LANDMANN 12016ST
Landmann 12016ST 가스 파티오 히터 사용 설명서
Model: 12016ST | Brand: LANDMANN
소개
This manual provides essential instructions for the safe assembly, operation, and maintenance of your Landmann 12016ST Gas Patio Heater. Please read this manual thoroughly before attempting to assemble or operate the heater. Keep it for future reference.
중요한 안전 정보
경고: 이 지침을 따르지 않을 경우 화재, 폭발 또는 일산화탄소 중독이 발생하여 재산 피해, 부상 또는 사망에 이를 수 있습니다.
- Always operate the heater outdoors in a well-ventilated area. Never use it indoors or in enclosed spaces.
- 인화성 물질은 히터에서 안전한 거리를 유지하십시오.
- Ensure the anti-tilt safety device is functioning correctly. This device is designed to shut off the gas supply if the heater tips over.
- 이 기기나 다른 기기 근처에서 가솔린이나 기타 가연성 증기 및 액체를 보관하거나 사용하지 마십시오.
- 매 사용 전에 모든 가스 연결부의 누출 여부를 점검하십시오.
- 히터에서 어린이와 애완동물을 멀리하세요.
- Do not move the heater while it is in operation or still hot.
설정 및 조립
The Landmann 12016ST Gas Patio Heater requires some assembly. Follow these general steps. Refer to the included assembly diagram for detailed instructions.
- 구성 요소 풀기: 모든 부품을 포장에서 조심스럽게 꺼내세요. 부품 목록에 나열된 모든 구성품이 들어 있고 손상되지 않았는지 확인하세요.
- 베이스 조립: Attach the wheels (if applicable) and any stabilizing feet to the base unit.
- Install Gas Cylinder Housing: Secure the gas cylinder housing to the base.
- 메인 폴 부착: Connect the main support pole to the gas cylinder housing.
- Mount Burner Unit: Carefully attach the burner assembly to the top of the main pole.
- Reflector를 설치하세요: Secure the aluminum heat reflector to the top of the burner unit.
- Connect Gas Hose and Regulator: Connect the provided BS hose and regulator to the heater's gas inlet and then to your gas cylinder. Ensure all connections are tight.
- 누출 테스트: Before first use, perform a leak test on all gas connections using a soapy water solution. Bubbles indicate a leak. Do not use the heater if a leak is detected.
그림 1: The Landmann Gas Patio Heater in its assembled state. This image displays the heater's tall, slender design with a silver finish. The base houses the gas cylinder, a central pole supports the burner unit, and a large circular reflector sits at the top.
작동 지침
- 기체 실린더: Ensure a properly connected and full gas cylinder is installed in the base. Open the valve on the gas cylinder.
- 점화: Turn the control knob to the "Pilot" position and push it in. Press the igniter button repeatedly until the pilot flame lights. Keep the knob pressed for 10-15 seconds to allow the thermocouple to heat up.
- 메인 버너 : Once the pilot is lit, release the control knob and turn it to the desired heat setting (Low to High). The main burner should ignite.
- 열 조절: Use the adjustable heat control knob to regulate the heat output as needed.
- 종료: To turn off the heater, turn the control knob to the "OFF" position. Close the valve on the gas cylinder.
메모: If the heater fails to ignite, ensure the gas supply is open and repeat the ignition steps. If issues persist, refer to the Troubleshooting section.
유지 보수 및 관리
- 청소: 부드러운 천으로 외부 표면을 청소하세요.amp 천을 사용하십시오. 연마성 세제나 용제를 사용하지 마십시오. 청소하기 전에 히터가 식었는지 확인하십시오.
- 반사기: Periodically wipe the aluminum reflector to maintain its efficiency.
- 가스 호스 및 레귤레이터: Inspect the gas hose and regulator regularly for signs of wear, cracks, or damage. Replace if necessary.
- 저장: When not in use for extended periods, disconnect the gas cylinder and store the heater in a dry, protected area. Using a protective cover is recommended.
그림 2: The Landmann Gas Patio Heater covered with a dark grey protective cover. This demonstrates proper storage and protection for the appliance when not in use.
문제 해결
| 문제 | 가능한 원인 | 해결책 |
|---|---|---|
| 히터가 점화되지 않습니다. | No gas supply, clogged pilot, faulty igniter, air in gas line. | Check gas cylinder valve is open. Ensure cylinder is not empty. Bleed air from gas line by attempting ignition several times. Clean pilot opening. Check igniter spark. |
| 점화등이 꺼진 후asing 노브. | Thermocouple not heated sufficiently, faulty thermocouple. | Hold control knob in for a longer period (15-20 seconds) after pilot lights. If problem persists, thermocouple may need replacement by a qualified technician. |
| 낮은 열 출력. | Low gas pressure, partially clogged burner, dirty reflector. | Check gas cylinder level. Ensure regulator is functioning correctly. Clean burner ports. Clean the aluminum reflector. |
| 가스 냄새가 감지되었습니다. | 가스 누출. | Immediately turn off gas supply at the cylinder. Perform a leak test with soapy water. Do not operate if a leak is found. Contact a qualified technician. |
| Assembly issues (e.g., threads jamming). | Misaligned parts, manufacturing defect. | Ensure parts are correctly aligned before tightening. Do not overtighten. If threads are damaged, contact customer support for replacement parts. |
명세서
- 모델: 12016ST
- 상표: 랜드만
- Dimensions (Assembled H x D): 219.51cm x 75.01cm (약 86.4인치 x 29.5인치)
- 무게: 2kg(약 4.4파운드) *Note: This weight seems unusually low for a patio heater. Please verify with product packaging.*
- 재료: Steel sheet with powder coating, Aluminum heat reflector
- 연료 유형: 가스
- 안전 기능: Anti-tilt safety device
- 포함 사항: BS hose and regulator
보증 및 고객 지원
Specific warranty information and details regarding customer support contacts are not provided within this manual. Please refer to the product packaging, the retailer's website, or the official Landmann website for warranty terms and contact information for technical assistance or replacement parts.
For general inquiries or to report issues, please contact Landmann customer service through their official channels.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.