure 525 Uninterruptible Power Supply (UPS). Please read this manual thoroughly before installation and use to ensure proper functionality and to prevent damage to the unit or connected equipment.

The Roline DesignSecure 525 UPS is designed to provide reliable emergency power for workstations and communication technology, protecting against power fluctuations, blackouts, and surges.

2. 안전 정보

경고: 이러한 안전 지침을 따르지 않을 경우 감전, 화재 또는 심각한 부상이 발생할 수 있습니다.

  • UPS c를 열지 마십시오.asing. 내부에는 사용자가 직접 수리할 수 있는 부품이 없습니다. 모든 수리는 자격을 갖춘 서비스 담당자에게 맡기십시오.
  • 레이저 프린터나 진공청소기처럼 무정전 전원 공급 장치(UPS)에 과부하를 줄 수 있는 기기는 연결하지 마십시오.
  • 무정전 전원 공급 장치(UPS)가 접지된 전원 콘센트에 연결되어 있는지 확인하십시오.
  • Do not expose the UPS to water or excessive humidity.
  • Position the UPS in a well-ventilated area, away from direct sunlight and heat sources.
  • 청소하기 전에 UPS의 전원 플러그를 콘센트에서 뽑으세요. 마른 천으로 닦으십시오.

3. 제품 오버view

The Roline DesignSecure 525 UPS provides uninterruptible power and protection for your electronic devices. Key features include:

  • 안정적인 전원 공급 장치: Provides emergency power and protection against spikes, voltage variations, blackouts, interference, and overvoltage.
  • 배터리 수명 연장: Features a battery management system for efficient charging and a digital display for battery status.
  • 전력 용량: Supports 2000 VA / 1200 W, offering a full power runtime of 2 minutes and 4 minutes at mid-power.
  • Built-in AVR: 자동 볼륨tage Regulation protects against surges and undervoltages, regulating voltage variations via Buck and Boost technology.
  • 모니터링 소프트웨어: Includes built-in software for communication between the inverter microprocessor and a PC, compatible with common operating systems.

3.1. 구성 요소

Below is an image of the Roline DesignSecure 525 UPS, highlighting its general appearance.

Roline DesignSecure 525 UPS front view with power outlets and display

그림 1: 전면 view of the Roline DesignSecure 525 UPS. This image shows the main unit, including the display panel and power outlets.

The UPS typically includes:

  • 전원 입력 포트
  • Output Power Outlets (Type B - 3 pin North American)
  • Control Panel / LCD Display
  • USB 통신 포트
  • Telephone/Modem Protection Ports (RJ11)

4. 설정

4.1. 풀기

Carefully unpack the UPS and inspect it for any shipping damage. Retain the packaging for future transport or storage.

4.2. 배치

Place the UPS on a flat, stable surface in a clean, dry, and well-ventilated area. Ensure there is adequate space around the unit for proper airflow. Avoid placing it near heat sources or in direct sunlight.

4.3. 전원에 연결

  1. UPS가 꺼져 있는지 확인하십시오.
  2. Connect the UPS power input cable to a grounded Type B (3-pin North American) wall outlet.
  3. 최적의 배터리 성능을 보장하기 위해 처음 사용하기 전에 UPS를 최소 8시간 동안 충전하십시오.

4.4. 장비 연결

  1. Connect your computer, monitor, and other critical devices to the UPS output receptacles.
  2. For telephone/modem line protection, connect your incoming telephone/modem line to the "IN" port on the UPS, and then connect a cable from the "OUT" port to your telephone/modem device.
  3. Do not connect surge strips or extension cords to the UPS output.

4.5. 소프트웨어 설치(선택 사항)

For advanced monitoring and management, install the provided smart monitoring software on your computer. Connect the UPS to your computer using a USB cable. Refer to the software's specific instructions for installation and configuration.

5. 사용 설명서

5.1. Turning On the UPS

Press and hold the power button on the front panel for approximately 2-3 seconds until you hear a beep and the display illuminates. The UPS will perform a self-test and then enter online mode.

5.2. Turning Off the UPS

To turn off the UPS, press and hold the power button for approximately 2-3 seconds until you hear a beep and the display turns off. Ensure all connected devices are properly shut down before turning off the UPS.

5.3. 디스플레이 표시기

The digital display provides real-time information about the UPS status, including:

  • 입력 Voltage
  • 출력 볼륨tage
  • 배터리 충전 수준
  • 부하 수준
  • Operating Mode (Online, Battery, Bypass)
  • 오류 코드(있는 경우)

Refer to the software manual for detailed explanations of all display indicators and error codes.

5.4. 자동 볼륨tage 규정(AVR)

The built-in AVR automatically corrects minor voltage fluctuations without switching to battery power, preserving battery life. If the input voltage goes too high or too low, the AVR will adjust it to a safe level for your connected devices.

5.5. 배터리 모드

정전이 발생한 경우tage, the UPS will automatically switch to battery power. An audible alarm will sound, and the display will indicate battery mode. The duration of battery backup depends on the load connected. The UPS will automatically shut down when the battery is depleted to prevent deep discharge.

6. 유지관리

6.1. 배터리 관리

  • To maintain optimal battery life, ensure the UPS is connected to a power source and charging when not in use.
  • 잦은 사정을 피하십시오.
  • If storing the UPS for an extended period, fully charge it every three months to prevent battery degradation.
  • Battery replacement should only be performed by qualified personnel.

6.2. 청소

Ensure the UPS is turned off and disconnected from the power outlet before cleaning. Use a soft, dry cloth to wipe the exterior. Do not use liquid or aerosol cleaners.

6.3. 환경 조건

Maintain the UPS in an environment with stable temperature and humidity. Extreme conditions can shorten battery life and affect performance.

7. 문제 해결

This section provides solutions to common issues you might encounter with your Roline DesignSecure 525 UPS.

문제가능한 원인해결책
UPS가 켜지지 않습니다.No input power; Low battery; Power button not pressed long enough.Check power cord connection; Allow UPS to charge for several hours; Press and hold power button for 2-3 seconds.
UPS beeps continuously in online mode.Overload condition; Internal fault.Reduce connected load; Disconnect non-essential devices; If problem persists, contact support.
배터리 백업 시간이 짧습니다.Overload; Battery nearing end of life; Battery not fully charged.Reduce connected load; Allow UPS to charge fully; Consider battery replacement if old.
Connected devices not receiving power.UPS is off; UPS is in fault mode; Output receptacles are not active.Turn on UPS; Check display for error codes; Ensure devices are connected to battery-backed outlets.

If the problem persists after attempting these solutions, please contact Roline customer support.

8. 사양

특징세부 사항
모델 번호19401205
제품 치수4.13 x 6.61 x 13.15 인치
품목 무게12.79파운드
출력 볼륨tage120볼트(AC)
전원 플러그 유형B형 - 3핀(북미)
색상블랙 / 실버
제조업체롤린
첫 번째 이용 가능 날짜20년 2012월 XNUMX일

9. 보증 및 지원

9.1. 보증 정보

Roline products are manufactured to high quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Roline web사이트. 보증 청구를 위해 구매 증빙 자료를 보관하세요.

9.2. 고객 지원

If you require technical assistance or have questions not covered in this manual, please contact Roline customer support. Contact information can typically be found on the Roline web사이트 또는 제품 포장에 표시되어 있습니다.

고객 지원팀에 문의하실 때는 모델 번호(19401205)와 구매일자를 준비해 주시기 바랍니다.

© 2024 Roline. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.