힐랜드 HLDS032-B 휴대용 탁상형 파티오 히터 사용 설명서

1. 서론

This manual provides essential information for the safe assembly, operation, maintenance, and troubleshooting of your Hiland HLDS032-B Portable Table Top Patio Heater. Please read all instructions carefully before use and retain this manual for future reference.

The Hiland HLDS032-B is a compact, portable propane-fueled heater designed for outdoor use, providing 11,000 BTUs of heat. It is suitable for placement on tabletops and can operate with either a 1lb propane tank or a 20lb propane tank (with an adapter hose, not included).

2. 안전 정보

WARNING: For Outdoor Use Only. Do not operate this heater indoors or in enclosed spaces.

• 히터를 작동할 때는 항상 적절한 환기를 확보하십시오.
• Keep clear of combustible materials. Maintain a minimum clearance of 24 inches (61 cm) from sides and rear, and 36 inches (91 cm) from the top.
• This heater is equipped with a thermocouple and anti-tilt safety devices, which will automatically shut off the gas supply if the pilot flame extinguishes or the unit tips over.
• 이 기기나 다른 기기 근처에서 가솔린이나 기타 가연성 증기 및 액체를 보관하거나 사용하지 마십시오.
• Propane gas is heavier than air and will settle in low areas. Ensure the area around the heater is clear of any potential ignition sources.
• Always inspect the gas hose and connections for leaks before each use. Use a soapy water solution to check for bubbles.
• Do not attempt to repair or alter the heater. Contact qualified service personnel for repairs.
• 히터가 작동하는 동안에는 어린이와 애완동물이 히터에 접근하지 못하도록 하세요.
• 이 제품에는 캘리포니아주에서 암과 선천적 기형 또는 기타 생식 기능 장애를 유발하는 것으로 알려진 화학 물질이 포함되어 있습니다(제안 65호 경고).

3. 패키지 내용

Verify that all components are present and undamaged before assembly. If any parts are missing or damaged, do not proceed with assembly; contact customer service.

• Heater Head Assembly (Burner, Reflector, Screen Guard)
• 본체/하우징
• 베이스 플레이트
• Heavy Weight Plate for Stability
• 조절기
• Hardware Pack (screws, wrench)
• 사용 설명서

4. 조립 및 설정

Follow these steps for proper assembly and initial setup of your patio heater.

4.1 Attaching the Base and Weight Plate

1. 모든 구성품을 조심스럽게 꺼내세요.
2. Attach the heavy weight plate to the underside of the base plate using the provided hardware. This plate significantly enhances stability.
3. Secure the main body/housing to the base plate.

4.2 Installing the Propane Tank

The heater is designed to use a 1lb propane tank directly or a 20lb propane tank with an optional adapter hose (not included).

1. 조절 노브가 "OFF" 위치에 있는지 확인하십시오.
2. Open the access door on the main body of the heater. This door provides easy access to the propane connection point.
3. Connect the regulator to the propane tank. For a 1lb tank, screw it directly into the regulator. For a 20lb tank, connect the adapter hose to the tank and then to the regulator.
4. Carefully place the propane tank inside the heater's housing. The regulator may tilt for easier installation.
5. 접근문을 단단히 닫으세요.

4.3 누출 테스트

Before first use and after every tank change, perform a leak test:

1. Mix a solution of soapy water (50% soap, 50% water).
2. Ensure the heater's control knob is OFF.
3. 프로판 탱크 밸브를 엽니다.
4. Apply the soapy solution to all gas connections. If bubbles appear, there is a leak. Tighten connections or replace parts as necessary. Do not operate the heater if a leak is detected.

5. 사용 설명서

This section details how to safely ignite and operate your Hiland patio heater.

5.1 점화 절차

It is recommended to perform the initial ignition in low light conditions to clearly see the pilot flame.

1. 프로판 탱크 밸브가 완전히 열려 있는지 확인하세요.
2. Push in the control knob and rotate it counter-clockwise to the "PILOT" position.
3. While holding the knob in, press the red igniter button repeatedly until the pilot flame ignites. You may need to press it multiple times (up to 15-20 times) until you hear a click and see the pilot light.
4. Once the pilot is lit, continue to hold the control knob in for at least 15-20 seconds. This allows the thermocouple to heat up and engage the safety valve. Releasing too soon will cause the pilot to extinguish.
5. After holding, slowly release the control knob. The pilot flame should remain lit. If it extinguishes, repeat steps 2-4.
6. To ignite the main burner, push in the control knob and rotate it further counter-clockwise to the "LOW" or "HIGH" position. The main burner should ignite.

5.2 열 출력 조절

Rotate the control knob between "LOW" and "HIGH" to adjust the heat intensity as desired. The heater provides up to 11,000 BTUs of heat.

5.3 히터 끄기

1. Rotate the control knob clockwise to the "OFF" position.
2. 프로판 탱크의 밸브를 닫으세요.
3. 히터를 옮기거나 보관하기 전에 완전히 식히십시오.

6. 유지관리

Regular maintenance ensures safe and efficient operation of your heater.

• 청소: 부드러운 천으로 외부 표면을 닦으십시오.amp cloth. Do not use abrasive cleaners or solvents. Ensure the burner screen is free of debris.
• 저장: When not in use for extended periods, disconnect the propane tank and store the heater in a dry, protected area.
• 검사: Periodically check all gas connections and the hose for signs of wear, damage, or leaks.

7. 문제 해결

일반적인 문제와 해결 방법은 이 섹션을 참조하세요.

8. 사양

9. 보증 및 지원

Hiland products include a one-year warranty against manufacturer defects. AZ Patio Heaters LLC maintains a complete line of replacement parts and a full-service repair center.

For warranty claims, replacement parts, or technical support, please contact Hiland customer service. Refer to your purchase documentation for contact details.